Jamal S. Rahhal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jamal S. Rahhal has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Ahmed Al-Mobydeen
Department of Chemistry, Faculty of Science, Jerash University, Jerash 26150, Jordan
2 shared publications - Dia I. Abu al Nadi
Electrical Engineering Department, The University of Jordan, Amman 11942, Jordan
2 shared publications - Ehab AlShamaileh
Department of Chemistry, The University of Jordan, Amman 11942, Jordan
2 shared publications - Iessa Sabbe Moosa
Department of Chemistry, The University of Jordan, Amman 11942, Jordan
2 shared publications - Imad Hamadneh
Department of Chemistry, The University of Jordan, Amman 11941, Jordan
2 shared publications - Mike Haddad
Renewable Energy Engineering Department, Isra University, Amman P.O. Box 33, Jordan
2 shared publications
Latest Publications
- Open Access
- 7 January 2026
- Published by MDPI AG in Inorganics
- Vol. 14 (1) , 25
The Influence of Sintering Temperature on the Transport Properties of GdBa2Cu3O7 Superconductor Prepared from Nano-Powders via the Co-Precipitation Method
This study examines the influence of sintering temperature on the structural and transport properties of GdBa2Cu3O7 (Gd123) superconductors prepared from nano-sized precursors via the co-precipitation method. The metal-oxalate precursor (average particle size < 50 nm) was calcined at 900 °C for 12 h, and then the prepared pellets were sintered under an oxygen atmosphere in the range of 920–950 °C for 15 h. All samples showed metallic properties and a sharp superconducting transition. Critical temperatures TC(R=0) were 94–95 K, with higher sintering temperatures steadily boosting critical current density. X-ray diffraction confirmed orthorhombic Gd123 as the dominant phase, with its phase fraction increasing from 92% to 99.8% as the sintering temperature increased. SEM micrographs showed large, densely packed grains, with higher sintering temperatures promoting improved grain connectivity and reduced porosity. The sample sintered at 950 °C exhibited the most favorable transport performance, attributed to enhanced intergranular coupling and the presence of nanoscale secondary phases acting as effective flux-pinning centers. Overall, these results demonstrate that careful control of sintering temperature can significantly optimize the microstructure and superconducting properties of Gd123 materials, supporting their advancement for practical electrical and magnetic applications.
- 7 January 2026
- Published by MDPI AG in Inorganics
- Vol. 14 (1) , 25
Open AccessThe Influence of Sintering Temperature on the Transport Properties of GdBa2Cu3O7 Superconductor Prepared from Nano-Powders via the Co-Precipitation Method
This study examines the influence of sintering temperature on the structural and transport properties of GdBa2Cu3O7 (Gd123) superconductors prepared from nano-sized precursors via the co-precipitation method. The metal-oxalate precursor (average particle size < 50 nm) was calcined at 900 °C for 12 h, and then the prepared pellets were sintered under an oxygen atmosphere in the range of 920–950 °C for 15 h. All samples showed metallic properties and a sharp superconducting transition. Critical temperatures TC(R=0) were 94–95 K, with higher sintering temperatures steadily boosting critical current density. X-ray diffraction confirmed orthorhombic Gd123 as the dominant phase, with its phase fraction increasing from 92% to 99.8% as the sintering temperature increased. SEM micrographs showed large, densely packed grains, with higher sintering temperatures promoting improved grain connectivity and reduced porosity. The sample sintered at 950 °C exhibited the most favorable transport performance, attributed to enhanced intergranular coupling and the presence of nanoscale secondary phases acting as effective flux-pinning centers. Overall, these results demonstrate that careful control of sintering temperature can significantly optimize the microstructure and superconducting properties of Gd123 materials, supporting their advancement for practical electrical and magnetic applications.
- Open Access
- 25 November 2025
- Published by MDPI AG in Preprints.org
Influence of Sintering Temperature on the Transport Properties of GdBa2Cu3O7 Superconductor Prepared from Nano-Powders via Co-Precipitation Method
This study examines the influence of sintering temperature on the structural and transport properties of GdBa₂Cu₃O₇ (Gd123) superconductors prepared from nano-sized precursors via the co-precipitation method. The metal-oxalate precursor (average particle size C(R=0) were 94–95 K, with higher sintering temperatures steadily boosting critical current density. X-ray diffraction confirmed orthorhombic Gd123 as the dominant phase, with its phase fraction increasing from 92% to 99.8% as the sintering temperature increased. SEM micrographs showed large, densely packed grains, with higher sintering temperatures promoting improved grain connectivity and reduced porosity. The sample sintered at 950 °C exhibited the most favorable transport performance, attributed to enhanced intergranular coupling and the presence of nanoscale secondary phases acting as effective flux-pinning centers. Overall, these results demonstrate that careful control of sintering temperature can significantly optimize the microstructure and superconducting properties of Gd123 materials, supporting their advancement for practical electrical and magnetic applications.
- 25 November 2025
- Published by MDPI AG in Preprints.org
Open AccessInfluence of Sintering Temperature on the Transport Properties of GdBa2Cu3O7 Superconductor Prepared from Nano-Powders via Co-Precipitation Method
This study examines the influence of sintering temperature on the structural and transport properties of GdBa₂Cu₃O₇ (Gd123) superconductors prepared from nano-sized precursors via the co-precipitation method. The metal-oxalate precursor (average particle size C(R=0) were 94–95 K, with higher sintering temperatures steadily boosting critical current density. X-ray diffraction confirmed orthorhombic Gd123 as the dominant phase, with its phase fraction increasing from 92% to 99.8% as the sintering temperature increased. SEM micrographs showed large, densely packed grains, with higher sintering temperatures promoting improved grain connectivity and reduced porosity. The sample sintered at 950 °C exhibited the most favorable transport performance, attributed to enhanced intergranular coupling and the presence of nanoscale secondary phases acting as effective flux-pinning centers. Overall, these results demonstrate that careful control of sintering temperature can significantly optimize the microstructure and superconducting properties of Gd123 materials, supporting their advancement for practical electrical and magnetic applications.
- Open Access
- 7 March 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (6) , 2916
An Experimental Study of Radiated Energy from an Optical Fiber and the Potential for an Optical MIMO System
Leaky feeders provide seamless and uniform signal coverage in confined spaces like tunnels, mines, and buildings. Their easy scalability and integration with modern systems, like Multiple Input Multiple Output (MIMO), make them ideal for environments requiring reliable and consistent connectivity. However, using optical fiber as a radiating cable has never been investigated before. This may seem infeasible at first sight. However, our experimental study shows otherwise. We measured light leaking from a bent optical fiber transmitter. We also derived closed-form formulas to describe the amount of leakage energy and found that this energy exponentially varies with the square of the curvature radius. This allows us to design an Optical Leaky Feeder (OLF) transmission system for the first time. Then, we analytically show that a slotted optical fiber can be used as a MIMO receiver. The proposed system can ensure reliable, high-quality signal distribution even in challenging environments like tunnels, industrial settings, and dense urban areas.
- 7 March 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (6) , 2916
Open AccessAn Experimental Study of Radiated Energy from an Optical Fiber and the Potential for an Optical MIMO System
Leaky feeders provide seamless and uniform signal coverage in confined spaces like tunnels, mines, and buildings. Their easy scalability and integration with modern systems, like Multiple Input Multiple Output (MIMO), make them ideal for environments requiring reliable and consistent connectivity. However, using optical fiber as a radiating cable has never been investigated before. This may seem infeasible at first sight. However, our experimental study shows otherwise. We measured light leaking from a bent optical fiber transmitter. We also derived closed-form formulas to describe the amount of leakage energy and found that this energy exponentially varies with the square of the curvature radius. This allows us to design an Optical Leaky Feeder (OLF) transmission system for the first time. Then, we analytically show that a slotted optical fiber can be used as a MIMO receiver. The proposed system can ensure reliable, high-quality signal distribution even in challenging environments like tunnels, industrial settings, and dense urban areas.
- Open Access
- 28 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 125411-125420
Pre-Coding OAM Based MIMO System for Multi-User Communications
Recently, orthogonal Orbital Angular Momentum (OAM) modes of electromagnetic waves have been widely applied to achieve high spectral efficiency in the radio and microwave regimes. This study investigates utilizing multimodal OAM carrying waves in communications between a central unit and distributed receiving units. Accommodated by a planner grid-array of antenna elements and backed by appropriate pre-coding, the central unit can transmit to each receiving unit multi-OAM modes. A receiving unit comprises a simple circular array. Pre-coding at the transmitting unit is a two-fold process: preventing user-to-user interference and enforcing any predetermined combination of OAM modes to reach its destination. Accordingly, the parallel transmission of multiple channels to each receiver is possible. Channels aimed at the same receiver are distinguished by different modes, but the same group of modes can be simultaneously used upon transmission to other receivers. The numerical results show that significant increase in the transmission capacity is achieved. For instance, in a system including 6 receivers, 25 channels are delivered in parallel to each receiver while maintaining an acceptable low bit-error rate. Results are judged by considering the theoretical single-user quadrature phase shift keying modulation performance as a benchmark for comparison. This study also examines channel perturbations when interfering modes exist. In addition, it overcomes many typical limitations with the utilization of OAM-based solutions in radio, such as the need for transmitter-receiver alignment. The proposed system also solves the problem of wave divergence at high OAM modes, thereby avoiding the exclusion of using these modes in transmission.
- 28 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 125411-125420
Open AccessPre-Coding OAM Based MIMO System for Multi-User Communications
Recently, orthogonal Orbital Angular Momentum (OAM) modes of electromagnetic waves have been widely applied to achieve high spectral efficiency in the radio and microwave regimes. This study investigates utilizing multimodal OAM carrying waves in communications between a central unit and distributed receiving units. Accommodated by a planner grid-array of antenna elements and backed by appropriate pre-coding, the central unit can transmit to each receiving unit multi-OAM modes. A receiving unit comprises a simple circular array. Pre-coding at the transmitting unit is a two-fold process: preventing user-to-user interference and enforcing any predetermined combination of OAM modes to reach its destination. Accordingly, the parallel transmission of multiple channels to each receiver is possible. Channels aimed at the same receiver are distinguished by different modes, but the same group of modes can be simultaneously used upon transmission to other receivers. The numerical results show that significant increase in the transmission capacity is achieved. For instance, in a system including 6 receivers, 25 channels are delivered in parallel to each receiver while maintaining an acceptable low bit-error rate. Results are judged by considering the theoretical single-user quadrature phase shift keying modulation performance as a benchmark for comparison. This study also examines channel perturbations when interfering modes exist. In addition, it overcomes many typical limitations with the utilization of OAM-based solutions in radio, such as the need for transmitter-receiver alignment. The proposed system also solves the problem of wave divergence at high OAM modes, thereby avoiding the exclusion of using these modes in transmission.
- Open Access
- 8 October 2017
- Published by Canadian Center of Science and Education in Modern Applied Science
- Vol. 11 (11) , 1
Optimum Signal Shaping for MIMO Radar System
Signal and hence, spatial diversity gain is obtained. A MIMO radar system, transmit via its diverse antennas multiple probing signals that is used to detect targets. The receiving antennas combined together form independent units. Their signals can be processed to make use from the diversity gain and better identifies the targets. In this paper, optimal probing signals are derived and its performance is simulated. MIMO radar can transmit different orthogonal signals that lead to signal diversity. Results showed good utilization of spatial diversity and better timing detection when using the optimal signals over the conventional phased array radar.
- 8 October 2017
- Published by Canadian Center of Science and Education in Modern Applied Science
- Vol. 11 (11) , 1
Open AccessOptimum Signal Shaping for MIMO Radar System
Signal and hence, spatial diversity gain is obtained. A MIMO radar system, transmit via its diverse antennas multiple probing signals that is used to detect targets. The receiving antennas combined together form independent units. Their signals can be processed to make use from the diversity gain and better identifies the targets. In this paper, optimal probing signals are derived and its performance is simulated. MIMO radar can transmit different orthogonal signals that lead to signal diversity. Results showed good utilization of spatial diversity and better timing detection when using the optimal signals over the conventional phased array radar.
- 13 January 2012
- Published by Springer Nature in Peer-to-Peer Networking and Applications
- Vol. 5 (3) , 279-291
File size models for shared content over the BitTorrent Peer-to-Peer network
- 13 January 2012
- Published by Springer Nature in Peer-to-Peer Networking and Applications
- Vol. 5 (3) , 279-291
File size models for shared content over the BitTorrent Peer-to-Peer network
- 11 September 2010
- Published by Springer Nature in Wireless Personal Communications
- Vol. 63 (2) , 447-457
Wireless MIMO Sensor Network with Power Constraint WLS/BLUE Estimators
- 11 September 2010
- Published by Springer Nature in Wireless Personal Communications
- Vol. 63 (2) , 447-457
Wireless MIMO Sensor Network with Power Constraint WLS/BLUE Estimators
- 22 December 2009
- Published by Springer Nature in Annals of Telecommunications
- Vol. 65 (7-8) , 353-358
A probabilistic model for sub-carrier allocation in OFDMA systems
- 22 December 2009
- Published by Springer Nature in Annals of Telecommunications
- Vol. 65 (7-8) , 353-358
A probabilistic model for sub-carrier allocation in OFDMA systems
- 25 September 2009
- Published by Springer Nature in Wireless Personal Communications
- Vol. 55 (4) , 591-605
Pre-Coding for MIMO Systems in Frequency-Selective Fading Channels
- 25 September 2009
- Published by Springer Nature in Wireless Personal Communications
- Vol. 55 (4) , 591-605
Pre-Coding for MIMO Systems in Frequency-Selective Fading Channels
- 1 October 2004
- Published by Springer Nature in International Journal of Wireless Information Networks
- Vol. 11 (4) , 187-199
Parallel Channels for High Rate UTRAN
- 1 October 2004
- Published by Springer Nature in International Journal of Wireless Information Networks
- Vol. 11 (4) , 187-199
Parallel Channels for High Rate UTRAN