Min Wei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Min Wei has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
Hong Deng
9 shared publications- Hong Deng
UESTC
5 shared publications - Xue-Ran Deng
Research Center of Laser Fusion, China Academy of Engineering Physics, Mianyang 621900, China
4 shared publications Chun-Fu Li
Institute of Astronautics and Aeronautics, University of Electronic Science and Technology of China , Chengdu , China
2 shared publicationsChunfu Li
2 shared publicationsDavid M. Fryauf
University of California Santa Cruz
2 shared publications
Latest Publications
- 19 October 2020
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (23) , 20667-20687
Ferroelectric photovoltaic effect and resistive switching behavior modulated by ferroelectric/electrode interface coupling
- 19 October 2020
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (23) , 20667-20687
Ferroelectric photovoltaic effect and resistive switching behavior modulated by ferroelectric/electrode interface coupling
- Open Access
- 19 September 2018
- Published by Walter de Gruyter GmbH in Nanotechnology Reviews
- Vol. 7 (5) , 443-468
Optimization of non-linear conductance modulation based on metal oxide memristors
As memristor-simulating synaptic devices have become available in recent years, the optimization on non-linearity degree (NL, related to adjacent conductance values) is unignorable in the promotion of the learning accuracy of systems. Importantly, based on the theoretical support of the Mott theory and the three partial differential equations, and the model of conductive filaments (CFs), we analyzed and summarized the optimization schemes on the physical structure and the extra stimulus signal from the internal factor and external influence, two aspects, respectively. It is worth noting that we divided the extra stimulus signals into two categories, the combined pulse signal and the feedback pulse signal. The former has an internal logical optimized phenomenon, and the composition of only two parts in each cycle leads to a simple peripheral circuit. The latter can obtain an almost linear NL curve in software stimulation because of its feature in real-time adjustment of signals, but it is complex in hardware implementation. In consideration of space and energy consumption, achieving memristor with different resistive switching (RS) layers can be another optimization scheme. Special attention should be paid to the weaker NL, which could improve learning accuracy at the system level only when the value of other non-ideal properties such as the on/off ratio is within a certain range.
- 19 September 2018
- Published by Walter de Gruyter GmbH in Nanotechnology Reviews
- Vol. 7 (5) , 443-468
Open AccessOptimization of non-linear conductance modulation based on metal oxide memristors
As memristor-simulating synaptic devices have become available in recent years, the optimization on non-linearity degree (NL, related to adjacent conductance values) is unignorable in the promotion of the learning accuracy of systems. Importantly, based on the theoretical support of the Mott theory and the three partial differential equations, and the model of conductive filaments (CFs), we analyzed and summarized the optimization schemes on the physical structure and the extra stimulus signal from the internal factor and external influence, two aspects, respectively. It is worth noting that we divided the extra stimulus signals into two categories, the combined pulse signal and the feedback pulse signal. The former has an internal logical optimized phenomenon, and the composition of only two parts in each cycle leads to a simple peripheral circuit. The latter can obtain an almost linear NL curve in software stimulation because of its feature in real-time adjustment of signals, but it is complex in hardware implementation. In consideration of space and energy consumption, achieving memristor with different resistive switching (RS) layers can be another optimization scheme. Special attention should be paid to the weaker NL, which could improve learning accuracy at the system level only when the value of other non-ideal properties such as the on/off ratio is within a certain range.
- 1 May 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 705, 598-601
Influence of ZnO buffer layer on the electrical, optical and surface properties of Ga-doped ZnO films
- 1 May 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 705, 598-601
Influence of ZnO buffer layer on the electrical, optical and surface properties of Ga-doped ZnO films
- 1 January 2016
- Published by Inderscience Publishers in International Journal of Nanotechnology
- Vol. 13 (10/11/12) , 913
Bipolar resistive switching properties of Cu-CuO-InGaZnO-AZO multilayer structure thin film
A multilayer structure (Cu/CuO/InGaZO/AZO) resistive switching based on multi-component metal oxide is proposed and demonstrated. Al doped ZnO (AZO) thin film prepared on quartz substrate was chosen to be a bottom electrode owing to its high transparency and conductivity, then an InGaZnO (IGZO) thin film with high electronic mobility and ductility was grown on the substrate acting as a dielectric layer. We designed a CuO layer to be an electronic buffer layer between IGZO and top Cu electrode, which can play a critical role in increasing the On/Off current ratio. All of these four layers were prepared by RF magnetron sputtering at a low temperature of 200°C. Test results indicate that Cu/CuO/IGZO/AZO switching devices have about 10
- 1 January 2016
- Published by Inderscience Publishers in International Journal of Nanotechnology
- Vol. 13 (10/11/12) , 913
Bipolar resistive switching properties of Cu-CuO-InGaZnO-AZO multilayer structure thin film
A multilayer structure (Cu/CuO/InGaZO/AZO) resistive switching based on multi-component metal oxide is proposed and demonstrated. Al doped ZnO (AZO) thin film prepared on quartz substrate was chosen to be a bottom electrode owing to its high transparency and conductivity, then an InGaZnO (IGZO) thin film with high electronic mobility and ductility was grown on the substrate acting as a dielectric layer. We designed a CuO layer to be an electronic buffer layer between IGZO and top Cu electrode, which can play a critical role in increasing the On/Off current ratio. All of these four layers were prepared by RF magnetron sputtering at a low temperature of 200°C. Test results indicate that Cu/CuO/IGZO/AZO switching devices have about 10
- 28 April 2015
- Published by Springer Nature in Journal of Materials Science
- Vol. 50 (14) , 4926-4932
Single-crystal indium phosphide nanowires grown on polycrystalline copper foils with an aluminum-doped zinc oxide template
- 28 April 2015
- Published by Springer Nature in Journal of Materials Science
- Vol. 50 (14) , 4926-4932
Single-crystal indium phosphide nanowires grown on polycrystalline copper foils with an aluminum-doped zinc oxide template
- 9 October 2014
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 25 (12) , 5535-5539
Improvements in the performances of In–Ga–Zn–O thin-film transistors on glass substrates by annealing treatment
- 9 October 2014
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 25 (12) , 5535-5539
Improvements in the performances of In–Ga–Zn–O thin-film transistors on glass substrates by annealing treatment
- 16 September 2014
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9174, 91740T-91740T-7
Investigation on resistive switching characteristics of ZnO thin film
- 16 September 2014
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9174, 91740T-91740T-7
Investigation on resistive switching characteristics of ZnO thin film
- 26 July 2014
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 25 (10) , 4444-4449
Growth and characterization of indium phosphide nanowires on transparent conductive ZnO:Al films
- 26 July 2014
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 25 (10) , 4444-4449
Growth and characterization of indium phosphide nanowires on transparent conductive ZnO:Al films
- 1 October 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 114 (13) , 134502
Bipolar resistive switching characteristics in CuO/ZnO bilayer structure
Resistive switching characteristics in Cu/ZnO/AZO (Al-doped ZnO) were investigated. Reproducible bipolar resistance switching properties were observed in the single oxide layer (SL)-based device. To improve the switching performance, a CuO–ZnO bilayer (BL) was used to form a Cu/CuO/ZnO/AZO structure. RS characteristics such as retention time, endurance, variations of threshold voltage as well as distribution of resistance were investigated. The results demonstrated that the BL devices exhibit more excellent switching performance than SL devices. The conduction mechanisms of high and low resistance states can be explained by trap-controlled space charge limited current (SCLC) and Ohmic's Law, respectively. The CuO layer is proposed as a “reservoir” of oxygen ions in set process and acting as an oxygen ions “supplier” in reset process, which plays a critical role in recovery/rupture of filament paths and greatly improves the switching characteristics of the device.
- 1 October 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 114 (13) , 134502
Bipolar resistive switching characteristics in CuO/ZnO bilayer structure
Resistive switching characteristics in Cu/ZnO/AZO (Al-doped ZnO) were investigated. Reproducible bipolar resistance switching properties were observed in the single oxide layer (SL)-based device. To improve the switching performance, a CuO–ZnO bilayer (BL) was used to form a Cu/CuO/ZnO/AZO structure. RS characteristics such as retention time, endurance, variations of threshold voltage as well as distribution of resistance were investigated. The results demonstrated that the BL devices exhibit more excellent switching performance than SL devices. The conduction mechanisms of high and low resistance states can be explained by trap-controlled space charge limited current (SCLC) and Ohmic's Law, respectively. The CuO layer is proposed as a “reservoir” of oxygen ions in set process and acting as an oxygen ions “supplier” in reset process, which plays a critical role in recovery/rupture of filament paths and greatly improves the switching characteristics of the device.
- 1 June 2013
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 563, 99-103
Deep ultraviolet detecting property of AlxZn1−xO alloy thin film as photocathode layer
- 1 June 2013
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 563, 99-103
Deep ultraviolet detecting property of AlxZn1−xO alloy thin film as photocathode layer