Johan C. Winterwerp
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Johan C. Winterwerp has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Dirk Sebastiaan van Maren
Ecosystems and Sediment Dynamics, Deltares, Delft, The Netherlands
3 shared publications - Ad J. H. M. Reniers
Civil Engineering and Geosciences Delft University of Technology Delft The Netherlands
1 shared publication - Andreas Schöl
Bundesanstalt für Gewässerkunde , Am Mainzer Tor 1, 56068, Koblenz , Germany
1 shared publication - Bram Christiaan van Prooijen
Department of Hydraulic Engineering Delft University of Technology Delft The Netherlands
1 shared publication - Christine Borgsmüller
Department of Quantitative Hydrology, Federal Institute of Hydrology, Koblenz, Germany
1 shared publication - Erik C.M. Hendriks
Delft Univ Technol, Fac Civil Engn & Geosci, Dept Hydraul Engn, Delft, Netherlands
1 shared publication
Latest Publications
- Open Access
- 12 November 2020
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 8 (11) , 910
The Impact of Wind on Flow and Sediment Transport over Intertidal Flats
Sediment transport over intertidal flats is driven by a combination of waves, tides, and wind-driven flow. In this study we aimed at identifying and quantifying the interactions between these processes. A five week long dataset consisting of flow velocities, waves, water depths, suspended sediment concentrations, and bed level changes was collected at two locations across a tidal flat in the Wadden Sea (The Netherlands). A momentum balance was evaluated, based on field data, for windy and non-windy conditions. The results show that wind speed and direction have large impacts on the net flow, and that even moderate wind can reverse the tidal flow. A simple analytical tide–wind interaction model shows that the wind-induced reversal can be predicted as a function of tidal flow amplitude and wind forcing. Asymmetries in sediment transport are not only related to the tide–wind interaction, but also to the intratidal asymmetries in sediment concentration. These asymmetries are influenced by wind-induced circulation interacting with the large scale topography. An analysis of the shear stresses induced by waves and currents revealed the relative contributions of local processes (resuspension) and large-scale processes (advection) at different tidal flat elevations.
- 12 November 2020
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 8 (11) , 910
Open AccessThe Impact of Wind on Flow and Sediment Transport over Intertidal Flats
Sediment transport over intertidal flats is driven by a combination of waves, tides, and wind-driven flow. In this study we aimed at identifying and quantifying the interactions between these processes. A five week long dataset consisting of flow velocities, waves, water depths, suspended sediment concentrations, and bed level changes was collected at two locations across a tidal flat in the Wadden Sea (The Netherlands). A momentum balance was evaluated, based on field data, for windy and non-windy conditions. The results show that wind speed and direction have large impacts on the net flow, and that even moderate wind can reverse the tidal flow. A simple analytical tide–wind interaction model shows that the wind-induced reversal can be predicted as a function of tidal flow amplitude and wind forcing. Asymmetries in sediment transport are not only related to the tide–wind interaction, but also to the intratidal asymmetries in sediment concentration. These asymmetries are influenced by wind-induced circulation interacting with the large scale topography. An analysis of the shear stresses induced by waves and currents revealed the relative contributions of local processes (resuspension) and large-scale processes (advection) at different tidal flat elevations.
- 1 August 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 144 (8)
Efficient Consolidation Model for Morphodynamic Simulations in Low-SPM Environments
This paper presents a new model, using existing consolidation theory, suitable for long-term morphodynamic simulations; we refer to the dynamic equilibrium consolidation (DECON) model. This model is applicable for muddy systems at small suspended particulate matter (SPM) concentrations, where the sedimentation rates are smaller than the consolidation rates and small fractions of sand can be accounted for. Thus, the model assumes quasi-equilibrium of the consolidating bed. It is derived from the full consolidation (Gibson) equation and is implemented in a mixed Lagrangian-Eulerian bed model guaranteeing stable and non-negative solutions, while numeric diffusion remains small. The erosion and deposition of sand and mud is accounted for, whereas internal mixing (e.g., bioturbation) is modeled through diffusion. The parameter settings for the new consolidation model (the hydraulic conductivity, consolidation coefficient, and strength) can be obtained from consolidation experiments in the laboratory. The model reproduces one-dimensional consolidation experiments and the qualitative behavior of erosion and deposition in a tidal flume. The DECON model was also applied to more natural conditions, simulating fine sediment dynamics on a schematized mud flat and in a schematized tidal basin under tide and wave forcing. The computational results of the mudflat simulations compared well with the simulations with the full Gibson equation. For the tidal basin simulations, DECON predicted the expected landward tidal transport of fine sediment during tide-dominated conditions, while the tidal basin withstood erosion during the more energetic wave-dominated periods. Computational times for the morphodynamic simulations of the tidal basin example without waves increased by a factor of 5 when consolidation was included. For the simulations with waves, this increase in computational times was only a factor of 2, as simulations with waves are always expensive. Applying a complete consolidation model would be prohibitive. The DECON model therefore serves as a useful tool to simulate fine-sediment dynamics in complex wave- and tide-dominated conditions, as well as the effects of seasonal variations.
- 1 August 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 144 (8)
Efficient Consolidation Model for Morphodynamic Simulations in Low-SPM Environments
This paper presents a new model, using existing consolidation theory, suitable for long-term morphodynamic simulations; we refer to the dynamic equilibrium consolidation (DECON) model. This model is applicable for muddy systems at small suspended particulate matter (SPM) concentrations, where the sedimentation rates are smaller than the consolidation rates and small fractions of sand can be accounted for. Thus, the model assumes quasi-equilibrium of the consolidating bed. It is derived from the full consolidation (Gibson) equation and is implemented in a mixed Lagrangian-Eulerian bed model guaranteeing stable and non-negative solutions, while numeric diffusion remains small. The erosion and deposition of sand and mud is accounted for, whereas internal mixing (e.g., bioturbation) is modeled through diffusion. The parameter settings for the new consolidation model (the hydraulic conductivity, consolidation coefficient, and strength) can be obtained from consolidation experiments in the laboratory. The model reproduces one-dimensional consolidation experiments and the qualitative behavior of erosion and deposition in a tidal flume. The DECON model was also applied to more natural conditions, simulating fine sediment dynamics on a schematized mud flat and in a schematized tidal basin under tide and wave forcing. The computational results of the mudflat simulations compared well with the simulations with the full Gibson equation. For the tidal basin simulations, DECON predicted the expected landward tidal transport of fine sediment during tide-dominated conditions, while the tidal basin withstood erosion during the more energetic wave-dominated periods. Computational times for the morphodynamic simulations of the tidal basin example without waves increased by a factor of 5 when consolidation was included. For the simulations with waves, this increase in computational times was only a factor of 2, as simulations with waves are always expensive. Applying a complete consolidation model would be prohibitive. The DECON model therefore serves as a useful tool to simulate fine-sediment dynamics in complex wave- and tide-dominated conditions, as well as the effects of seasonal variations.
- Open Access
- 28 March 2017
- Published by Springer Nature in Ocean Dynamics
- Vol. 67 (5) , 559-583
SPM response to tide and river flow in the hyper-turbid Ems River
- 28 March 2017
- Published by Springer Nature in Ocean Dynamics
- Vol. 67 (5) , 559-583
Open AccessSPM response to tide and river flow in the hyper-turbid Ems River
- 29 March 2013
- Published by Springer Nature in Wetlands
- Vol. 33 (3) , 515-526
Defining Eco-Morphodynamic Requirements for Rehabilitating Eroding Mangrove-Mud Coasts
- 29 March 2013
- Published by Springer Nature in Wetlands
- Vol. 33 (3) , 515-526
Defining Eco-Morphodynamic Requirements for Rehabilitating Eroding Mangrove-Mud Coasts
- 9 September 2010
- Published by Springer Nature in Ocean Dynamics
- Vol. 61 (2-3) , 203-215
Fine sediment transport by tidal asymmetry in the high-concentrated Ems River: indications for a regime shift in response to channel deepening
- 9 September 2010
- Published by Springer Nature in Ocean Dynamics
- Vol. 61 (2-3) , 203-215
Fine sediment transport by tidal asymmetry in the high-concentrated Ems River: indications for a regime shift in response to channel deepening