Yuji Harata
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yuji Harata has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Takashi Ikeda
Department of Mechanical Engineering, Graduate School of Advanced Science and Engineering, Hiroshima University, Higashi-Hiroshima, Japan
18 shared publications - Kouichi Taji
The Department of Mechanical Science and Engineering, Graduate School of Engineering, Nagoya University, Aichi, Japan
6 shared publications - Fumihiko Asano
Graduate School of Advanced Science and Technology, Japan Advanced Institute of Science and Technology, Nomi, Japan
4 shared publications - Yukio Ishida
Nagoya University
4 shared publications Yasuhisa Sekiguchi
Hiroshima University
3 shared publications- Yoji Uno
Nagoya University
3 shared publications
Latest Publications
- Open Access
- 10 October 2018
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 211, 18004
Parametric resonances of floating wind turbines blades under vertical wave excitation
The parametric resonances of the blades in floating offshore wind turbines are theoretically and experimentally investigated. In the theoretical analysis, each blade is pinned to a horizontal, rotating shaft and has a spring with rotational stiffness at the end. The blade is subjected to horizontal excitation which represents winds; the rotating shaft to vertical excitation which represents waves. The equation of motion for the blade inclination angle includes parametric excitation terms with three different frequencies, i.e., the rotational speed of the blade, and the sum of and difference between the rotational speed and wave excitation frequency. Numerical simulations are conducted for the corresponding linearized system, and it is found that unstable vibrations appear at several rotational speed ranges. An empirical approach is used to determine the regions where the unstable vibrations appear. Swept-sine tests are conducted to determine the frequency response curves for the nonlinear system and demonstrate that the parametric resonances appear at similar rotational speeds as those of the unstable regions. In experiments, parametric resonances were observed at the rotational speeds and wave excitation frequencies predicted by the theoretical analysis.
- 10 October 2018
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 211, 18004
Open AccessParametric resonances of floating wind turbines blades under vertical wave excitation
The parametric resonances of the blades in floating offshore wind turbines are theoretically and experimentally investigated. In the theoretical analysis, each blade is pinned to a horizontal, rotating shaft and has a spring with rotational stiffness at the end. The blade is subjected to horizontal excitation which represents winds; the rotating shaft to vertical excitation which represents waves. The equation of motion for the blade inclination angle includes parametric excitation terms with three different frequencies, i.e., the rotational speed of the blade, and the sum of and difference between the rotational speed and wave excitation frequency. Numerical simulations are conducted for the corresponding linearized system, and it is found that unstable vibrations appear at several rotational speed ranges. An empirical approach is used to determine the regions where the unstable vibrations appear. Swept-sine tests are conducted to determine the frequency response curves for the nonlinear system and demonstrate that the parametric resonances appear at similar rotational speeds as those of the unstable regions. In experiments, parametric resonances were observed at the rotational speeds and wave excitation frequencies predicted by the theoretical analysis.
- 1 January 2018
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2018.56, 1002
Vibration control in wind turbine blades using pendulum-type vibration absorbers
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2018
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2018.56, 1002
Vibration control in wind turbine blades using pendulum-type vibration absorbers
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2018
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2018.56, 1004
Nonlinear vibrations of double beams connected by a spring and dashpot
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2018
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2018.56, 1004
Nonlinear vibrations of double beams connected by a spring and dashpot
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2018
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2018.56, 1003
Vibration analysis of offshore floating wind turbine blades subjected to horizontal excitation
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2018
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2018.56, 1003
Vibration analysis of offshore floating wind turbine blades subjected to horizontal excitation
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 30 May 2017
- Published by ASME International in Journal of Vibration and Acoustics
- Vol. 139 (4) , 041009
Vibration Control of Horizontally Excited Structures Utilizing Internal Resonance of Liquid Sloshing in Nearly Square Tanks
Passive control of vibrations in an elastic structure subjected to horizontal, harmonic excitation by utilizing a nearly square liquid tank is investigated. When the natural frequency ratio 1:1:1 is satisfied among the natural frequencies of the structure and the two predominant sloshing modes (1,0) and (0,1), the performance of a nearly square tank as a tuned liquid damper (TLD) is expected to be superior to rectangular TLDs due to internal resonance. In the theoretical analysis, Galerkin's method is used to determine the modal equations of motion for liquid sloshing considering the nonlinearity of sloshing. Then, van der Pol's method is used to obtain the expressions for the frequency response curves for the structure and sloshing modes. Frequency response curves and bifurcation set diagrams are shown to investigate the influences of the aspect ratio of the tank cross section and the tank installation angle on the system response. From the theoretical results, the optimal values of the system parameters can be determined in order to achieve maximum efficiency of vibration suppression for the structure. Hopf bifurcations occur and amplitude modulated motions (AMMs) may appear depending on the values of the system parameters. Experiments were also conducted, and the theoretical results agreed well with the experimental data.
- 30 May 2017
- Published by ASME International in Journal of Vibration and Acoustics
- Vol. 139 (4) , 041009
Vibration Control of Horizontally Excited Structures Utilizing Internal Resonance of Liquid Sloshing in Nearly Square Tanks
Passive control of vibrations in an elastic structure subjected to horizontal, harmonic excitation by utilizing a nearly square liquid tank is investigated. When the natural frequency ratio 1:1:1 is satisfied among the natural frequencies of the structure and the two predominant sloshing modes (1,0) and (0,1), the performance of a nearly square tank as a tuned liquid damper (TLD) is expected to be superior to rectangular TLDs due to internal resonance. In the theoretical analysis, Galerkin's method is used to determine the modal equations of motion for liquid sloshing considering the nonlinearity of sloshing. Then, van der Pol's method is used to obtain the expressions for the frequency response curves for the structure and sloshing modes. Frequency response curves and bifurcation set diagrams are shown to investigate the influences of the aspect ratio of the tank cross section and the tank installation angle on the system response. From the theoretical results, the optimal values of the system parameters can be determined in order to achieve maximum efficiency of vibration suppression for the structure. Hopf bifurcations occur and amplitude modulated motions (AMMs) may appear depending on the values of the system parameters. Experiments were also conducted, and the theoretical results agreed well with the experimental data.
- 4 May 2017
- Published by ASME International in Journal of Computational and Nonlinear Dynamics
- Vol. 12 (5) , 051012
Vibration Control of Two-Degree-of-Freedom Structures Utilizing Sloshing in Nearly Square Tanks
This paper investigates the vibration control of a towerlike structure with degrees of freedom utilizing a square or nearly square tuned liquid damper (TLD) when the structure is subjected to horizontal, harmonic excitation. In the theoretical analysis, when the two natural frequencies of the two-degree-of-freedom (2DOF) structure nearly equal those of the two predominant sloshing modes, the tuning condition, 1:1:1:1, is nearly satisfied. Galerkin's method is used to derive the modal equations of motion for sloshing. The nonlinearity of the hydrodynamic force due to sloshing is considered in the equations of motion for the 2DOF structure. Linear viscous damping terms are incorporated into the modal equations to consider the damping effect of sloshing. Van der Pol's method is employed to determine the expressions for the frequency response curves. The influences of the excitation frequency, the tank installation angle, and the aspect ratio of the tank cross section on the response curves are examined. The theoretical results show that whirling motions and amplitude-modulated motions (AMMs), including chaotic motions, may occur in the structure because swirl motions and Hopf bifurcations, followed by AMMs, appear in the tank. It is also found that a square TLD works more effectively than a conventional rectangular TLD, and its performance is further improved when the tank width is slightly increased and the installation angle is equal to zero. Experiments were conducted in order to confirm the validity of the theoretical results.
- 4 May 2017
- Published by ASME International in Journal of Computational and Nonlinear Dynamics
- Vol. 12 (5) , 051012
Vibration Control of Two-Degree-of-Freedom Structures Utilizing Sloshing in Nearly Square Tanks
This paper investigates the vibration control of a towerlike structure with degrees of freedom utilizing a square or nearly square tuned liquid damper (TLD) when the structure is subjected to horizontal, harmonic excitation. In the theoretical analysis, when the two natural frequencies of the two-degree-of-freedom (2DOF) structure nearly equal those of the two predominant sloshing modes, the tuning condition, 1:1:1:1, is nearly satisfied. Galerkin's method is used to derive the modal equations of motion for sloshing. The nonlinearity of the hydrodynamic force due to sloshing is considered in the equations of motion for the 2DOF structure. Linear viscous damping terms are incorporated into the modal equations to consider the damping effect of sloshing. Van der Pol's method is employed to determine the expressions for the frequency response curves. The influences of the excitation frequency, the tank installation angle, and the aspect ratio of the tank cross section on the response curves are examined. The theoretical results show that whirling motions and amplitude-modulated motions (AMMs), including chaotic motions, may occur in the structure because swirl motions and Hopf bifurcations, followed by AMMs, appear in the tank. It is also found that a square TLD works more effectively than a conventional rectangular TLD, and its performance is further improved when the tank width is slightly increased and the installation angle is equal to zero. Experiments were conducted in order to confirm the validity of the theoretical results.
- 1 January 2017
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2017.55, K1003
Impact response of two beams connected by a spring and damper
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2017
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2017.55, K1003
Impact response of two beams connected by a spring and damper
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2016
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2016.54, _605-1_
605 Nonlinear Liquid Sloshing in Cylindrical Tanks Subjected to Horizontal Excitation
- 1 January 2016
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Chugoku-Shikoku Branch
- Vol. 2016.54, _605-1_
605 Nonlinear Liquid Sloshing in Cylindrical Tanks Subjected to Horizontal Excitation
- 1 January 2016
- Published by Elsevier in Journal of Sound and Vibration
- Vol. 361, 210-225
Internal resonance of nonlinear sloshing in rectangular liquid tanks subjected to obliquely horizontal excitation
- 1 January 2016
- Published by Elsevier in Journal of Sound and Vibration
- Vol. 361, 210-225
Internal resonance of nonlinear sloshing in rectangular liquid tanks subjected to obliquely horizontal excitation