Jaromír Příhoda
Research Subjects
Jaromír Příhoda has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Karel Kozel
CTU in Prague
5 shared publications - Jiří Fürst
Czech Technical University in Prague
3 shared publications - Petr Straka
VZLU – Czech Aerospace Research Centre, Beranových 130, 19905 Prague 9, Czech Republic
3 shared publications - David Šimurda
Institute of Thermomechanics, Czech Academy of Sciences, Dolejškova 5, Prague, Czech Republic
2 shared publications - Jiří Trefilík
Institute of Thermomechanics AS CR, v. v. i
2 shared publications - Bartolomej Rudas
R&D dept., Doosan Skoda Power, Ltd., Pilsen, Czech Republic
1 shared publication
Latest Publications
- Open Access
- 2 July 2024
- Published by Springer Nature in Journal of Thermal Science
- Vol. 33 (5) , 1-12
Hybrid LES/RANS Simulations of Compressible Flow in a Linear Cascade of Flat Blade Profiles
The paper reports on 3D numerical simulations of unsteady compressible airflow in a blade cascade consisting of flat profiles using a hybrid LES/RANS approach including a transition model. As a first step towards simulation of blade flutter in turbomachinery, various incidence angle offsets of the middle blade were modeled. All simulations were run for the flow regime characterized by outlet isentropic Mach number Mis=0.5 and zero incidence. The results of the LES/RANS simulations (pressure and Mach number distributions) were compared to a baseline RANS model, and to experimental data measured in a high-speed wind tunnel. The numerical results show that both methods overpredict flow separation taking place at the leading edge. In this regard, the hybrid LES/RANS method does not provide superior results compared to the traditional RANS simulations. Nevertheless, the LES/RANS results also capture vortex shedding from the blunt trailing edge. The frequency of the trailing edge vortex shedding in CFD simulations matches perfectly the spectral peak recorded during wind tunnel measurements.
- 2 July 2024
- Published by Springer Nature in Journal of Thermal Science
- Vol. 33 (5) , 1-12
Open AccessHybrid LES/RANS Simulations of Compressible Flow in a Linear Cascade of Flat Blade Profiles
The paper reports on 3D numerical simulations of unsteady compressible airflow in a blade cascade consisting of flat profiles using a hybrid LES/RANS approach including a transition model. As a first step towards simulation of blade flutter in turbomachinery, various incidence angle offsets of the middle blade were modeled. All simulations were run for the flow regime characterized by outlet isentropic Mach number Mis=0.5 and zero incidence. The results of the LES/RANS simulations (pressure and Mach number distributions) were compared to a baseline RANS model, and to experimental data measured in a high-speed wind tunnel. The numerical results show that both methods overpredict flow separation taking place at the leading edge. In this regard, the hybrid LES/RANS method does not provide superior results compared to the traditional RANS simulations. Nevertheless, the LES/RANS results also capture vortex shedding from the blunt trailing edge. The frequency of the trailing edge vortex shedding in CFD simulations matches perfectly the spectral peak recorded during wind tunnel measurements.
- Open Access
- 24 September 2019
- Published by MDPI AG in International Journal of Turbomachinery, Propulsion and Power
- Vol. 4 (4) , 33
Turbine Cascades of Last Stage Blades for Wide Range of Operating Conditions
Recent trends in the electric energy market such as biomass, waste incineration or combined cycle power plants require innovative solutions in steam turbine design. Variable operating conditions cause significant changes in flow field surrounding the steam turbine last stage blades. Therefore, the enlargement of operating range for last stage blades presents new challenges in design of turbine cascades. Several turbine cascades were designed and analyzed by commercial and in-house software of CTU Prague. Selected profiles were experimentally validated in the high-speed wind tunnel for 2D cascade measurements of the Institute of Thermomechanics of the Czech Academy of Sciences which is equipped by an adjustable supersonic inlet nozzle, perforated inserts at side walls and adjustable perforated tailboard. Comparisons are presented of numerical results with optical and pneumatic measurements for a wide range of inlet and outlet Mach numbers for optimized hub and tip profile cascades.
- 24 September 2019
- Published by MDPI AG in International Journal of Turbomachinery, Propulsion and Power
- Vol. 4 (4) , 33
Open AccessTurbine Cascades of Last Stage Blades for Wide Range of Operating Conditions
Recent trends in the electric energy market such as biomass, waste incineration or combined cycle power plants require innovative solutions in steam turbine design. Variable operating conditions cause significant changes in flow field surrounding the steam turbine last stage blades. Therefore, the enlargement of operating range for last stage blades presents new challenges in design of turbine cascades. Several turbine cascades were designed and analyzed by commercial and in-house software of CTU Prague. Selected profiles were experimentally validated in the high-speed wind tunnel for 2D cascade measurements of the Institute of Thermomechanics of the Czech Academy of Sciences which is equipped by an adjustable supersonic inlet nozzle, perforated inserts at side walls and adjustable perforated tailboard. Comparisons are presented of numerical results with optical and pneumatic measurements for a wide range of inlet and outlet Mach numbers for optimized hub and tip profile cascades.
- 1 January 2016
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1745 (1) , 020029
Numerical simulation of transitional flows with heat transfer
The contribution deals with simulation of internal flows with the laminar/turbulent transition and heat transfer. The numerical modeling of incompressible flow on a heated flat plate was carried out partly by the k-kL-ω model of Walters and Cokljat [1] and partly by the algebraic transition model of Straka and Příhoda [2] connected with the EARSM turbulence model of Hellsten [3]. Transition models were tested by means of the skin friction and the Stanton number distribution. Used models of turbulent heat transfer were compared with the simplest model based on the constant turbulent Prandtl number. The k-kL-ω model is applied for the simulation of compressible flow through the VKI turbine blade cascade with heat transfer.
- 1 January 2016
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1745 (1) , 020029
Numerical simulation of transitional flows with heat transfer
The contribution deals with simulation of internal flows with the laminar/turbulent transition and heat transfer. The numerical modeling of incompressible flow on a heated flat plate was carried out partly by the k-kL-ω model of Walters and Cokljat [1] and partly by the algebraic transition model of Straka and Příhoda [2] connected with the EARSM turbulence model of Hellsten [3]. Transition models were tested by means of the skin friction and the Stanton number distribution. Used models of turbulent heat transfer were compared with the simplest model based on the constant turbulent Prandtl number. The k-kL-ω model is applied for the simulation of compressible flow through the VKI turbine blade cascade with heat transfer.
- Open Access
- 25 March 2014
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 67, 02118
Numerical experiments modelling turbulent flows
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 25 March 2014
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 67, 02118
Open AccessNumerical experiments modelling turbulent flows
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 1 January 2014
- Published by AIP Publishing in AIP Conference Proceedings
Comparison of various laminar/turbulent transition models
The transition model with the algebraic equation for the intermittency coefficient proposed for the bypass transition was modified for modelling of the transition at low free-stream turbulence. Further, the three-equation k-kL-ω model and the Xfoil program were used for the comparison. All models were tested by means of the incompressible flow around the flat plate and symmetrical airfoils at moderate and very low free-stream turbulence.
- 1 January 2014
- Published by AIP Publishing in AIP Conference Proceedings
Comparison of various laminar/turbulent transition models
The transition model with the algebraic equation for the intermittency coefficient proposed for the bypass transition was modified for modelling of the transition at low free-stream turbulence. Further, the three-equation k-kL-ω model and the Xfoil program were used for the comparison. All models were tested by means of the incompressible flow around the flat plate and symmetrical airfoils at moderate and very low free-stream turbulence.
- Open Access
- 9 April 2013
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 45, 01090
Numerical experiments for turbulent flows
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 9 April 2013
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 45, 01090
Open AccessNumerical experiments for turbulent flows
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- Open Access
- 9 April 2013
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 45, 01042
Numerical Simulation of 2D Transonic Flows in DCA 8% Cascade
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 9 April 2013
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 45, 01042
Open AccessNumerical Simulation of 2D Transonic Flows in DCA 8% Cascade
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 4 November 2012
- Published by Springer Nature
- p. 539-547
Numerical Simulations of Turbulent 3D Flow in Channel Junction
- 4 November 2012
- Published by Springer Nature
- p. 539-547
Numerical Simulations of Turbulent 3D Flow in Channel Junction
- Open Access
- 16 April 2012
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 25, 02023
Modelling of subcritical free-surface flow over an inclined backward-facing step in a water channel
- 16 April 2012
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 25, 02023
Open AccessModelling of subcritical free-surface flow over an inclined backward-facing step in a water channel
- Open Access
- 16 April 2012
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 25, 01091
Modelling of the effect of the foregoing wake on the bypass transition on the airfoil
- 16 April 2012
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 25, 01091
Open AccessModelling of the effect of the foregoing wake on the bypass transition on the airfoil