Paul E. Luner
Paul E. Luner has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Jeffery J. Seyer
College of Pharmacy, Division of Pharmaceutics, The University of Iowa, Iowa City, Iowa 52242; Pfizer Consumer Healthcare, Richmond, Virginia 23261
2 shared publicationsCecile Forness
Material and Analytical Sciences, Boehringer Ingelheim Pharmaceuticals, Inc., Ridgefield, Connecticut, 06877, USA
1 shared publicationCorinne Jankovsky
Material and Analytical Sciences, Boehringer Ingelheim Pharmaceuticals, Inc., Ridgefield, Connecticut, 06877, USA
1 shared publicationDoris Baker
Material and Analytical Sciences, Boehringer Ingelheim Pharmaceuticals, Inc., Ridgefield, Connecticut, 06877, USA
1 shared publication- Kaushalkumar Dave
Present Address: Division of Biopharmaceutics, Office of New Drug Products, Office of Pharmaceutical Quality, Center for Drug Evaluation and Research, Food and Drug Administration, Silver Spring, MD 20993, USA
1 shared publication - M. Teresa Carvajal
Agricultural and Biological Engineering, Purdue University, West Lafayette, IN 47907, USA
1 shared publication
Latest Publications
- 21 June 2017
- Published by Springer Nature in AAPS PharmSciTech
- Vol. 19 (1) , 155-165
Feasibility of Focused Beam Reflectance Measurement (FBRM) for Analysis of Pharmaceutical Suspensions in Preclinical Development
This study examined the use of focused beam reflectance measurement (FBRM) for qualitative and quantitative analysis of pharmaceutical suspensions with particular application to toxicology supply preparations for use in preclinical studies. Aqueous suspensions of ibuprofen were used as prototype formulations. Initial experiments were conducted to examine the effects of operational conditions including FBRM probe angle, probe location, and mixing (method and rate of mixing) on the FBRM analysis. Once experimental conditions were optimized, the homogeneity and sedimentation-redispersion of particles in the suspensions were assessed. Ibuprofen suspension under continuous agitation was monitored using FBRM for 60 h to study particle size change over time. Another study was performed to determine if particle count rates obtained by FBRM could be correlated to suspension concentration. The location and the angle of the FBRM probe relative to the beaker contents, and the rate and the method of mixing the suspension were found to be sensitive parameters during FBRM analysis. FBRM was able to monitor the process of particle sedimentation in the suspension. The attrition of ibuprofen particles was detectable by FBRM during prolonged stirring with an increase in the number of smaller particles and decrease in the number of larger particles. A strong correlation was observed between particle count rate by FBRM and ibuprofen concentration in the suspension. Also, change in content uniformity in the suspension at different locations of the beaker was represented by FBRM particle count. Overall, FBRM has potential to be a useful tool for qualitative and quantitative analysis of pharmaceutical suspensions.
- 21 June 2017
- Published by Springer Nature in AAPS PharmSciTech
- Vol. 19 (1) , 155-165
Feasibility of Focused Beam Reflectance Measurement (FBRM) for Analysis of Pharmaceutical Suspensions in Preclinical Development
This study examined the use of focused beam reflectance measurement (FBRM) for qualitative and quantitative analysis of pharmaceutical suspensions with particular application to toxicology supply preparations for use in preclinical studies. Aqueous suspensions of ibuprofen were used as prototype formulations. Initial experiments were conducted to examine the effects of operational conditions including FBRM probe angle, probe location, and mixing (method and rate of mixing) on the FBRM analysis. Once experimental conditions were optimized, the homogeneity and sedimentation-redispersion of particles in the suspensions were assessed. Ibuprofen suspension under continuous agitation was monitored using FBRM for 60 h to study particle size change over time. Another study was performed to determine if particle count rates obtained by FBRM could be correlated to suspension concentration. The location and the angle of the FBRM probe relative to the beaker contents, and the rate and the method of mixing the suspension were found to be sensitive parameters during FBRM analysis. FBRM was able to monitor the process of particle sedimentation in the suspension. The attrition of ibuprofen particles was detectable by FBRM during prolonged stirring with an increase in the number of smaller particles and decrease in the number of larger particles. A strong correlation was observed between particle count rate by FBRM and ibuprofen concentration in the suspension. Also, change in content uniformity in the suspension at different locations of the beaker was represented by FBRM particle count. Overall, FBRM has potential to be a useful tool for qualitative and quantitative analysis of pharmaceutical suspensions.
- 1 November 2015
- Published by Elsevier in Journal of Pharmaceutical Sciences
- Vol. 104 (11) , 3804-3813
Assessment of Pharmaceutical Powder Flowability using Shear Cell-Based Methods and Application of Jenike’s Methodology
- 1 November 2015
- Published by Elsevier in Journal of Pharmaceutical Sciences
- Vol. 104 (11) , 3804-3813
Assessment of Pharmaceutical Powder Flowability using Shear Cell-Based Methods and Application of Jenike’s Methodology
- 1 September 2014
- Published by Elsevier in Journal of Pharmaceutical Sciences
- Vol. 103 (9) , 2884-2895
Assessment of Crystallinity in Processed Sucrose by Near‐Infrared Spectroscopy and Application to Lyophiles
- 1 September 2014
- Published by Elsevier in Journal of Pharmaceutical Sciences
- Vol. 103 (9) , 2884-2895
Assessment of Crystallinity in Processed Sucrose by Near‐Infrared Spectroscopy and Application to Lyophiles
- 23 October 2012
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 12 (11) , 5271-5282
Evaluation of Milling Method on the Surface Energetics of Molecular Crystals Using Inverse Gas Chromatography
- 23 October 2012
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 12 (11) , 5271-5282
Evaluation of Milling Method on the Surface Energetics of Molecular Crystals Using Inverse Gas Chromatography
- 1 January 2001
- Published by Taylor & Francis in Pharmaceutical Development and Technology
- Vol. 6 (4) , 573-582
Determination of Indomethacin Crystallinity in the Presence of Excipients Using Diffuse Reflectance Near-Infrared Spectroscopy
Studies were conducted to investigate the use of near-infrared spectroscopy for determining the crystallinity of indomethacin in multi-component physical mixtures. Three calibration sets of amorphous/crystalline indomethacin physical mixtures were prepared over the composition range of 0-100% crystallinity. Each of the three calibration sets was diluted step-wise with increasing amounts of a single excipient (Avicel, alpha-lactose monohydrate, or sodium chloride). Near-infrared spectra were obtained after each round of dilutions using diffuse reflectance sampling on samples contained in glass vials. After a second derivative transformation, standard curves were constructed by plotting percent indomethacin crystallinity against the ratio of responses at two wavelengths. At dilution levels up to 75% Avicel or lactose, the calibration models demonstrated high coefficients of determination and low standard errors. Dilution with sodium chloride did not produce comparable results and it was necessary to use partial least-squares regression to achieve a similar level of error. These findings were confirmed with separate validation sets. An investigation of instrument error showed that the impact of instrument variability on quantification generally increased as a function of the dilution level.
- 1 January 2001
- Published by Taylor & Francis in Pharmaceutical Development and Technology
- Vol. 6 (4) , 573-582
Determination of Indomethacin Crystallinity in the Presence of Excipients Using Diffuse Reflectance Near-Infrared Spectroscopy
Studies were conducted to investigate the use of near-infrared spectroscopy for determining the crystallinity of indomethacin in multi-component physical mixtures. Three calibration sets of amorphous/crystalline indomethacin physical mixtures were prepared over the composition range of 0-100% crystallinity. Each of the three calibration sets was diluted step-wise with increasing amounts of a single excipient (Avicel, alpha-lactose monohydrate, or sodium chloride). Near-infrared spectra were obtained after each round of dilutions using diffuse reflectance sampling on samples contained in glass vials. After a second derivative transformation, standard curves were constructed by plotting percent indomethacin crystallinity against the ratio of responses at two wavelengths. At dilution levels up to 75% Avicel or lactose, the calibration models demonstrated high coefficients of determination and low standard errors. Dilution with sodium chloride did not produce comparable results and it was necessary to use partial least-squares regression to achieve a similar level of error. These findings were confirmed with separate validation sets. An investigation of instrument error showed that the impact of instrument variability on quantification generally increased as a function of the dilution level.