Andreas Vetter
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Andreas Vetter has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Bernhard Hofbeck
Bavarian Center for Applied Energy Research (ZAE Bayern) Energie Campus Nürnberg Fürther Str. 250 90429 Nürnberg Germany
1 shared publicationChristoph J. Brabec
Institute of Materials for Electronics and Energy (I‐Meet) Friedrich Alexander University Erlangen‐Nuremberg Martensstraße 7 91058 Erlangen Germany
1 shared publication- Christoph Joseph Brabec
Institute of Materials for Electronics and Energy Technology (i‐MEET) Department of Materials Science and Engineering Friedrich‐Alexander‐Universität Erlangen‐Nürnberg Erlangen Germany
1 shared publication Claudia Buerhop
Bavarian Center for Applied Energy Research (ZAE Bayern) Haberstr. 2a 91058 Erlangen Germany
1 shared publication- Finn Babbe
Chemical Sciences Division, Lawrence Berkeley National Laboratory, Berkeley, USA
1 shared publication Frank Fecher
Bavarian Center for Applied Energy Research (ZAE Bayern) Haberstr. 2a 91058 Erlangen Germany
1 shared publication
Latest Publications
- 5 February 2016
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 24 (7) , 1001-1008
Visualizing the performance loss of solar cells by IR thermography — an evaluation study on CIGS with artificially induced defects
- 5 February 2016
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 24 (7) , 1001-1008
Visualizing the performance loss of solar cells by IR thermography — an evaluation study on CIGS with artificially induced defects
- Open Access
- 2 April 2013
- Published by Wiley in Energy Science & Engineering
- Vol. 1 (1) , 12-17
Lock‐in thermography as a tool for quality control of photovoltaic modules
In this short communication, we present a method which utilizes contactless ILIT (illuminated lock‐in thermography) measurement of a photovoltaic (PV) module and image postprocessing in order to calculate the peak power Pmpp of the module and to study the influence of local defects on the module performance. In total, 103 Copper‐Indium‐Gallium‐Diselenide (CIGS) modules were investigated and the results showed a good correlation (mean error less than 6%) between the calculated IR‐signal and the measured Pmpp. We performed our study on CIGS modules but the presented approach is not restricted to CIGS modules. The method provides a valuable tool for PV quality control.
- 2 April 2013
- Published by Wiley in Energy Science & Engineering
- Vol. 1 (1) , 12-17
Open AccessLock‐in thermography as a tool for quality control of photovoltaic modules
In this short communication, we present a method which utilizes contactless ILIT (illuminated lock‐in thermography) measurement of a photovoltaic (PV) module and image postprocessing in order to calculate the peak power Pmpp of the module and to study the influence of local defects on the module performance. In total, 103 Copper‐Indium‐Gallium‐Diselenide (CIGS) modules were investigated and the results showed a good correlation (mean error less than 6%) between the calculated IR‐signal and the measured Pmpp. We performed our study on CIGS modules but the presented approach is not restricted to CIGS modules. The method provides a valuable tool for PV quality control.