Johann Thomas Sausgruber
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Johann Thomas Sausgruber has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Alexander Preh
Vienna University of Technology
4 shared publications - Michael Schiffer
Wildbach- und Lawinenverbauung Gebietsbauleitung Salzkammergut, Austrian Service for Torrent and Avalanche, Control, Traunreiterweg 5, 4820 Bad Ischl, Austria
2 shared publications - Rainer Poisel
Vienna University of Technology
2 shared publications - Robert Hofmann
Priv. Doz. Dipl.-Ing. Dr. techn.; Ziviltechnikerbüro Hofmann, Hochstraße 17, 2380 Perchtoldsdorf; Austria
2 shared publications - Anna Sara Amabile
GBA-Geological Survey of Austria, Neulinggasse 38, 1030 Vienna, Austria
1 shared publication - Anne Hormes
Sky4geo e.U. Planötzenhofstrasse 29b 6020 Innsbruck
1 shared publication
Latest Publications
- Open Access
- 21 June 2022
- Published by MDPI AG in Geosciences
- Vol. 12 (7) , 255
Challenges Assessing Rock Slope Stability Using the Strength Reduction Method with the Hoek–Brown Criterion on the Example of Vals (Tyrol/Austria)
To estimate the hazard posed by rock slopes, it is essential to determine the overall stability and potential detachment volume. This is mostly solved using numerical methods together with the strength reduction method (SRM). Many calculation programs do not provide a direct implementation of the Hoek–Brown (HB) criterion. Equivalent Mohr–Coulomb (MC) parameters are often used. Especially for steep rock slopes, the use of equivalent MC parameters with numerical codes and the SRM lead to poor estimates of safety factors. The problem lies in the required and often difficult estimation of a suitable range of minor principal stresses over a ‘slope height’. In the example of the stability analysis of the rock slope Vals in Tyrol/Austria, we show the differences between the application of equivalent MC parameters and a direct application of the HB criterion with apparent MC parameters. The detachment volume and stability are overestimated when applying equivalent MC parameters, as confirmed by calculations with the continuum mechanics code FLAC3D (Itasca Consulting Group). However, the SRM with HB material (i.e., apparent MC parameters) results in a safety factor that cannot be applied to HB parameters. To date, it has not been possible to determine the HB parameters for limit equilibrium via the SRM. This challenge was overcome by fitting an HB envelope to the original HB shear envelope reduced by the safety factor. The envelope is adjusted by two HB variables: GSI and D. This allows to determine the HB parameters at limit equilibrium. It helps to make more realistic predictions about the detachment mechanism and volume.
- 21 June 2022
- Published by MDPI AG in Geosciences
- Vol. 12 (7) , 255
Open AccessChallenges Assessing Rock Slope Stability Using the Strength Reduction Method with the Hoek–Brown Criterion on the Example of Vals (Tyrol/Austria)
To estimate the hazard posed by rock slopes, it is essential to determine the overall stability and potential detachment volume. This is mostly solved using numerical methods together with the strength reduction method (SRM). Many calculation programs do not provide a direct implementation of the Hoek–Brown (HB) criterion. Equivalent Mohr–Coulomb (MC) parameters are often used. Especially for steep rock slopes, the use of equivalent MC parameters with numerical codes and the SRM lead to poor estimates of safety factors. The problem lies in the required and often difficult estimation of a suitable range of minor principal stresses over a ‘slope height’. In the example of the stability analysis of the rock slope Vals in Tyrol/Austria, we show the differences between the application of equivalent MC parameters and a direct application of the HB criterion with apparent MC parameters. The detachment volume and stability are overestimated when applying equivalent MC parameters, as confirmed by calculations with the continuum mechanics code FLAC3D (Itasca Consulting Group). However, the SRM with HB material (i.e., apparent MC parameters) results in a safety factor that cannot be applied to HB parameters. To date, it has not been possible to determine the HB parameters for limit equilibrium via the SRM. This challenge was overcome by fitting an HB envelope to the original HB shear envelope reduced by the safety factor. The envelope is adjusted by two HB variables: GSI and D. This allows to determine the HB parameters at limit equilibrium. It helps to make more realistic predictions about the detachment mechanism and volume.
- 17 February 2020
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 13 (1) , 88-102
Innovative methods to monitor rock and mountain slope deformation
- 17 February 2020
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 13 (1) , 88-102
Innovative methods to monitor rock and mountain slope deformation
- 9 February 2017
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 10 (1) , 59-73
Creep behaviour and remediation concept for a deep‐seated landslide, Navistal, Tyrol, Austria
In the valley of Navis, the village of Kerschbaum with 84 houses stands on a slowly downhill moving, relatively corase grained, aqua bearing earth‐flow/‐slide about 40 m thick. This secondary movement overlies a deep‐seated rock slide. The rates of movement at the surface of the earth‐flow/‐slide were between 1 und 3 cm/a before the implementation of remedial works. Starting from the geotechnical and geomechanical model of the slope, measures were developed, which were intended to reduce the movement. A monitoring system was installed to provide information about the movement and slope water conditions of the earth‐flow/‐slide and the sliding rock mass. In order to estimate the creep behaviour of the earth‐flow/‐slide, the ductility index ILZR was determined from shear tests. A simple flow law was assumed for the estimation of the change of creep rate. Measurements over a period of about 18 months after the first phase of remedial works show rates between 0.5 and 1.2 cm/a. The reduction of the rate of movement is compared with the creep model applied and the viscosity index ILZR to check the validity.
- 9 February 2017
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 10 (1) , 59-73
Creep behaviour and remediation concept for a deep‐seated landslide, Navistal, Tyrol, Austria
In the valley of Navis, the village of Kerschbaum with 84 houses stands on a slowly downhill moving, relatively corase grained, aqua bearing earth‐flow/‐slide about 40 m thick. This secondary movement overlies a deep‐seated rock slide. The rates of movement at the surface of the earth‐flow/‐slide were between 1 und 3 cm/a before the implementation of remedial works. Starting from the geotechnical and geomechanical model of the slope, measures were developed, which were intended to reduce the movement. A monitoring system was installed to provide information about the movement and slope water conditions of the earth‐flow/‐slide and the sliding rock mass. In order to estimate the creep behaviour of the earth‐flow/‐slide, the ductility index ILZR was determined from shear tests. A simple flow law was assumed for the estimation of the change of creep rate. Measurements over a period of about 18 months after the first phase of remedial works show rates between 0.5 and 1.2 cm/a. The reduction of the rate of movement is compared with the creep model applied and the viscosity index ILZR to check the validity.
- 1 August 2012
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 5 (4) , 355-367
Evacuation or protection? Risk analysis as a tool for decision making in the case of a residential building endangered by rockfall / Aussiedlung oder Schutz? Die Risikoanalyse als Entscheidungsgrundlage im Fall eines durch Steinschlag bedrohten Wohnhauses
- 1 August 2012
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 5 (4) , 355-367
Evacuation or protection? Risk analysis as a tool for decision making in the case of a residential building endangered by rockfall / Aussiedlung oder Schutz? Die Risikoanalyse als Entscheidungsgrundlage im Fall eines durch Steinschlag bedrohten Wohnhauses
- 3 May 2012
- Published by Springer Nature
- p. 33-49
Susceptibility and Triggers for Debris Flows: Emergence, Loading, Release and Entrainment
- 3 May 2012
- Published by Springer Nature
- p. 33-49
Susceptibility and Triggers for Debris Flows: Emergence, Loading, Release and Entrainment
- 5 October 2011
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 4 (5) , 445-453
Lessons learned from Gschliefgraben mudslide (Austria) / Die Lehren aus dem Erdstrom im Gschliefgraben (Österreich)
- 5 October 2011
- Published by Wiley in Geomechanics and Tunnelling
- Vol. 4 (5) , 445-453
Lessons learned from Gschliefgraben mudslide (Austria) / Die Lehren aus dem Erdstrom im Gschliefgraben (Österreich)
- 16 June 2011
- Published by Springer Nature in Natural Hazards
- Vol. 61 (1) , 267-279
Gschliefgraben mudslide (Austria): hazard evaluation and risk mitigation
- 16 June 2011
- Published by Springer Nature in Natural Hazards
- Vol. 61 (1) , 267-279
Gschliefgraben mudslide (Austria): hazard evaluation and risk mitigation