Phillip S. Tong

The objective of this study was to determine the effect of mineral chelator addition during skim milk powder (SMP) manufacture on the solubility, turbidity, soluble protein, and heat stability (HS). Three chelators (sodium citrate dihydrate, sodium polyphosphate, and disodium EDTA) at 3 different concentrations (5, 15, and 25mM) were added to skim milk concentrate (30% total solids), and the pH was adjusted to 6.65 before spray drying to produce SMP. Spray-dried SMP samples were tested for solubility index (SI). Additionally, samples were reconstituted to contain 9% total solids, adjusted to pH 7.0, and tested for turbidity, protein content from supernatants of ultracentrifuged samples, and HS. Lower SI values were observed for samples treated with 5mM disodium EDTA and sodium polyphosphate than control samples or samples with 5mM sodium citrate dihydrate. Furthermore, lower SI values were observed with an increased level of chelating agents regardless of chelator type. A decreased turbidity value was found with increasing levels of mineral chelating salt treatment. Low turbidity with increasing levels of added chelators may be associated with the dissociation of caseins from micelles. Furthermore, higher protein content was observed in supernatants of ultracentrifuged samples treated with increased level of chelators as compared with the control sample. Higher HS was observed in samples treated with 5mM compared with samples treated with 25mM mineral chelator. The results suggest improved solubility and HS upon addition of mineral chelators to SMP during its manufacture.

A previous study in our laboratory showed that addition of 150 mM NaCl or KCl into diafiltration water improved the solubility of freshly made milk protein concentrate 80 (MPC80). In the present study, the objectives were (1) to evaluate the solubility of NaCl- or KCl-treated MPC80 samples kept at varying temperatures and then stored for extensive periods at room temperature (21 °C ± 1 °C); and (2) to determine if MPC80 samples stored at different temperatures and protein conformation can be grouped or categorized together. Freshly manufactured MPC80 samples were untreated (control), processed with NaCl, or processed with KCl. One set of sample bags was stored at 4 °C; second and third sets of bags were kept at 25 °C and 55 °C for 1 mo (31 d) and then transferred to room temperature (21 °C ± 1 °C) storage conditions for 1 yr (365 d). Samples were tested for nitrogen solubility index (NSI) and for protein changes by Fourier-transform infrared (FTIR) spectroscopy. Analysis of variance results for NSI showed 2 significantly different groupings of MPC80 samples. The more soluble group contained samples treated with NaCl or KCl and stored at either 4 °C or 25 °C. These samples had mean NSI >97.5%. The less soluble groups contained all control samples, regardless of storage temperature, and NaCl- or KCl-treated samples stored at 55 °C. These samples had mean NSI from 39.5 to 58%. Within each of these groups (more soluble and less soluble), no significant differences in solubility were detected. Pattern recognition analysis by soft independent modeling of class analogy (SIMCA) was used to assess protein changes during storage by monitoring the amide I and amide II (1,700(-1) to 1,300 cm(-1)) regions. Dominant bands were observed at 1,385 cm(-1) for control, 1,551 cm(-1) for KCl-treated samples, and 1,694 cm(-1) for NaCl-treated samples. Moreover, SIMCA clustered the MPC80 samples stored at 4 °C separately from samples stored at 25 °C and 55 °C. This study demonstrates that (1) the addition of NaCl or KCl during MPC80 manufacture reduces the deleterious changes in solubility upon prolonged storage at 4 °C or 25 °C, and (2) the solubility of samples stored at 55 °C is poor irrespective of salt treatment.

Cream cheese is used as a spread and as an ingredient in many food applications. A gritty or grainy mouthfeel is an undesirable textural defect that occurs in cream cheese. However, the factors that cause the textural defect are not well understood. The objectives of this study were to isolate and characterize particles from cream cheese and to study the effect of particles on cheese texture. Particles were isolated by washing cream cheese with water first at 25 degrees C and then at 50 degrees C repeatedly 4 to 5 times. The size of these particles was determined using a particle size analyzer. The particles as well as the original cheeses were analyzed for moisture, fat, protein, ash, and lactose. The particle size ranged of 0.04 to 850 microm. It was found that isolated particles were significantly higher in protein content as compared with the whole cheese. To study the effect on the cheese texture, particles were added at 5, 15, and 25% (wt/wt) levels to smooth cream cheese, and a sensory ranking test was done on the samples. Isolated particles were further separated into 2 size classes of 2.5 to 150 microm and > or =150 microm. These particles were then mixed with smooth cream cheese at 16 and 29% (wt/wt), and a sensory test was conducted on these samples. Smooth cream cheese with only 5% (wt/wt) added particles was perceived as significantly grittier than the control sample. This experiment also revealed that the perceived grittiness increased with increase in amount and size of particles.

We made Milled curd Cheddar cheese with Lactococcus starter and an adjunct culture of Lactobacillus helveticus I or Lactobacillus casei T subjected to different attenuation treatments: freeze shocking (FS), heat shocking (HS), or spray drying (SD). Proteolysis during cheese ripening (0 to 6 mo), measured by urea-PAGE and water-soluble nitrogen, indicated only minor differences between control and most adjunct-treated cheeses. However, there were significant differences in the effect of Lactobacillus adjuncts on the level of free amino nitrogen in cheese. Cheeses made with FS or HS Lb. helveticus adjunct exhibited significantly greatest rates of free amino group formation. Lipolysis as measured by total free fatty acids was consistently highest in adjunct-treated cheeses, and FS Lb. casei-treated cheeses showed the highest rate of free fatty acid formation followed by FS Lb. helveticus treated cheeses. Mean flavor and aroma scores were significantly higher for cheeses made with Lb. helveticus strain. Freeze-shocked Lb. helveticus-treated cheeses obtained the highest flavor and aroma scores. Sensory evaluation indicated that most of the adjunct-treated cheeses promoted better texture and body quality.

Several previous reviews have described different ways to enhance the flavor and texture of cheese, including use of live cells and nonviable attenuated cells as adjunct cultures. However, comparisons between viable and nonviable cultures were never discussed in these reviews. In addition, recent publications on adjunct cultures have not been covered in previous reviews. This article will survey the more recent work on adjunct cultures--with particular attention to whether the adjuncts contained viable or nonviable cells--and propose areas where additional research is needed.