John F. McClelland
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
John F. McClelland has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Roger W. Jones
Iowa State University
5 shared publications - Connor Daily
Materials Science and Engineering Department, Iowa State University, Ames, IA, USA
1 shared publication Dan J. Barnard
Center for Nondestructive Evaluation, Iowa State University, USA
1 shared publication- Diane F. Birt
Iowa State University, Ames, IA
1 shared publication Jay-Lin Jane
Ames Laboratory, United States Department of Energy (U.S. DOE), ‡Department of Chemistry, §Department of Food Science and Human Nutrition, and ∥Department of Mechanical Engineering, Iowa State University, Ames, Iowa 50011, United States
1 shared publicationNicola Bowler
Materials Science and Engineering Department, Iowa State University and Center for Nondestructive Evaluation, Iowa State University, USA
1 shared publication
Latest Publications
- 1 January 2015
- Published by AIP Publishing in AIP Conference Proceedings
Thermo-oxidative degradation assessment in quasi-isotropic carbon fiber/epoxy composites
Components made from polymer matrix composites (PMCs) are finding increasing use in armored vehicles for the purpose of weight savings and fuel efficiency. Often times, these PMC components are installed next to engines, or in other high-temperature environments within the vehicle. The present work investigates the change in surface chemistry and its correlation with changes in the interlaminar shear strength (ILSS) due to accelerated thermo-oxidative aging of a quasi-isotropic carbon fiber reinforced epoxy laminate. Samples are aged isothermally at various temperatures whose selection is guided by degradation steps revealed by thermo-gravimetric analysis. Fourier transform infrared (FTIR) photoacoustic spectroscopy is utilized to identify the chemical changes due to aging, and compression-test results reveal a non-linear decrease in ILSS with increasing aging temperature. A correlation between the FTIR and ILSS data sets suggests that nondestructive FTIR techniques may be used for assessing ILSS of PMCs.
- 1 January 2015
- Published by AIP Publishing in AIP Conference Proceedings
Thermo-oxidative degradation assessment in quasi-isotropic carbon fiber/epoxy composites
Components made from polymer matrix composites (PMCs) are finding increasing use in armored vehicles for the purpose of weight savings and fuel efficiency. Often times, these PMC components are installed next to engines, or in other high-temperature environments within the vehicle. The present work investigates the change in surface chemistry and its correlation with changes in the interlaminar shear strength (ILSS) due to accelerated thermo-oxidative aging of a quasi-isotropic carbon fiber reinforced epoxy laminate. Samples are aged isothermally at various temperatures whose selection is guided by degradation steps revealed by thermo-gravimetric analysis. Fourier transform infrared (FTIR) photoacoustic spectroscopy is utilized to identify the chemical changes due to aging, and compression-test results reveal a non-linear decrease in ILSS with increasing aging temperature. A correlation between the FTIR and ILSS data sets suggests that nondestructive FTIR techniques may be used for assessing ILSS of PMCs.
- 13 February 2013
- Published by American Chemical Society (ACS) in Journal of Agricultural and Food Chemistry
- Vol. 61 (8) , 1818-1822
Analysis of Resistant Starches in Rat Cecal Contents Using Fourier Transform Infrared Photoacoustic Spectroscopy
Fourier transform infrared photoacoustic spectroscopy (FTIR-PAS) qualitatively and quantitatively measured resistant starch (RS) in rat cecal contents. Fisher 344 rats were fed diets of 55% (w/w, dry basis) starch for 8 weeks. Cecal contents were collected from sacrificed rats. A corn starch control was compared against three RS diets. The RS diets were high-amylose corn starch (HA7), HA7 chemically modified with octenyl succinic anhydride, and stearic-acid-complexed HA7 starch. To calibrate the FTIR-PAS analysis, samples from each diet were analyzed using an enzymatic assay. A partial least-squares cross-validation plot generated from the enzymatic assay and FTIR-PAS spectral results for starch fit the ideal curve with a R2 of 0.997. A principal component analysis plot of components 1 and 2 showed that spectra from diets clustered significantly from each other. This study clearly showed that FTIR-PAS can accurately quantify starch content and identify the form of starch in complex matrices.
- 13 February 2013
- Published by American Chemical Society (ACS) in Journal of Agricultural and Food Chemistry
- Vol. 61 (8) , 1818-1822
Analysis of Resistant Starches in Rat Cecal Contents Using Fourier Transform Infrared Photoacoustic Spectroscopy
Fourier transform infrared photoacoustic spectroscopy (FTIR-PAS) qualitatively and quantitatively measured resistant starch (RS) in rat cecal contents. Fisher 344 rats were fed diets of 55% (w/w, dry basis) starch for 8 weeks. Cecal contents were collected from sacrificed rats. A corn starch control was compared against three RS diets. The RS diets were high-amylose corn starch (HA7), HA7 chemically modified with octenyl succinic anhydride, and stearic-acid-complexed HA7 starch. To calibrate the FTIR-PAS analysis, samples from each diet were analyzed using an enzymatic assay. A partial least-squares cross-validation plot generated from the enzymatic assay and FTIR-PAS spectral results for starch fit the ideal curve with a R2 of 0.997. A principal component analysis plot of components 1 and 2 showed that spectra from diets clustered significantly from each other. This study clearly showed that FTIR-PAS can accurately quantify starch content and identify the form of starch in complex matrices.
- 1 March 1992
- Published by SPIE-Intl Soc Optical Eng
- Vol. 1575, 220-222
Real-time infrared spectroscopy of moving solids for on-line analyses
Two related methods, transient infrared emission spectroscopy and transient infrared transmission spectroscopy, can obtain good spectra from opaque, moving solids by using a transient thermal gradient to isolate spectroscopically a thin layer of material. The basic elements of the methods, the ability to depth profile, and an application involving monitoring coating cure are described.
- 1 March 1992
- Published by SPIE-Intl Soc Optical Eng
- Vol. 1575, 220-222
Real-time infrared spectroscopy of moving solids for on-line analyses
Two related methods, transient infrared emission spectroscopy and transient infrared transmission spectroscopy, can obtain good spectra from opaque, moving solids by using a transient thermal gradient to isolate spectroscopically a thin layer of material. The basic elements of the methods, the ability to depth profile, and an application involving monitoring coating cure are described.
- 15 October 1990
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 62 (20) , 2247-2251
Transient infrared transmission spectroscopy
Transient infrared transmission spectroscopy is a new method that can acquire analytically useful transmission spectra from moving, optically thick solids. No sample preparation is required. The spectra are of sufficient quality for accurate quantitative compositional analysis. The method works by the creation of a thin, short-lived, chilled layer at the sample surface. Blackbody-like thermal emission from the bulk of the sample is selectively absorbed as it passes through the chilled layer, so the transmission spectrum of the layer is superimposed on the observed thermal emission. Spectra of polycarbonate, beeswax, and copolymers of methyl and butyl methacrylate are presented. Compositional analysis of the methacrylate copolymers with a standard error of prediction of only 0.87 mol % is demonstrated.
- 15 October 1990
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 62 (20) , 2247-2251
Transient infrared transmission spectroscopy
Transient infrared transmission spectroscopy is a new method that can acquire analytically useful transmission spectra from moving, optically thick solids. No sample preparation is required. The spectra are of sufficient quality for accurate quantitative compositional analysis. The method works by the creation of a thin, short-lived, chilled layer at the sample surface. Blackbody-like thermal emission from the bulk of the sample is selectively absorbed as it passes through the chilled layer, so the transmission spectrum of the layer is superimposed on the observed thermal emission. Spectra of polycarbonate, beeswax, and copolymers of methyl and butyl methacrylate are presented. Compositional analysis of the methacrylate copolymers with a standard error of prediction of only 0.87 mol % is demonstrated.
- 1 October 1990
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 62 (19) , 2074-2079
Quantitative analysis of solids in motion by transient infrared emission spectroscopy using hot-gas jet excitation
- 1 October 1990
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 62 (19) , 2074-2079
Quantitative analysis of solids in motion by transient infrared emission spectroscopy using hot-gas jet excitation