Zurina Osman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zurina Osman has a total of 102 co-authors. Here are the top co-authors by number of shared publications:
D. Hambali
Centre for Ionics Universiti Malaya, Universiti Malaya, Kuala Lumpur, Malaysia
8 shared publicationsL. Othman
Centre for Ionics Universiti Malaya, Universiti Malaya, Kuala Lumpur, Malaysia
8 shared publicationsN. Harudin
Centre for Ionics Universiti Malaya, Universiti Malaya, Kuala Lumpur, Malaysia
6 shared publications- Markus Diantoro
Department of Physics Faculty of Mathematics and Natural Sciences Universitas Negeri Malang Malang Indonesia
4 shared publications N. H. Zainol
University of Malaya
4 shared publicationsR. Rosli
Centre for Ionics Universiti Malaya, Universiti Malaya, Kuala Lumpur, Malaysia
4 shared publications
Latest Publications
- 16 November 2026
- Published by Elsevier in Physica B: Condensed Matter
Synergistic Supercapacitor and Antimicrobial Performance Via Green Nanocomposite Engineering
- 16 November 2026
- Published by Elsevier in Physica B: Condensed Matter
Synergistic Supercapacitor and Antimicrobial Performance Via Green Nanocomposite Engineering
- 13 October 2026
- Published by Wiley in Macromolecular Symposia
- p. e70499
Engineering of D205 Dye Concentration and Incorporation of Plasmonic Silver Nanoparticles in ZnO Nanorods for Enhanced Solar Energy Conversion
Dye concentration engineering and the incorporation of plasmonic silver nanoparticles (AgNPs) improved the performance of dye‐sensitized solar cells (DSSCs) based on ZnO nanorods (ZnONRs). ZnONRs were synthesized using a low‐temperature hydrothermal method and sensitized with the organic dye D205 at concentrations ranging from 0.4 to 1.6 mM. Structural analysis revealed the formation of highly crystalline hexagonal wurtzite ZnONRs with an average crystallite size of 57 nm and rod diameter of 587 nm. Photovoltaic measurements revealed that a 1 mM concentration of D205 resulted in the highest power conversion efficiency (PCE) of 1.48%, as well as a reduced optical bandgap of 2.08 eV. The incorporation of 15 wt.% AgNPs at the optimized dye concentration increased the PCE to 1.57% while decreasing the bandgap to 2.07 eV, owing to improved light harvesting via localized surface plasmon resonance. The synergistic effect of optimized dye loading and plasmonic enhancement demonstrates an effective strategy for improving charge generation and photovoltaic performance in DSSCs based on ZnONRs.
- 13 October 2026
- Published by Wiley in Macromolecular Symposia
- p. e70499
Engineering of D205 Dye Concentration and Incorporation of Plasmonic Silver Nanoparticles in ZnO Nanorods for Enhanced Solar Energy Conversion
Dye concentration engineering and the incorporation of plasmonic silver nanoparticles (AgNPs) improved the performance of dye‐sensitized solar cells (DSSCs) based on ZnO nanorods (ZnONRs). ZnONRs were synthesized using a low‐temperature hydrothermal method and sensitized with the organic dye D205 at concentrations ranging from 0.4 to 1.6 mM. Structural analysis revealed the formation of highly crystalline hexagonal wurtzite ZnONRs with an average crystallite size of 57 nm and rod diameter of 587 nm. Photovoltaic measurements revealed that a 1 mM concentration of D205 resulted in the highest power conversion efficiency (PCE) of 1.48%, as well as a reduced optical bandgap of 2.08 eV. The incorporation of 15 wt.% AgNPs at the optimized dye concentration increased the PCE to 1.57% while decreasing the bandgap to 2.07 eV, owing to improved light harvesting via localized surface plasmon resonance. The synergistic effect of optimized dye loading and plasmonic enhancement demonstrates an effective strategy for improving charge generation and photovoltaic performance in DSSCs based on ZnONRs.
- Open Access
- 16 April 2026
- Published by Elsevier in SSRN Electronic Journal
Al-doped V2O5 cathode material for high performance Aluminum-ion batteries
Aluminum-ion batteries (AIBs) are promising alternatives to lithium-ion batteries due to the abundance, low cost, and high theoretical capacity of aluminum. However, their performance is largely limited by the availability of suitable cathode materials capable of accommodating multivalent Al3+ ions. In this study, Al-doped V2O5 (AlxV2-xO5) was investigated as a cathode material to improve the structural and electrochemical properties of V2O5 for AIB applications. X-ray diffraction (XRD) confirms that both undoped and Al-doped samples exhibit a single-phase orthorhombic structure (JCPDS No. 00-041-1426). The XRD shows a reduction in crystallite size upon Al doping. FESEM analysis shows thinner nanosheet morphology, with the 0.04 Al-doped sample exhibiting a thickness of approximately 15 nm. BET results indicate larger pore sizes in the Al-doped samples compared to the undoped V2O5. Among the compositions studied, the 0.04 Al-doped V2O5 demonstrates the optimum structural properties and superior electrochemical performance, delivering a discharge capacity of 113 mAh g-1 compared to 46 mAh g-1 for the undoped sample. These results highlight the effectiveness of Al doping in enhancing V2O5 cathode performance for AIBs.
- 16 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessAl-doped V2O5 cathode material for high performance Aluminum-ion batteries
Aluminum-ion batteries (AIBs) are promising alternatives to lithium-ion batteries due to the abundance, low cost, and high theoretical capacity of aluminum. However, their performance is largely limited by the availability of suitable cathode materials capable of accommodating multivalent Al3+ ions. In this study, Al-doped V2O5 (AlxV2-xO5) was investigated as a cathode material to improve the structural and electrochemical properties of V2O5 for AIB applications. X-ray diffraction (XRD) confirms that both undoped and Al-doped samples exhibit a single-phase orthorhombic structure (JCPDS No. 00-041-1426). The XRD shows a reduction in crystallite size upon Al doping. FESEM analysis shows thinner nanosheet morphology, with the 0.04 Al-doped sample exhibiting a thickness of approximately 15 nm. BET results indicate larger pore sizes in the Al-doped samples compared to the undoped V2O5. Among the compositions studied, the 0.04 Al-doped V2O5 demonstrates the optimum structural properties and superior electrochemical performance, delivering a discharge capacity of 113 mAh g-1 compared to 46 mAh g-1 for the undoped sample. These results highlight the effectiveness of Al doping in enhancing V2O5 cathode performance for AIBs.
- Open Access
- 20 March 2026
- Published by Elsevier in SSRN Electronic Journal
D-Limonene-Modified Gel Polymer Electrolytes for Enhanced Performance of Quasi-Solid Dye-Sensitized Solar Cells
Gel Polymer Electrolyte (GPE), are used in the development of dye-based solar cells known as QS-DSSCs. In this study, a PVA/DMSO/Mosalyte-based GPE was used to fabricate QS-DSSCs, with D-limonene (orange extract) as an additive. The D-limonene additive was added to increase the free space in the polyvinyl alcohol (PVA) polymer, its constituent. The D-limonene additive concentrations used in this study were 0, 1, 2, 3, 4, and 5 wt%. The Fourier Transform Infrared (FTIR) test results showed that the addition of the D-limonene additive changed the GPE structure, as indicated by a decrease in the intensity of the –OH band intensity, indicating a weakening of hydrogen bonding interactions between PVA molecules, and an increase in the C=C stretching band, indicating the characteristic band of I3− ions from mosalyte appearing around 691 cm−1. The addition of the D-limonene additive also increased the ionic conductivity of GPE by S cm−1. The increase in ionic conductivity also improved the performance of the QS-DSSC in the 5 wt% sample, with an efficiency of up to 8.49% and Voc, Jsc, and FF of 0.72 V, 21.8 mA/cm2, and 54%, respectively. Additionally, the stability of use with the D-limonene additive tends to be higher, with only a 5.7% decrease in light conversion efficiency at H+30 from 8.49% to 8.00%. Furthermore, the diffusion resistance and electrolyte interface with TiO2 in this sample had the lowest values of 4.82 Ω and 10.86 Ω, with an electron lifetime of 5.20 ms.
- 20 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessD-Limonene-Modified Gel Polymer Electrolytes for Enhanced Performance of Quasi-Solid Dye-Sensitized Solar Cells
Gel Polymer Electrolyte (GPE), are used in the development of dye-based solar cells known as QS-DSSCs. In this study, a PVA/DMSO/Mosalyte-based GPE was used to fabricate QS-DSSCs, with D-limonene (orange extract) as an additive. The D-limonene additive was added to increase the free space in the polyvinyl alcohol (PVA) polymer, its constituent. The D-limonene additive concentrations used in this study were 0, 1, 2, 3, 4, and 5 wt%. The Fourier Transform Infrared (FTIR) test results showed that the addition of the D-limonene additive changed the GPE structure, as indicated by a decrease in the intensity of the –OH band intensity, indicating a weakening of hydrogen bonding interactions between PVA molecules, and an increase in the C=C stretching band, indicating the characteristic band of I3− ions from mosalyte appearing around 691 cm−1. The addition of the D-limonene additive also increased the ionic conductivity of GPE by S cm−1. The increase in ionic conductivity also improved the performance of the QS-DSSC in the 5 wt% sample, with an efficiency of up to 8.49% and Voc, Jsc, and FF of 0.72 V, 21.8 mA/cm2, and 54%, respectively. Additionally, the stability of use with the D-limonene additive tends to be higher, with only a 5.7% decrease in light conversion efficiency at H+30 from 8.49% to 8.00%. Furthermore, the diffusion resistance and electrolyte interface with TiO2 in this sample had the lowest values of 4.82 Ω and 10.86 Ω, with an electron lifetime of 5.20 ms.
- Open Access
- 18 June 2025
- Published by Elsevier in Transactions of Materials Research
- Vol. 1 (4)
Differential voltage analysis for rapid and sensitive rate capability evaluation of graphite anodes
- 18 June 2025
- Published by Elsevier in Transactions of Materials Research
- Vol. 1 (4)
Open AccessDifferential voltage analysis for rapid and sensitive rate capability evaluation of graphite anodes
- Open Access
- 20 February 2025
- Published by Elsevier in Results in Surfaces and Interfaces
- Vol. 18
The effect of RF sputtering power variation on blocking layer TiO2 on the performance of DSSC
- 20 February 2025
- Published by Elsevier in Results in Surfaces and Interfaces
- Vol. 18
Open AccessThe effect of RF sputtering power variation on blocking layer TiO2 on the performance of DSSC
- 1 November 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 625
Understanding the regulation of sulfur on surface-dominated hard carbon anode for sodium ion batteries
- 1 November 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 625
Understanding the regulation of sulfur on surface-dominated hard carbon anode for sodium ion batteries
- 2 September 2024
- Published by Springer Nature in Ionics
- Vol. 30 (11) , 6879-6892
Influence of ethylene sulfite in lithium bis(trifluoromethane)sulfonimide-based electrolyte for dual carbon battery
- 2 September 2024
- Published by Springer Nature in Ionics
- Vol. 30 (11) , 6879-6892
Influence of ethylene sulfite in lithium bis(trifluoromethane)sulfonimide-based electrolyte for dual carbon battery