Baosheng Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Baosheng Wang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
A. Ivanov
University of British Columbia
2 shared publicationsYuejian Wu
Nortel Networks
2 shared publications- Andre Ivanov
Department of Electrical and Computer Engineering, The University of British Columbia, Vancouver, Canada
1 shared publication André Ivanov
1 shared publicationAndy Kuo
1 shared publicationJosh Yang
University of British Columbia
1 shared publication
Latest Publications
- Open Access
A Fast Diagnosis Scheme for Distributed Small Embedded SRAMs
This paper proposes a diagnosis scheme aimed at reducing diagnosis time of distributed small embedded SRAMs (e-SRAMs). This scheme improves the one proposed in [A parallel built-in self-diagnostic method for embedded memory buffers, A parallel built-in self-diagnostic method for embedded memory arrays]. The improvements are mainly two-fold. On one hand, the diagnosis of time-consuming Data Retention Faults (DRFs), which is neglected by the diagnosis architecture in [A parallel built-in self-diagnostic method for embedded memory buffers, A parallel built-in self-diagnostic method for embedded memory arrays], is now considered and performed via a DFT technique referred to as the "No Write Recovery Test Mode (NWRTM)". On the other hand, a pair comprising a Serial to Parallel Converter (SPC) and a Parallel to Serial Converter (PSC) is utilized to replace the bi-directional serial interface, to avoid the problems of serial fault masking and defect rate dependent diagnosis. Results from our evaluations show that the proposed diagnosis scheme achieves an increased diagnosis coverage and reduces diagnosis time compared to those obtained in [A parallel built-in self-diagnostic method for embedded memory buffers, A parallel built-in self-diagnostic method for embedded memory arrays], with neglectable extra area cost.
Open AccessA Fast Diagnosis Scheme for Distributed Small Embedded SRAMs
This paper proposes a diagnosis scheme aimed at reducing diagnosis time of distributed small embedded SRAMs (e-SRAMs). This scheme improves the one proposed in [A parallel built-in self-diagnostic method for embedded memory buffers, A parallel built-in self-diagnostic method for embedded memory arrays]. The improvements are mainly two-fold. On one hand, the diagnosis of time-consuming Data Retention Faults (DRFs), which is neglected by the diagnosis architecture in [A parallel built-in self-diagnostic method for embedded memory buffers, A parallel built-in self-diagnostic method for embedded memory arrays], is now considered and performed via a DFT technique referred to as the "No Write Recovery Test Mode (NWRTM)". On the other hand, a pair comprising a Serial to Parallel Converter (SPC) and a Parallel to Serial Converter (PSC) is utilized to replace the bi-directional serial interface, to avoid the problems of serial fault masking and defect rate dependent diagnosis. Results from our evaluations show that the proposed diagnosis scheme achieves an increased diagnosis coverage and reduces diagnosis time compared to those obtained in [A parallel built-in self-diagnostic method for embedded memory buffers, A parallel built-in self-diagnostic method for embedded memory arrays], with neglectable extra area cost.
- 1 December 2005
- Published by Springer Nature in Journal of Electronic Testing
- Vol. 21 (6) , 621-630
A Realistic Timing Test Model and Its Applications in High-Speed Interconnect Devices
- 1 December 2005
- Published by Springer Nature in Journal of Electronic Testing
- Vol. 21 (6) , 621-630
A Realistic Timing Test Model and Its Applications in High-Speed Interconnect Devices
- 28 July 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 66-71
SRAM Retention Testing: Zero Incremental Time Integration with March Algorithms
Testing data retention faults (DRFs), particularly in integrated systems on chip comprised of very large number of various sizes and types of embedded SRAMs is challenging and typically time-consuming due to the required pause time that needs to be introduced in the test session. This paper proposes a novel technique, referred to as pre-discharge write test mode (PDWTM), that effectively integrates the testing of DRF within "regular" March algorithms such that the rate (speed) of the latter remains unaltered. That is, the PDWTM enables DRF testing without incurring the additional cycles or pauses in the March test execution thereby enabling additional coverage at no expense in terms of overall test time. We show that DRFs can be easily detected by pre-discharging bit lines before a write operation. Here, the PDWTM is evaluated using both high-speed and low power memory cells, representing two extreme cases based on the typical memory design methodologies.
- 28 July 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 66-71
SRAM Retention Testing: Zero Incremental Time Integration with March Algorithms
Testing data retention faults (DRFs), particularly in integrated systems on chip comprised of very large number of various sizes and types of embedded SRAMs is challenging and typically time-consuming due to the required pause time that needs to be introduced in the test session. This paper proposes a novel technique, referred to as pre-discharge write test mode (PDWTM), that effectively integrates the testing of DRF within "regular" March algorithms such that the rate (speed) of the latter remains unaltered. That is, the PDWTM enables DRF testing without incurring the additional cycles or pauses in the March test execution thereby enabling additional coverage at no expense in terms of overall test time. We show that DRFs can be easily detected by pre-discharging bit lines before a write operation. Here, the PDWTM is evaluated using both high-speed and low power memory cells, representing two extreme cases based on the typical memory design methodologies.
- 8 November 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 120-128
Designs for reducing test time of distributed small embedded SRAMs
This paper proposes a test architecture aimed at reducing test time of distributed small embedded SRAMs (e-SRAMs). This architecture improves the one proposed in (W. B. Jone et al, Proc. 17th IEEE VLSI Test Symp., p.246- 251, 1999 and also IEEE Transact. VLSI Syst., vol.10, no.4, p.512-515, 2002). The improvements are mainly two-fold. On one hand, the testing of time-consuming data retention faults (DRFs), that is neglected by the previously proposed test architecture, is now considered and performed via a DFT technique referred to as the "no write recovery test mode (XWRTM)". On the other hand, a parallel local response analyzer (LRA), instead of a serial response analyzer, is used to reduce the test time of these distributed small e-SRAMs. Results from our evaluations show that the proposed test architecture can achieve a better defect coverage and test time compared to those obtained previously, with a negligible area cost.
- 8 November 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 120-128
Designs for reducing test time of distributed small embedded SRAMs
This paper proposes a test architecture aimed at reducing test time of distributed small embedded SRAMs (e-SRAMs). This architecture improves the one proposed in (W. B. Jone et al, Proc. 17th IEEE VLSI Test Symp., p.246- 251, 1999 and also IEEE Transact. VLSI Syst., vol.10, no.4, p.512-515, 2002). The improvements are mainly two-fold. On one hand, the testing of time-consuming data retention faults (DRFs), that is neglected by the previously proposed test architecture, is now considered and performed via a DFT technique referred to as the "no write recovery test mode (XWRTM)". On the other hand, a parallel local response analyzer (LRA), instead of a serial response analyzer, is used to reduce the test time of these distributed small e-SRAMs. Results from our evaluations show that the proposed test architecture can achieve a better defect coverage and test time compared to those obtained previously, with a negligible area cost.