Akbar Zendehnam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Akbar Zendehnam has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Sayed Mohsen Hosseini
Isfahan University of Medical Sciences
5 shared publications - Maryam Hosseinpour
Arak University
3 shared publications Mina Arabzadegan
3 shared publicationsNasrin Robatmili
Arak Univ, Fac Sci, Dept Phys, Thin Film Lab, Arak 3815688349, Iran
3 shared publicationsHamidreza Ghomi Marzdashti
2 shared publicationsSayed Siavash Madaeni
Membrane Research Centre Department of Chemical Engineering Faculty of Engineering Razi University Kermanshah 67149 Iran
2 shared publications
Latest Publications
- Open Access
- 27 August 2021
- Published by IWA Publishing in Water Supply
- Vol. 22 (2) , 1183-1198
Non-perpendicular incidence angle of cold atmospheric-pressure plasma treatment for fabrication of silver-based surface plasmon resonance biosensor for detection of Escherichia coli in water
In this study, for the first time, to our knowledge, a biosensor was produced using cold atmospheric plasma (CAP) treatment of silver thin film surface with non-perpendicular incidence angle for identification of Escherichia coli in distilled water. Field emission scanning electron microscopy (FESEM) exhibits that before deposition, non-perpendicular CAP treatment of glass surface substrate leads to the production of pinhole-free silver thin film. The results of atomic force microscopy (AFM) and curve fitting show that non-perpendicular CAP treatment of this pinhole-free silver thin film indicates to the appearance of Ag NPs with smaller size and larger surface area compared to untreated silver film deposited on the untreated glass substrate. The silver-based pinhole-free SPR biosensor produced with non-perpendicular CAP treatment of both glass substrate and silver film shows E. coli detection in the distilled water in the range of 104 colony forming unit (CFU/ml) to 108 CFU/ml with better sensitivity compared to the untreated silver-based SPR biosensor.
- 27 August 2021
- Published by IWA Publishing in Water Supply
- Vol. 22 (2) , 1183-1198
Open AccessNon-perpendicular incidence angle of cold atmospheric-pressure plasma treatment for fabrication of silver-based surface plasmon resonance biosensor for detection of Escherichia coli in water
In this study, for the first time, to our knowledge, a biosensor was produced using cold atmospheric plasma (CAP) treatment of silver thin film surface with non-perpendicular incidence angle for identification of Escherichia coli in distilled water. Field emission scanning electron microscopy (FESEM) exhibits that before deposition, non-perpendicular CAP treatment of glass surface substrate leads to the production of pinhole-free silver thin film. The results of atomic force microscopy (AFM) and curve fitting show that non-perpendicular CAP treatment of this pinhole-free silver thin film indicates to the appearance of Ag NPs with smaller size and larger surface area compared to untreated silver film deposited on the untreated glass substrate. The silver-based pinhole-free SPR biosensor produced with non-perpendicular CAP treatment of both glass substrate and silver film shows E. coli detection in the distilled water in the range of 104 colony forming unit (CFU/ml) to 108 CFU/ml with better sensitivity compared to the untreated silver-based SPR biosensor.
- Open Access
- 13 June 2018
- Published by Springer Nature in International Nano Letters
- Vol. 8 (3) , 157-164
Employing cold atmospheric plasma (Ar, He) on Ag thin film and their influences on surface morphology and anti-bacterial activity of silver films for water treatment
- 13 June 2018
- Published by Springer Nature in International Nano Letters
- Vol. 8 (3) , 157-164
Open AccessEmploying cold atmospheric plasma (Ar, He) on Ag thin film and their influences on surface morphology and anti-bacterial activity of silver films for water treatment
- 1 June 2017
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 131 (6) , 1431-1438
Externally Liquid-Filled Photonic Crystal Fibers with High Output Intensity and Low Confinement Loss
- 1 June 2017
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 131 (6) , 1431-1438
Externally Liquid-Filled Photonic Crystal Fibers with High Output Intensity and Low Confinement Loss
- 11 April 2014
- Published by Springer Nature in Korean Journal of Chemical Engineering
- Vol. 31 (7) , 1187-1193
Preparation and characterization of nanocomposite heterogeneous cation exchange membranes modified by silver nanoparticles
- 11 April 2014
- Published by Springer Nature in Korean Journal of Chemical Engineering
- Vol. 31 (7) , 1187-1193
Preparation and characterization of nanocomposite heterogeneous cation exchange membranes modified by silver nanoparticles
- Open Access
- 1 April 2014
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 37 (2) , 179-183
Influence of deposition rate on PL spectrum and surface morphology of ZnO nanolayers deposited on Si (100) substrate
- 1 April 2014
- Published by Springer Nature in Bulletin of Materials Science
- Vol. 37 (2) , 179-183
Open AccessInfluence of deposition rate on PL spectrum and surface morphology of ZnO nanolayers deposited on Si (100) substrate
- 12 February 2014
- Published by Optica Publishing Group in Applied Optics
- Vol. 53 (6) , 1075-1082
Optimum values of air-filling fraction for photonic crystal fibers with different configurations and fixed number of air rings.
In this study, a Gaussian amp function related to the Gaussian family is employed to approximate the output intensity profile of various arrangements of air holes in photonic crystal fibers (PCFs) with a fixed number of air rings (). It is shown that can be the best minimum value of air-filling fraction for all of the studied PCFs when , whereas, for and 1.65 μm, is suitable for achieving the maximum output intensity with very low confinement loss.- 12 February 2014
- Published by Optica Publishing Group in Applied Optics
- Vol. 53 (6) , 1075-1082
Optimum values of air-filling fraction for photonic crystal fibers with different configurations and fixed number of air rings.
In this study, a Gaussian amp function related to the Gaussian family is employed to approximate the output intensity profile of various arrangements of air holes in photonic crystal fibers (PCFs) with a fixed number of air rings (). It is shown that can be the best minimum value of air-filling fraction for all of the studied PCFs when , whereas, for and 1.65 μm, is suitable for achieving the maximum output intensity with very low confinement loss.- 17 October 2013
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 131 (6)
Fabrication and modification of acrylonitrile–butadiene–styrene‐based heterogeneous ion‐exchange membranes by plasma treatment: Investigation of the nanolayer deposition rate and temperature effects
Our target in this study was the preparation of electrodialysis ion‐exchange membranes with appropriate properties for applications in water recovery and treatment. Composite mixed‐matrix, anion‐exchange membranes were prepared by a solution casting technique with acrylonitrile–butadiene–styrene as a base binder, resin powder as a functional group agent, activated carbon as an adsorptive filler, and an Ag nanolayer as a surface modifier. The Ag nanolayer was used with a magnetron sputtering method. The effect of the nanolayer deposition rate (Rq) and substrate and annealing temperatures on the physicochemical characteristics of the membranes were studied. The X‐ray diffraction results show that average grain size of the nanolayer and membrane crystallinity were improved with increasing Rq. The atomic force microscopy and scanning electron microscopy results show that the membrane roughness was enhanced with increasing Rq. The height distribution results also show the best height distribution for the modified membrane at low Rq. The selectivity and flux decreased with increasing nanolayer Rq in the membranes. The selectivity was also decreased initially with increases in the substrate and annealing temperatures from 300 to 325 K in the membranes and then showed an increasing trend. An opposite trend was found for flux with variations in the temperature. The modified membrane containing a 20‐nm Ag nanolayer at low Rq showed better performance compared to the other modified membranes and the pristine one. © 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2014, 131, 40025.
- 17 October 2013
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 131 (6)
Fabrication and modification of acrylonitrile–butadiene–styrene‐based heterogeneous ion‐exchange membranes by plasma treatment: Investigation of the nanolayer deposition rate and temperature effects
Our target in this study was the preparation of electrodialysis ion‐exchange membranes with appropriate properties for applications in water recovery and treatment. Composite mixed‐matrix, anion‐exchange membranes were prepared by a solution casting technique with acrylonitrile–butadiene–styrene as a base binder, resin powder as a functional group agent, activated carbon as an adsorptive filler, and an Ag nanolayer as a surface modifier. The Ag nanolayer was used with a magnetron sputtering method. The effect of the nanolayer deposition rate (Rq) and substrate and annealing temperatures on the physicochemical characteristics of the membranes were studied. The X‐ray diffraction results show that average grain size of the nanolayer and membrane crystallinity were improved with increasing Rq. The atomic force microscopy and scanning electron microscopy results show that the membrane roughness was enhanced with increasing Rq. The height distribution results also show the best height distribution for the modified membrane at low Rq. The selectivity and flux decreased with increasing nanolayer Rq in the membranes. The selectivity was also decreased initially with increases in the substrate and annealing temperatures from 300 to 325 K in the membranes and then showed an increasing trend. An opposite trend was found for flux with variations in the temperature. The modified membrane containing a 20‐nm Ag nanolayer at low Rq showed better performance compared to the other modified membranes and the pristine one. © 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2014, 131, 40025.
- 13 October 2013
- Published by Springer Nature in Journal of Polymer Research
- Vol. 20 (11) , 1-9
Electrochemical, morphological and antibacterial characterization of PVC based cation exchange membrane modified by zinc oxide nanoparticles
- 13 October 2013
- Published by Springer Nature in Journal of Polymer Research
- Vol. 20 (11) , 1-9
Electrochemical, morphological and antibacterial characterization of PVC based cation exchange membrane modified by zinc oxide nanoparticles