Kiyonori Mizuno
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kiyonori Mizuno has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Masahiro Kurosaka
Kobe University Graduate School of Medicine
6 shared publications Mitsumasa Matsuda
3 shared publications- Shinichi Yoshiya
Department of Orthopaedic Surgery Nishinomiya Kaisei Hospital Nishinomiya Hyogo Japan
3 shared publications - Hirotsugu Muratsu
Department of Orthopaedic Surgery, Nippon Steel Hirohata Hospital, Japan
2 shared publications - Jun Okamoto
Waseda University
2 shared publications Kyohei Kida
Waseda University
2 shared publications
Latest Publications
- 1 January 2007
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2007, _1A2-L03_1
1A2-L03 Development of a Manual Clinical Examination Assisting System for Knee Ligament Injury : Evaluation of Estimation Accuracy of Force Acting on Knee Joint
The manual clinical examinations are commonly used in orthopedic clinical practice to estimate the state of knee ligament injury. However, the manual clinical examination results depend on a doctor's intuition and experience greatly because they are judged by the feel of the reaction of affected part to the doctor's hand. Therefore, we proposed a manual clinical examination assisting system that provides force acting on a knee joint and a lower leg motion quantitatively to a doctor. This paper focused on force acting on a knee joint. And we evaluated estimation accuracy of the force calculated by manual clinical examination assisting system.
- 1 January 2007
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2007, _1A2-L03_1
1A2-L03 Development of a Manual Clinical Examination Assisting System for Knee Ligament Injury : Evaluation of Estimation Accuracy of Force Acting on Knee Joint
The manual clinical examinations are commonly used in orthopedic clinical practice to estimate the state of knee ligament injury. However, the manual clinical examination results depend on a doctor's intuition and experience greatly because they are judged by the feel of the reaction of affected part to the doctor's hand. Therefore, we proposed a manual clinical examination assisting system that provides force acting on a knee joint and a lower leg motion quantitatively to a doctor. This paper focused on force acting on a knee joint. And we evaluated estimation accuracy of the force calculated by manual clinical examination assisting system.
- 1 January 2007
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2007, _2A1-G07_1
2A1-G07 Robotic instrument for evaluating intra-operative soft tissue balance of knee joint
The intra-operative evaluation of soft tissue balance in knee arthroplasty is executed with trial components of article knee joint. It is needed for excellent long-term result after knee arthroplasty to confirm the proper soft tissue balance. So to assist surgeon, we proposed the robotic instrument for intra-operative evaluation. This paper reports the in vitro experiment with the robotic instrument that consists of tensing robot and 6DOF measurement of the knee joint. We could adjust the soft tissue balance quantitatively by cutting distal femur seeing the robotic data.
- 1 January 2007
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2007, _2A1-G07_1
2A1-G07 Robotic instrument for evaluating intra-operative soft tissue balance of knee joint
The intra-operative evaluation of soft tissue balance in knee arthroplasty is executed with trial components of article knee joint. It is needed for excellent long-term result after knee arthroplasty to confirm the proper soft tissue balance. So to assist surgeon, we proposed the robotic instrument for intra-operative evaluation. This paper reports the in vitro experiment with the robotic instrument that consists of tensing robot and 6DOF measurement of the knee joint. We could adjust the soft tissue balance quantitatively by cutting distal femur seeing the robotic data.
- 14 June 2006
- Published by ASME International in Journal of Biomechanical Engineering
- Vol. 128 (6) , 867-871
Joint Gap Kinematics in Posterior-Stabilized Total Knee Arthroplasty Measured by a New Tensor With the Navigation System
Background: The management of soft tissue balance during surgery is essential for the success of total knee arthroplasty (TKA) but remains difficult, leaving it much to the surgeon’s feel. Previous assessments for soft tissue balance have been performed under unphysiological joint conditions, with patellar eversion and without the prosthesis only at extension and 90 deg of flexion. We therefore developed a new tensor for TKA procedures, enabling soft tissue balance assessment throughout the range of motion while reproducing postoperative joint alignment with the patellofemoral (PF) joint reduced and the tibiofemoral joint aligned. Our purpose in the present study was to clarify joint gap kinematics using the tensor with the CT-free computer assisted navigation system. Method of Approach: Joint gap kinematics, defined as joint gap change during knee motion, was evaluated during 30 consecutive, primary posterior-stabilized (PS) TKA with the navigation system in 30 osteoarthritic patients. Measurements were performed using a newly developed tensor, which enabled the measurement of the joint gap throughout the range of motion, including the joint conditions relevant after TKA with PF joint reduced and trial femoral component in place. Joint gap was assessed by the tensor at full extension, 5 deg, 10 deg, 15 deg, 30 deg, 45 deg, 60 deg, 90 deg, and 135 deg of flexion with the patella both everted and reduced. The navigation system was used to obtain the accuracy of implantations and to measure an accurate flexion angle of the knee during the intraoperative joint gap measurement. Results: Results showed that the joint gap varied depending on the knee flexion angle. Joint gap showed an accelerated decrease during full knee extension. With the PF joint everted, the joint gap increased throughout knee flexion. In contrast, the joint gap with the PF joint reduced increased with knee flexion but decreased after 60 deg of flexion. Conclusions: We clarified the characteristics of joint gap kinematics in PS TKA under physiological and reproducible joint conditions. Our findings can provide useful information for prosthetic design and selection and allow evaluation of surgical technique throughout the range of knee motion that may lead to consistent clinical outcomes after TKA.
- 14 June 2006
- Published by ASME International in Journal of Biomechanical Engineering
- Vol. 128 (6) , 867-871
Joint Gap Kinematics in Posterior-Stabilized Total Knee Arthroplasty Measured by a New Tensor With the Navigation System
Background: The management of soft tissue balance during surgery is essential for the success of total knee arthroplasty (TKA) but remains difficult, leaving it much to the surgeon’s feel. Previous assessments for soft tissue balance have been performed under unphysiological joint conditions, with patellar eversion and without the prosthesis only at extension and 90 deg of flexion. We therefore developed a new tensor for TKA procedures, enabling soft tissue balance assessment throughout the range of motion while reproducing postoperative joint alignment with the patellofemoral (PF) joint reduced and the tibiofemoral joint aligned. Our purpose in the present study was to clarify joint gap kinematics using the tensor with the CT-free computer assisted navigation system. Method of Approach: Joint gap kinematics, defined as joint gap change during knee motion, was evaluated during 30 consecutive, primary posterior-stabilized (PS) TKA with the navigation system in 30 osteoarthritic patients. Measurements were performed using a newly developed tensor, which enabled the measurement of the joint gap throughout the range of motion, including the joint conditions relevant after TKA with PF joint reduced and trial femoral component in place. Joint gap was assessed by the tensor at full extension, 5 deg, 10 deg, 15 deg, 30 deg, 45 deg, 60 deg, 90 deg, and 135 deg of flexion with the patella both everted and reduced. The navigation system was used to obtain the accuracy of implantations and to measure an accurate flexion angle of the knee during the intraoperative joint gap measurement. Results: Results showed that the joint gap varied depending on the knee flexion angle. Joint gap showed an accelerated decrease during full knee extension. With the PF joint everted, the joint gap increased throughout knee flexion. In contrast, the joint gap with the PF joint reduced increased with knee flexion but decreased after 60 deg of flexion. Conclusions: We clarified the characteristics of joint gap kinematics in PS TKA under physiological and reproducible joint conditions. Our findings can provide useful information for prosthetic design and selection and allow evaluation of surgical technique throughout the range of knee motion that may lead to consistent clinical outcomes after TKA.
- Open Access
- 1 January 2003
- Published by Japan Society of Mechanical Engineers in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
- Vol. 69 (680) , 945-952
Reconstruction of the Posterolateral Structure of the Knee.
- 1 January 2003
- Published by Japan Society of Mechanical Engineers in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
- Vol. 69 (680) , 945-952
Open AccessReconstruction of the Posterolateral Structure of the Knee.
- 1 January 2000
- Published by Japan Society of Mechanical Engineers in Proceedings of the JSME Bioengineering Conference and Seminar
- Vol. 2000.11, 61-62
Reconstruction of Posteolateral Structure on Knee
- 1 January 2000
- Published by Japan Society of Mechanical Engineers in Proceedings of the JSME Bioengineering Conference and Seminar
- Vol. 2000.11, 61-62
Reconstruction of Posteolateral Structure on Knee
- 1 January 1997
- Published by Japan Society of Mechanical Engineers in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
- Vol. 63 (607) , 875-880
Identification of the Resultant Force Direction and Magnitude of Quadriceps Femoris by Video Image Analysis.
- 1 January 1997
- Published by Japan Society of Mechanical Engineers in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
- Vol. 63 (607) , 875-880
Identification of the Resultant Force Direction and Magnitude of Quadriceps Femoris by Video Image Analysis.