Farinazleen Mohamad. Ghazali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Farinazleen Mohamad. Ghazali has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Hasanah Mohd Ghazali
Universiti Putra Malaysia
3 shared publications S. Jinap
Center of Excellence for Food Safety Research (CEFSR), Faculty of Food Science and Technology, Universiti Putra Malaysia, 43400 Serdang, Selangor Darul Ehsan Malaysia
2 shared publicationsSon Radu
2 shared publicationsWael Mousa
Center of Excellence for Food Safety Research (CEFSR), University Putra Malaysia, 43400 Serdang, Selangor Darul Ehsan, Malaysia
2 shared publicationsS. Radu
Centre of Excellence for Food Safety Research (CEFSR), Faculty of Food Science and Technology, University Putra Malaysia, Serdang, Selangor Darul Ehsan, Malaysia
1 shared publicationSelamat Jinap
1 shared publication
Latest Publications
- 9 January 2013
- Published by Wiley in Journal of Food Science
- Vol. 78 (1) , M56-M63
Modeling Growth Rate and Assessing Aflatoxins Production by Aspergillus flavus as a Function of Water Activity and Temperature on Polished and Brown Rice
Abstract: The aim of this study was to model the radial growth rate and to assess aflatoxin production by Aspergillus flavus as a function of water activity ( a w 0.82 to 0.92) and temperature (12 to 42 °C) on polished and brown rice. The growth of the fungi, expressed as colony diameter (mm) was measured daily, and the aflatoxins were analyzed using HPLC with a fluorescence detector. The growth rates were estimated using the primary model of Baranyi, which describes the change in colony radius as a function of time. Total of 2 secondary models were used to describe the combined effects of a w and temperature on the growth rates. The models were validated using independent experimental data. Linear Arrhenius–Davey model proved to be the best predictor of A. flavus growth rates on polished and brown rice followed by polynomial model. The estimated optimal growth temperature was around 30 °C. A. flavus growth and aflatoxins were not detected at 0.82 a w on polished rice while growth and aflatoxins were detected at this a w between 25 and 35 °C on brown rice. The highest amounts of toxins were formed at the highest a w values (0.90 to 0.92) at a temperature of 20 °C after 21 d of incubation on both types of rice. Nevertheless, the consistencies of toxin production within a wider range of a w values occurred between 25 to 30 °C. Brown rice seems to support A. flavus growth and aflatoxin production more than the polished rice. Practical Application: The developed models can be used to estimate to what extent the change in grain ecosystem conditions affect the storage stability and safety of grains without the need for running long‐standing storage study. By monitoring the intergranular relative humidity and temperature at different locations in the storage facility and inputting these data into the models, it is directly possible to assess either the conditions are conductive for the growth of A. flavus or aflatoxin production.
- 9 January 2013
- Published by Wiley in Journal of Food Science
- Vol. 78 (1) , M56-M63
Modeling Growth Rate and Assessing Aflatoxins Production by Aspergillus flavus as a Function of Water Activity and Temperature on Polished and Brown Rice
Abstract: The aim of this study was to model the radial growth rate and to assess aflatoxin production by Aspergillus flavus as a function of water activity ( a w 0.82 to 0.92) and temperature (12 to 42 °C) on polished and brown rice. The growth of the fungi, expressed as colony diameter (mm) was measured daily, and the aflatoxins were analyzed using HPLC with a fluorescence detector. The growth rates were estimated using the primary model of Baranyi, which describes the change in colony radius as a function of time. Total of 2 secondary models were used to describe the combined effects of a w and temperature on the growth rates. The models were validated using independent experimental data. Linear Arrhenius–Davey model proved to be the best predictor of A. flavus growth rates on polished and brown rice followed by polynomial model. The estimated optimal growth temperature was around 30 °C. A. flavus growth and aflatoxins were not detected at 0.82 a w on polished rice while growth and aflatoxins were detected at this a w between 25 and 35 °C on brown rice. The highest amounts of toxins were formed at the highest a w values (0.90 to 0.92) at a temperature of 20 °C after 21 d of incubation on both types of rice. Nevertheless, the consistencies of toxin production within a wider range of a w values occurred between 25 to 30 °C. Brown rice seems to support A. flavus growth and aflatoxin production more than the polished rice. Practical Application: The developed models can be used to estimate to what extent the change in grain ecosystem conditions affect the storage stability and safety of grains without the need for running long‐standing storage study. By monitoring the intergranular relative humidity and temperature at different locations in the storage facility and inputting these data into the models, it is directly possible to assess either the conditions are conductive for the growth of A. flavus or aflatoxin production.
- 1 September 2012
- Published by Springer Nature in Journal of Food Science and Technology
- Vol. 51 (10) , 2656-2663
Sorption isotherms and isosteric heats of sorption of Malaysian paddy
Understanding the water sorption characteristics of cereal is extremely essential for optimizing the drying process and ensuring storage stability. Water relation of rough rice was studied at 20, 30, 40 and 50 °C over relative humidity (RH.) between 0.113 and 0.976 using the gravimetric technique. The isotherms displayed the general sigmoid, Type II pattern and exhibited the phenomenon of hysteresis where it was more pronounced at lower temperatures. The sorption characteristics were temperature dependence where the sorption capacity of the paddy increased as the temperature was decreased at fixed (RH). Among the models assessed for their ability to fit the sorption data, Oswin equation was the best followed by the third order polynomial, GAB, Smith, Chung-Pfost, and Henderson models. The monolayer moisture content was higher for desorption than adsorption and tend to decrease with the increase in temperature. Given the temperature dependence of the sorption isotherms the isosteric heats of sorption were calculated using Claussius-Clapeyron equation. The net isosteric heats decreased as the moisture content was increased and heats of desorption were greater than that of adsorption.
- 1 September 2012
- Published by Springer Nature in Journal of Food Science and Technology
- Vol. 51 (10) , 2656-2663
Sorption isotherms and isosteric heats of sorption of Malaysian paddy
Understanding the water sorption characteristics of cereal is extremely essential for optimizing the drying process and ensuring storage stability. Water relation of rough rice was studied at 20, 30, 40 and 50 °C over relative humidity (RH.) between 0.113 and 0.976 using the gravimetric technique. The isotherms displayed the general sigmoid, Type II pattern and exhibited the phenomenon of hysteresis where it was more pronounced at lower temperatures. The sorption characteristics were temperature dependence where the sorption capacity of the paddy increased as the temperature was decreased at fixed (RH). Among the models assessed for their ability to fit the sorption data, Oswin equation was the best followed by the third order polynomial, GAB, Smith, Chung-Pfost, and Henderson models. The monolayer moisture content was higher for desorption than adsorption and tend to decrease with the increase in temperature. Given the temperature dependence of the sorption isotherms the isosteric heats of sorption were calculated using Claussius-Clapeyron equation. The net isosteric heats decreased as the moisture content was increased and heats of desorption were greater than that of adsorption.
- Open Access
- 24 August 2011
- Published by Oxford University Press (OUP) in Journal of Applied Microbiology
- Vol. 111 (5) , 1262-1274
Modelling the effect of water activity and temperature on growth rate and aflatoxin production by two isolates of Aspergillus flavus on paddy
Aims: This study was conducted to characterize the growth of and aflatoxin production by Aspergillus flavus on paddy and to develop kinetic models describing the growth rate as a function of water activity (aw) and temperature. Methods and Results: The growth of A. flavus on paddy and aflatoxin production were studied following a full factorial design with seven aw levels within the range of 0·82–0·99 and seven temperatures between 10 and 43°C. The growth of the fungi, expressed as colony diameter (mm), was measured daily, and the aflatoxins were analysed using HPLC with a fluorescence detector. The maximum colony growth rates of both isolates were estimated by fitting the primary model of Baranyi to growth data. Three potentially suitable secondary models, Rosso, polynomial and Davey, were assessed for their ability to describe the radial growth rate as a function of temperature and aw. Both strains failed to grow at the marginal temperatures (10 and 43°C), regardless of the aw studied, and at the aw level of 0·82, regardless of temperature. Despite that the predictions of all studied models showed good agreement with the observed growth rates, Davey model proved to be the best predictor of the experimental data. The cardinal parameters as estimated by Rosso model were comparable to those reported in previous studies. Toxins were detected in the range of 0·86–0·99 aw with optimal aw of 0·98 and optimal temperature in the range of 25–30°C. Conclusions: The influences of aw and temperature on the growth of A. flavus and aflatoxin production were successfully characterized, and the models developed were found to be capable of providing good, related estimates of the growth rates. Significance and Impact of the Study: The results of this study could be effectively implemented in minimizing the risk of aflatoxin contamination of the paddy at postharvest.
- 24 August 2011
- Published by Oxford University Press (OUP) in Journal of Applied Microbiology
- Vol. 111 (5) , 1262-1274
Open AccessModelling the effect of water activity and temperature on growth rate and aflatoxin production by two isolates of Aspergillus flavus on paddy
Aims: This study was conducted to characterize the growth of and aflatoxin production by Aspergillus flavus on paddy and to develop kinetic models describing the growth rate as a function of water activity (aw) and temperature. Methods and Results: The growth of A. flavus on paddy and aflatoxin production were studied following a full factorial design with seven aw levels within the range of 0·82–0·99 and seven temperatures between 10 and 43°C. The growth of the fungi, expressed as colony diameter (mm), was measured daily, and the aflatoxins were analysed using HPLC with a fluorescence detector. The maximum colony growth rates of both isolates were estimated by fitting the primary model of Baranyi to growth data. Three potentially suitable secondary models, Rosso, polynomial and Davey, were assessed for their ability to describe the radial growth rate as a function of temperature and aw. Both strains failed to grow at the marginal temperatures (10 and 43°C), regardless of the aw studied, and at the aw level of 0·82, regardless of temperature. Despite that the predictions of all studied models showed good agreement with the observed growth rates, Davey model proved to be the best predictor of the experimental data. The cardinal parameters as estimated by Rosso model were comparable to those reported in previous studies. Toxins were detected in the range of 0·86–0·99 aw with optimal aw of 0·98 and optimal temperature in the range of 25–30°C. Conclusions: The influences of aw and temperature on the growth of A. flavus and aflatoxin production were successfully characterized, and the models developed were found to be capable of providing good, related estimates of the growth rates. Significance and Impact of the Study: The results of this study could be effectively implemented in minimizing the risk of aflatoxin contamination of the paddy at postharvest.