Bhaskar Bhattacharya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bhaskar Bhattacharya has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Pramod Kumar Singh
Centre of Excellence in Solar Cell and Renewable Energy, Department of Physics & Env Sci, Sharda School of Engineering and Sciences, Sharda University, Greater Noida, India
6 shared publications Divya Singh
Material Research Laboratory, School of Basic Sciences & Research, Sharda University, Greater Noida, Uttar Pradesh, India
3 shared publicationsPramod K Singh
Material Research Laboratory, School of Basic Sciences & Research, Sharda University, Greater Noida, Uttar Pradesh, India
3 shared publicationsPramod K. Singh
Sharda University
3 shared publicationsAnemone Koul Chaku
Material Research Laboratory, School of Basic Sciences & Research, Sharda University, Greater Noida, India
2 shared publications- Nitin Appa Jadhav
Vidya Pratishthan’s Kamalnayan Bajaj Institute of Engineering and Technology
2 shared publications
Latest Publications
- 12 June 2018
- Published by SAGE Publications in High Performance Polymers
- Vol. 30 (8) , 978-985
Conductivity and dielectric studies of Li3+-irradiated PVP-based polymer electrolytes
Poly(vinylpyrrolidone) (PVP) complexed with sodium iodide (NaI) is synthesized to investigate the ionic conductivity of alkaline-based polymer electrolytes. In this article, we report the modification of electrical properties of a new ion-conducting polymer electrolyte, namely, PVP complexed with NaI. Modification of polymer electrolyte was carried out before and after the exposure of films by bombarding them at different fluences with respect to Li3+ ion beam at 60 MeV. The preparation and detailed characterization of PVP:NaI is being reported. Further, a correlation with conductivity and dielectric constant has also been established. The modulation in the conductivity is explained in terms of number of charge carriers ( n) and its mobility ( μ), which confirms the behavior of the polymer electrolyte as an alternative strategy to improve the conductivity.
- 12 June 2018
- Published by SAGE Publications in High Performance Polymers
- Vol. 30 (8) , 978-985
Conductivity and dielectric studies of Li3+-irradiated PVP-based polymer electrolytes
Poly(vinylpyrrolidone) (PVP) complexed with sodium iodide (NaI) is synthesized to investigate the ionic conductivity of alkaline-based polymer electrolytes. In this article, we report the modification of electrical properties of a new ion-conducting polymer electrolyte, namely, PVP complexed with NaI. Modification of polymer electrolyte was carried out before and after the exposure of films by bombarding them at different fluences with respect to Li3+ ion beam at 60 MeV. The preparation and detailed characterization of PVP:NaI is being reported. Further, a correlation with conductivity and dielectric constant has also been established. The modulation in the conductivity is explained in terms of number of charge carriers ( n) and its mobility ( μ), which confirms the behavior of the polymer electrolyte as an alternative strategy to improve the conductivity.
- 1 January 2018
- Published by Elsevier in Materials Today: Proceedings
- Vol. 5 (3) , 9108-9113
Quantum Dot Solar Cells with size tuned CdSe QDs exhibiting 1.51V
- 1 January 2018
- Published by Elsevier in Materials Today: Proceedings
- Vol. 5 (3) , 9108-9113
Quantum Dot Solar Cells with size tuned CdSe QDs exhibiting 1.51V
- 6 September 2017
- Published by Taylor & Francis in Phase Transitions
- Vol. 91 (3) , 332-342
Effect of corona discharge on cadmium sulphide and lead sulphide films
- 6 September 2017
- Published by Taylor & Francis in Phase Transitions
- Vol. 91 (3) , 332-342
Effect of corona discharge on cadmium sulphide and lead sulphide films
- 24 June 2017
- Published by Springer Nature in Ionics
- Vol. 24 (1) , 163-167
Charge carriers dynamics in PEO + NaSCN polymer electrolytes
- 24 June 2017
- Published by Springer Nature in Ionics
- Vol. 24 (1) , 163-167
Charge carriers dynamics in PEO + NaSCN polymer electrolytes
- 9 May 2017
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 28 (15) , 11163-11171
Cadmium zinc sulphide (Cd1−xZnxS) films: effect of annealing
- 9 May 2017
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 28 (15) , 11163-11171
Cadmium zinc sulphide (Cd1−xZnxS) films: effect of annealing
- 28 July 2016
- Published by SAGE Publications in High Performance Polymers
- Vol. 28 (9) , 1059-1063
Ion irradiation on polymer electrolyte films
Two polymer (poly(ethylene oxide) and poly(vinylpyrrolidone))-based sodium ion conducting systems have been studied. The conductivity and related parameters has been compared after irradiation with that before irradiation. The complex impedance spectroscopic tools have been used to determine the ionic conductivity, dielectric constant, number of charge carriers, and its corresponding mobility of the two systems. Modulation in conductivity of the systems has been correlated and attributed to change in crystallinity of the matrix. Suggestive principles have also been proposed for preparation of optimum polymer electrolyte films using ion beam treatment.
- 28 July 2016
- Published by SAGE Publications in High Performance Polymers
- Vol. 28 (9) , 1059-1063
Ion irradiation on polymer electrolyte films
Two polymer (poly(ethylene oxide) and poly(vinylpyrrolidone))-based sodium ion conducting systems have been studied. The conductivity and related parameters has been compared after irradiation with that before irradiation. The complex impedance spectroscopic tools have been used to determine the ionic conductivity, dielectric constant, number of charge carriers, and its corresponding mobility of the two systems. Modulation in conductivity of the systems has been correlated and attributed to change in crystallinity of the matrix. Suggestive principles have also been proposed for preparation of optimum polymer electrolyte films using ion beam treatment.
- 20 April 2016
- Published by Taylor & Francis in Phase Transitions
- Vol. 90 (3) , 236-243
Detail electrical and dielectric studies on carbon-fly ash composite
A new solid-state composite was prepared by using fly ash as host matrix and carbon shoots of camphor as dispersoid, which are abundantly available and cheap. The composite was characterized by using different techniques. For conductivity and dielectric measurements, we used complex impedance spectroscopy. Maximum conductivity was obtained at 4% of carbon in fly ash. The dielectric measurements affirm conductivity pattern. X-ray diffraction and Fourier transform infrared spectroscopy (FTIR) was conducted which shows composite nature of sample. Total ionic transference number test reveals that conductivity is mainly due to ions.
- 20 April 2016
- Published by Taylor & Francis in Phase Transitions
- Vol. 90 (3) , 236-243
Detail electrical and dielectric studies on carbon-fly ash composite
A new solid-state composite was prepared by using fly ash as host matrix and carbon shoots of camphor as dispersoid, which are abundantly available and cheap. The composite was characterized by using different techniques. For conductivity and dielectric measurements, we used complex impedance spectroscopy. Maximum conductivity was obtained at 4% of carbon in fly ash. The dielectric measurements affirm conductivity pattern. X-ray diffraction and Fourier transform infrared spectroscopy (FTIR) was conducted which shows composite nature of sample. Total ionic transference number test reveals that conductivity is mainly due to ions.
- 7 April 2016
- Published by Wiley in Advances in Polymer Technology
- Vol. 37 (2) , 542-546
Synthesis, Characterization, and Detailed Studies on Plasticized Poly(ethyl methacrylate): NH4I Polymer Electrolyte
Polymer electrolyte films of poly(ethyl methacrylate) (PEMA) with ethylene carbonate (EC) as a plasticizer and ammonium iodide (NH4I) as an ion‐donating salt have been prepared using the solution‐cast technique. The electrical characterization of the films was performed by impedance spectroscopy. The highest obtained ionic conductivity at room temperature was 1.16 × 10−5 S/cm with the composition of PEMA: NH4I (60:40) + 10% EC. The ionic transference number of the mobile ions estimated by the dc polarization method, and the H+ ionic transference number was found to be ∼0.85, which revealed that the conductivity species are predominantly ions. Likewise, the micrographs of the films were analyzed under an optical microscope. In addition, the charge carrier density (n) of the individual films was calculated on the basis of the dielectric constant study.
- 7 April 2016
- Published by Wiley in Advances in Polymer Technology
- Vol. 37 (2) , 542-546
Synthesis, Characterization, and Detailed Studies on Plasticized Poly(ethyl methacrylate): NH4I Polymer Electrolyte
Polymer electrolyte films of poly(ethyl methacrylate) (PEMA) with ethylene carbonate (EC) as a plasticizer and ammonium iodide (NH4I) as an ion‐donating salt have been prepared using the solution‐cast technique. The electrical characterization of the films was performed by impedance spectroscopy. The highest obtained ionic conductivity at room temperature was 1.16 × 10−5 S/cm with the composition of PEMA: NH4I (60:40) + 10% EC. The ionic transference number of the mobile ions estimated by the dc polarization method, and the H+ ionic transference number was found to be ∼0.85, which revealed that the conductivity species are predominantly ions. Likewise, the micrographs of the films were analyzed under an optical microscope. In addition, the charge carrier density (n) of the individual films was calculated on the basis of the dielectric constant study.
- 23 January 2015
- Published by Wiley in Macromolecular Symposia
- Vol. 347 (1) , 68-74
Band Gap Tailoring of Ni Doped Ternary Semiconductors for Photovoltaic Applications
- 23 January 2015
- Published by Wiley in Macromolecular Symposia
- Vol. 347 (1) , 68-74
Band Gap Tailoring of Ni Doped Ternary Semiconductors for Photovoltaic Applications
- Open Access
- 14 October 2014
- Published by Springer Nature in Discover Nano
- Vol. 9 (1) , 575
Effect of variation of average pore size and specific surface area of ZnO electrode (WE) on efficiency of dye-sensitized solar cells
Mesoporous ZnO nanoparticles have been synthesized with tremendous increase in specific surface area of up to 578 m2/g which was 5.54 m2/g in previous reports (J. Phys. Chem. C 113:14676-14680, 2009). Different mesoporous ZnO nanoparticles with average pore sizes ranging from 7.22 to 13.43 nm and specific surface area ranging from 50.41 to 578 m2/g were prepared through the sol-gel method via a simple evaporation-induced self-assembly process. The hydrolysis rate of zinc acetate was varied using different concentrations of sodium hydroxide. Morphology, crystallinity, porosity, and J-V characteristics of the materials have been studied using transmission electron microscopy (TEM), X-ray diffraction (XRD), BET nitrogen adsorption/desorption, and Keithley instruments.
- 14 October 2014
- Published by Springer Nature in Discover Nano
- Vol. 9 (1) , 575
Open AccessEffect of variation of average pore size and specific surface area of ZnO electrode (WE) on efficiency of dye-sensitized solar cells
Mesoporous ZnO nanoparticles have been synthesized with tremendous increase in specific surface area of up to 578 m2/g which was 5.54 m2/g in previous reports (J. Phys. Chem. C 113:14676-14680, 2009). Different mesoporous ZnO nanoparticles with average pore sizes ranging from 7.22 to 13.43 nm and specific surface area ranging from 50.41 to 578 m2/g were prepared through the sol-gel method via a simple evaporation-induced self-assembly process. The hydrolysis rate of zinc acetate was varied using different concentrations of sodium hydroxide. Morphology, crystallinity, porosity, and J-V characteristics of the materials have been studied using transmission electron microscopy (TEM), X-ray diffraction (XRD), BET nitrogen adsorption/desorption, and Keithley instruments.