C. Lederer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
C. Lederer has a total of 206 co-authors. Here are the top co-authors by number of shared publications:
- Alberto Mengoni
European Organization for Nuclear Research (CERN), 1211 Geneva, Switzerland
4 shared publications - Rene Reifarth
Los Alamos National Laboratory (LANL), Los Alamos, NM (United States)
4 shared publications - Anton Wallner
Helmholtz-Zentrum Dresden-Rossendorf, 01328 Dresden, Germany
3 shared publications F. Käppeler
3 shared publications- Justyna Marganiec
Uniwersytet Łódzki, Lodz, Poland
3 shared publications - Michael Heil
GSI Helmholtzzentrum fūr Schwerionenforschung, Darmstadt, Germany
3 shared publications
Latest Publications
- Open Access
- 23 July 2015
- Published by American Physical Society (APS) in Physical Review C
- Vol. 92 (1)
Erratum: Stellar neutron capture cross sections of Ne20,21,22 [Phys. Rev. C 90 , 045804 (2014)]
DOI: ©2015 American Physical Society
- 23 July 2015
- Published by American Physical Society (APS) in Physical Review C
- Vol. 92 (1)
Open AccessErratum: Stellar neutron capture cross sections of Ne20,21,22 [Phys. Rev. C 90 , 045804 (2014)]
DOI: ©2015 American Physical Society
- 1 January 2015
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 10 (1) , C01043
Performance of timing Resistive Plate Chambers with protons from 200 to 800 MeV
A prototype composed of four resistive plate chamber layers has been exposed to quasi-monoenergetic protons produced from a deuteron beam of varying energy (200 to 800 AMeV) in experiment S406 at GSI, Darmstadt, Germany. The aim of the experiment is to characterize the response of the prototype to protons in this energy range, which deposit from 1.75 to 6 times more energy than minimum ionizing particles. Each layer, with an active area of about 2000 × 500 mm2, is made of modules containing the active gaps, all in multigap construction. Each gap is defined by 0.3 mm nylon mono-filaments positioned between 2.85 mm thick float glass electrodes. The modules are operated in avalanche mode with a non-flammable gas mixture composed of 90% C2H2F4 and 10% SF6. The signals are readout by a pick-up electrode formed by 15 copper strips (per layer), spaced at a pitch of 30 mm, connected at both sides to timing front end electronics. Results show an uniform efficiency close to 100% along with a timing resolution of around 60 ps on the entire 2000 × 500 mm2 area.
- 1 January 2015
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 10 (1) , C01043
Performance of timing Resistive Plate Chambers with protons from 200 to 800 MeV
A prototype composed of four resistive plate chamber layers has been exposed to quasi-monoenergetic protons produced from a deuteron beam of varying energy (200 to 800 AMeV) in experiment S406 at GSI, Darmstadt, Germany. The aim of the experiment is to characterize the response of the prototype to protons in this energy range, which deposit from 1.75 to 6 times more energy than minimum ionizing particles. Each layer, with an active area of about 2000 × 500 mm2, is made of modules containing the active gaps, all in multigap construction. Each gap is defined by 0.3 mm nylon mono-filaments positioned between 2.85 mm thick float glass electrodes. The modules are operated in avalanche mode with a non-flammable gas mixture composed of 90% C2H2F4 and 10% SF6. The signals are readout by a pick-up electrode formed by 15 copper strips (per layer), spaced at a pitch of 30 mm, connected at both sides to timing front end electronics. Results show an uniform efficiency close to 100% along with a timing resolution of around 60 ps on the entire 2000 × 500 mm2 area.
- Open Access
- 20 March 2014
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 66, 07016
The nucleosynthesis of heavy elements in Stars: the key isotope25Mg
We have measured the radiative neutron-capture cross section and the total neutron-induced cross section of one of the most important isotopes for the s process, the 25Mg. The measurements have been carried out at the neutron time-of-flight facilities n_TOF at CERN (Switzerland) and GELINA installed at the EC-JRC-IRMM (Belgium). The cross sections as a function of neutron energy have been measured up to approximately 300 keV, covering the energy region of interest to the s process. The data analysis is ongoing and preliminary results show the potential relevance for the s process.
- 20 March 2014
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 66, 07016
Open AccessThe nucleosynthesis of heavy elements in Stars: the key isotope25Mg
We have measured the radiative neutron-capture cross section and the total neutron-induced cross section of one of the most important isotopes for the s process, the 25Mg. The measurements have been carried out at the neutron time-of-flight facilities n_TOF at CERN (Switzerland) and GELINA installed at the EC-JRC-IRMM (Belgium). The cross sections as a function of neutron energy have been measured up to approximately 300 keV, covering the energy region of interest to the s process. The data analysis is ongoing and preliminary results show the potential relevance for the s process.
- 29 May 2012
- Published by American Physical Society (APS) in Physical Review C
- Vol. 85 (5)
Definition of a standard neutron field with theLi()Be reactionThe quasistellar neutron spectrum for a thermal energy of kT=25 keV that can be produced via the 7Li(p,n)7Be reaction at a proton energy of Ep=1912 keV has been measured using the dedicated setup for the definition of neutron fields at Physikalisch-Technische Bundesanstalt Braunschweig. The results confirm previous work with improved accuracy and resolution. Small variations in proton energy leave the spectrum essentially unchanged. This is illustrated by the example of the (n,$\gamma${}) cross section of 197Au, where the averaged cross section for the spectrum defined in this work agrees perfectly with the result of a previous measurement.
- 29 May 2012
- Published by American Physical Society (APS) in Physical Review C
- Vol. 85 (5)
Definition of a standard neutron field with theLi()Be reactionThe quasistellar neutron spectrum for a thermal energy of kT=25 keV that can be produced via the 7Li(p,n)7Be reaction at a proton energy of Ep=1912 keV has been measured using the dedicated setup for the definition of neutron fields at Physikalisch-Technische Bundesanstalt Braunschweig. The results confirm previous work with improved accuracy and resolution. Small variations in proton energy leave the spectrum essentially unchanged. This is illustrated by the example of the (n,$\gamma${}) cross section of 197Au, where the averaged cross section for the spectrum defined in this work agrees perfectly with the result of a previous measurement.
- 14 June 2011
- Published by AIP Publishing
- Vol. 1336 (1) , 547
The Neutron Time-Of-Flight Facility ṉTOF At CERN: Phase II
Neutron‐induced reactions are studied at the neutron time‐of‐flight facility n_TOF at CERN. The facility uses 6∼ns wide pulses of 20 GeV/c protons impinging on a lead spallation target. The large neutron energy range and the high instantaneous neutron flux combined with high resolution are among the key characteristics of the facility. After a first phase of data taking during the period 2001–2004, the facility has been refurbished with an upgraded spallation target and cooling system for a second phase of data taking which started in 2009. Since 2010, the experimental area at 185 m where the neutronbeam arrives, has been modified into a worksector of type A, allowing the extension of the physics program to include neutron‐induced reactions on radioactive isotopes.
- 14 June 2011
- Published by AIP Publishing
- Vol. 1336 (1) , 547
The Neutron Time-Of-Flight Facility ṉTOF At CERN: Phase II
Neutron‐induced reactions are studied at the neutron time‐of‐flight facility n_TOF at CERN. The facility uses 6∼ns wide pulses of 20 GeV/c protons impinging on a lead spallation target. The large neutron energy range and the high instantaneous neutron flux combined with high resolution are among the key characteristics of the facility. After a first phase of data taking during the period 2001–2004, the facility has been refurbished with an upgraded spallation target and cooling system for a second phase of data taking which started in 2009. Since 2010, the experimental area at 185 m where the neutronbeam arrives, has been modified into a worksector of type A, allowing the extension of the physics program to include neutron‐induced reactions on radioactive isotopes.