Anders Elverhøi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Anders Elverhøi has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
C. B. Harbitz
Norwegian Geotechnical Institute, P.O. Box 3930 Ullevl Stadion, 0806 Oslo, Norway
1 shared publicationCarl B. Harbitz
Norwegian Geotechnical Institute
1 shared publication- Dieter Issler
Norwegian Geotechnical Institute, Natural Hazards Division, Oslo, Norway
1 shared publication F. V. De Blasio
Dept. of Geosciences, University of Oslo, P.O. Box 1047 Blindern, 0316 Oslo, Norway
1 shared publication- Fabio V. DE Blasio
Department of Geosciences, University of Oslo, P.O. Box 1047, Blindern, N-0316 Oslo, Norway
1 shared publication Fabio V. De Blasio
University of Oslo
1 shared publication
Latest Publications
- 1 January 2011
- Published by Society for Sedimentary Geology
- p. 499-508
Properties of Mass-Transport Deposits as Inferred From Dynamic Modeling of Subaqueous Mass Wasting: A Short Review
We discuss recent attempts to investigate some features of mass-transport deposits (MTDs) from a dynamic and numerical modeling viewpoint. We selected some study examples, such as the problem of the large mobility of submarine mass wasting, emplacement of erratic blocks, and possible change of rheologic properties during flow. Some lubrication mechanisms are needed to explain mobility of submarine slides, and in this respect we discuss hydroplaning and shear wetting models. We show that hydroplaning could explain several features of small, cohesive debris flows such as the Finneidfjord landslide in Norway, and emplacement of outrunner blocks in the Nigerian basin or the Faeroe Islands. However, larger submarine slides usually scour the sea bottom and need a much higher velocity to hydroplane. For this reason, additional mechanisms must be invoked to explain dynamics of the largest submarine slides. In relation to the giant Storegga slide off Norway, we discuss possible effect of the high shear rates due to friction with ambient water on the surface of a submarine slide. This may result in strength loss of sediments and remolding, with consequent increase in mobility. At times, a mobile debris flow may raft huge blocks along its path, providing a further clue as to velocity, impact forces, and block resistance. In this respect, we discuss a couple of examples from the Arctic Sea and the Balearic Basin. We argue that a better understanding of geometry and sedimentologic characteristics of MTDs will require more dedicated studies on submarine slide dynamics in the subaqueous environment. In turn, this should be achieved with an integrated approach between field data, experimental activity, and numerical simulations.
- 1 January 2011
- Published by Society for Sedimentary Geology
- p. 499-508
Properties of Mass-Transport Deposits as Inferred From Dynamic Modeling of Subaqueous Mass Wasting: A Short Review
We discuss recent attempts to investigate some features of mass-transport deposits (MTDs) from a dynamic and numerical modeling viewpoint. We selected some study examples, such as the problem of the large mobility of submarine mass wasting, emplacement of erratic blocks, and possible change of rheologic properties during flow. Some lubrication mechanisms are needed to explain mobility of submarine slides, and in this respect we discuss hydroplaning and shear wetting models. We show that hydroplaning could explain several features of small, cohesive debris flows such as the Finneidfjord landslide in Norway, and emplacement of outrunner blocks in the Nigerian basin or the Faeroe Islands. However, larger submarine slides usually scour the sea bottom and need a much higher velocity to hydroplane. For this reason, additional mechanisms must be invoked to explain dynamics of the largest submarine slides. In relation to the giant Storegga slide off Norway, we discuss possible effect of the high shear rates due to friction with ambient water on the surface of a submarine slide. This may result in strength loss of sediments and remolding, with consequent increase in mobility. At times, a mobile debris flow may raft huge blocks along its path, providing a further clue as to velocity, impact forces, and block resistance. In this respect, we discuss a couple of examples from the Arctic Sea and the Balearic Basin. We argue that a better understanding of geometry and sedimentologic characteristics of MTDs will require more dedicated studies on submarine slide dynamics in the subaqueous environment. In turn, this should be achieved with an integrated approach between field data, experimental activity, and numerical simulations.
- Open Access
- 25 July 2010
- Published by Springer Nature in Ocean Dynamics
- Vol. 60 (4) , 1027-1046
Submarine landslides and the importance of the initial sediment composition for run-out length and final deposit
- 25 July 2010
- Published by Springer Nature in Ocean Dynamics
- Vol. 60 (4) , 1027-1046
Open AccessSubmarine landslides and the importance of the initial sediment composition for run-out length and final deposit
- 16 May 2008
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 27 (1) , 23-42
Statistical Analysis of Landslide Events in Central America and their Run-out Distance
- 16 May 2008
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 27 (1) , 23-42
Statistical Analysis of Landslide Events in Central America and their Run-out Distance
- Open Access
- 17 August 2005
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 5 (5) , 633-648
Emerging insights into the dynamics of submarine debris flows
Recent experimental and theoretical work on the dynamics of submarine debris flows is summarized. Hydroplaning was first discovered in laboratory flows and later shown to likely occur in natural debris flows as well. It is a prime mechanism for explaining the extremely long runout distances observed in some natural debris flows even of over-consolidated clay materials. Moreover, the accelerations and high velocities reached by the flow head in a short time appear to fit well with the required initial conditions of observed tsunamis as obtained from back-calculations. Investigations of high-speed video recordings of laboratory debris flows were combined with measurements of total and pore pressure. The results are pointing towards yet another important role of ambient water: Water that intrudes from the water cushion underneath the hydroplaning head and through cracks in the upper surface of the debris flow may drastically soften initially stiff clayey material in the "neck" of the flow, where significant stretching occurs due to the reduced friction at the bottom of the hydroplaning head. This self-reinforcing process may lead to the head separating from the main body and becoming an "outrunner" block as clearly observed in several natural debris flows. Comparison of laboratory flows with different material composition indicates a gradual transition from hydroplaning plug flows of stiff clay-rich material, with a very low suspension rate, to the strongly agitated flow of sandy materials that develop a pronounced turbidity current. Statistical analysis of the great number of distinguishable lobes in the Storegga slide complex reveals power-law scaling behavior of the runout distance with the release mass over many orders of magnitude. Mathematical flow models based on viscoplastic material behavior (e.g. BING) successfully reproduce the observed scaling behavior only for relatively small clay-rich debris flows while granular (frictional) models fail at all scales. For very large release masses, hydroplaning or significant softening of the shear layer due to water incorporation must be invoked to recover the observed scaling behavior; a combination of both effects likely will give the most realistic description of the phenomenon. Detailed studies of the neck behavior and the compositional dependence of the material properties are needed to arrive at a quantitative model. Other related and important open questions concern the rheological model appropriate for sandy debris flows and the suspension rate from the dense body into the associated turbidity current.
- 17 August 2005
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 5 (5) , 633-648
Open AccessEmerging insights into the dynamics of submarine debris flows
Recent experimental and theoretical work on the dynamics of submarine debris flows is summarized. Hydroplaning was first discovered in laboratory flows and later shown to likely occur in natural debris flows as well. It is a prime mechanism for explaining the extremely long runout distances observed in some natural debris flows even of over-consolidated clay materials. Moreover, the accelerations and high velocities reached by the flow head in a short time appear to fit well with the required initial conditions of observed tsunamis as obtained from back-calculations. Investigations of high-speed video recordings of laboratory debris flows were combined with measurements of total and pore pressure. The results are pointing towards yet another important role of ambient water: Water that intrudes from the water cushion underneath the hydroplaning head and through cracks in the upper surface of the debris flow may drastically soften initially stiff clayey material in the "neck" of the flow, where significant stretching occurs due to the reduced friction at the bottom of the hydroplaning head. This self-reinforcing process may lead to the head separating from the main body and becoming an "outrunner" block as clearly observed in several natural debris flows. Comparison of laboratory flows with different material composition indicates a gradual transition from hydroplaning plug flows of stiff clay-rich material, with a very low suspension rate, to the strongly agitated flow of sandy materials that develop a pronounced turbidity current. Statistical analysis of the great number of distinguishable lobes in the Storegga slide complex reveals power-law scaling behavior of the runout distance with the release mass over many orders of magnitude. Mathematical flow models based on viscoplastic material behavior (e.g. BING) successfully reproduce the observed scaling behavior only for relatively small clay-rich debris flows while granular (frictional) models fail at all scales. For very large release masses, hydroplaning or significant softening of the shear layer due to water incorporation must be invoked to recover the observed scaling behavior; a combination of both effects likely will give the most realistic description of the phenomenon. Detailed studies of the neck behavior and the compositional dependence of the material properties are needed to arrive at a quantitative model. Other related and important open questions concern the rheological model appropriate for sandy debris flows and the suspension rate from the dense body into the associated turbidity current.