MRMarcelo Leite Ribeiro

Marcelo Leite Ribeiro

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marcelo Leite Ribeiro has a total of 11 co-authors. Here are the top co-authors by number of shared publications:

  • Koen Blanckaert

    Institute of Hydraulic Engineering and Water Resources Management Research Unit Hydraulic Engineering and Environmental Hydromechanics Technische Universität Wien (TU Wien) Vienna Austria

    4 shared publications
  • A. J. Schleiss

    Laboratory of Hydraulic Constructions (LCH) Ecole Polytechnique Fédérale de Lausanne (EPFL) Station 18 Lausanne Switzerland

    3 shared publications
  • A. G. Roy

    2 shared publications
  • Anton J. Schleiss

    Platform of Hydraulic Constructions (PL-LCH), École Polytechnique Fédérale de Lausanne (EPFL), CH-1015 Lausanne, Switzerland

    2 shared publications
  • A.J. Schleiss

    Laboratory of Hydraulic Constructions (LCH), Ecole Polytechnique Fédérale de Lausanne (EPFL), Station 18, Switzerland

    1 shared publication
  • G. Singhal

    Engineer, Stucky SA, Renens, Switzerland; formerly Research Assistant, Laboratory of Hydraulic Constructions, Ecole Polytechnique Fédérale de Lausanne, Switzerland

    1 shared publication

Latest Publications

  • Local tributary widening for river rehabilitation

    by M. Leite Ribeiro, K. Blanckaert, A. J. Schleiss

    The hydro‐morpho‐sedimentary processes in confluence hydrodynamic zones (CHZ) subject to a local widening of the tributary were investigated in a series of laboratory experiments that were representative of the 20 major confluences of the Upper Rhone River in Switzerland. Three discharge ratios (low, intermediate and high ratios of tributary to main channel discharge) were investigated for each of four tributary configurations (reference configuration with constant tributary width and three geometries of the local tributary widening). In all experiments, the local tributary widening caused substantial morphodynamic changes in the CHZ and moderate sediment redistribution in the post‐confluence channel. At the entrance of the local widening, the tributary main flow corridor gradually widened. Towards the confluence mouth, it narrowed and deflected in downstream direction because of a zone of flow stagnation at the confluence upstream junction corner. Dry zones and flow stagnation zones occurred in the widening zone outside the tributary main flow corridor. The results indicate that a local tributary widening considerably enhances the variability of bed substrate, velocity and depth in the CHZ, and offers an appropriate habitat for a wider range of biota than the homogeneous channelized reference configuration. None of the investigated experiments resulted in adverse impacts on water surface elevation and thereby flood safety. On the basis of the laboratory experiments, the appropriate geometry of the local tributary widening is discussed, and quantitative guidelines for practical application are proposed. Copyright © 2014 John Wiley & Sons, Ltd.


  • Hydromorphological implications of local tributary widening for river rehabilitation

    by M. Leite Ribeiro, K. Blanckaert, A. G. Roy, A. J. Schleiss

    The hydromorphological implications of the local widening of a tributary where it enters a confluence were investigated in a laboratory setting that is representative of the 20 major confluences on the channelized Upper Rhone River. Although local tributary widening reduces the confluence angle, it amplifies the hydromorphosedimentary processes in the confluence hydrodynamic zone (CHZ), because local widening reduces the effective flow area, causing increased tributary velocities and momentum flux. The reduction in effective flow area is caused by an increase in bed elevation and by lateral constriction of the flow induced by flow stagnation at the upstream corner of the confluence. The increased tributary velocities amplify the two‐layer flow structure in the CHZ. Flow originating from the tributary is confined to the upper part of the water column and is more markedly directed outward than flow in the lower part of the water column originating from the main channel. A shear layer characterized by increased turbulence activity develops at the interface between the two flow layers. The increased tributary velocities enhance bed discordance, the penetration of the tributary into the CHZ and the channel bed gradients in the postconfluence channel. The results indicate that local tributary widening can enhance heterogeneity in sediment substrate, flow velocities and flow depths. Widening may therefore enhance local habitat and improve the connectivity of the tributary to the main river network. This may, in turn, provide favorable conditions for the improvement and reestablishment of ecological river functions, without having adverse impact on flood safety.


  • Hydraulic design of A-type Piano Key Weirs

    by Marcelo Leite Ribeiro, Michael Pfister, Anton J. Schleiss, Jean-Louis Boillat

    Piano Key Weirs (PKWs) are an alternative to linear overflow structures, increasing the unit discharge for similar heads and spillway widths. Thus, they allow to operate reservoirs with elevated supply levels, thereby providing additional storage volume. As they are relatively novel structures, few design criteria are available. Hence, physical model tests of prototypes are required. This study describes comprehensive model tests on a sectional set-up of several A-type PKWs, in which the relevant parameters were systematically varied. Considering data of former studies, a general design equation relating to the head–discharge ratio is derived and discussed. The latter is mainly a function of the approach flow head, the developed crest length, the inlet key height, and the transverse width. To extend its application range, case study model tests were analysed to provide a design approach if reservoir approach flow instead of channel flow is considered.


  • Flow and sediment dynamics in channel confluences

    by M. Leite Ribeiro, K. Blanckaert, A. G. Roy, A. J. Schleiss

    Confluences with relatively low discharge and momentum flux ratios where a small steep tributary with a high supply of poorly sorted sediment joins a large, low‐gradient main channel commonly occur in nature, but they have not yet been investigated. Measurements of the three‐dimensional velocity field, turbulence, sediment transport, bed material grain size and morphology are reported in a laboratory setting that is representative of confluences on the Upper Rhone River, Switzerland. The difference between the low‐flow depth in the steep tributary and the higher flow depth in the main channel creates a marked bed discordance in the tributary zone. Due to this bed discordance, the tributary flow penetrates into the main channel mainly in the upper part of the water column, whereas the main‐channel flow is hardly hindered by the tributary in the lower part of the water column, giving rise to a two‐layer flow structure in the confluence zone. In confluences with high supply of coarse sediment from the tributary, the development of a deposition bar downstream from the confluence reduces the flow area and causes flow acceleration that contributes to an increase in sediment transport capacity. The sediment supplied by the tributary is mainly sorted and transported on the face of the bar by the near‐bed flow originating from the main channel. The sediment transport capacity is further increased by the three‐dimensionality of the flow, which is characterized by maximum velocities occurring near the bed, and by a considerable increase in turbulent kinetic energy generated in the shear layer at the interface of the flows originating from the main channel and the tributary. A conceptual model is proposed for the hydro‐morpho‐sedimentary processes, and compared to existing conceptual models for confluences with different characteristics.


  • Discharge Capacity of Piano Key Weirs

    by M. Leite Ribeiro, M. Bieri, J.-L. Boillat, A. J. Schleiss, G. Singhal, N. Sharma

    In recent years, spillway rehabilitation has increased in importance and become the subject of many projects worldwide. One solution for this problem is the implementation of a new type of labyrinth spillway, called Piano Key Weir (PK-Weir ). This is an excellent alternative for increasing the overflow capacity of existing dams. Similarly to traditional labyrinth weirs, the hydraulic capacity of a PK-Weir is a function of its geometrical characteristics. Currently, there is a lack of systematic experiments, and the existing data does not allow the proposition of a universal design procedure. This paper reviews the previous studies on the efficiency of planned and built PK-Weirs. The results are evaluated by comparing an actual PK-Weir’s discharge to that theoretically obtained for a sharp-crested spillway with crest length equal to the width of the PK-Weir for a given hydraulic head. On the basis of this evaluation, a preliminary design procedure is proposed.