Daisuke Ito
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Daisuke Ito has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Hiroshige Kikura
Tokyo Institute of Technology
2 shared publications - Masanori Aritomi
Tokyo Institute of Technology
2 shared publications Horst-Michael Prasser
Department of Mechanical and Process Engineering, ETH Zurich, Zurich, Switzerland
1 shared publicationManuel Damsohn
Department of Mechanical and Process Engineering, ETH Zurich, Zurich, Switzerland
1 shared publicationMasanori Aritomi
Research Laboratory for Nuclear Reactors, Tokyo Institute of Technology, Meguro-ku, Japan
1 shared publication
Latest Publications
- 3 May 2011
- Published by Springer Nature in Experiments in Fluids
- Vol. 51 (3) , 821-833
Dynamic film thickness between bubbles and wall in a narrow channel
- 3 May 2011
- Published by Springer Nature in Experiments in Fluids
- Vol. 51 (3) , 821-833
Dynamic film thickness between bubbles and wall in a narrow channel
- 1 January 2009
- Published by Japan Society of Mechanical Engineers in The Proceedings of the National Symposium on Power and Energy Systems
- Vol. 2009.14, 115-116
D110 Gas-liquid two-phase flow measurement in narrow channel using micro wire-mesh sensor
A micro wire-mesh sensor (μWMS) based on an electrical conductivity measurement was developed for gas-liquid two-phase flow measurement in a narrow channel. The measuring method applies a principle of conventional wire-mesh tomography, which can measure the instantaneous void fraction distributions in the cross-section of the flow channel. In μWMS for narrow two-phase flow, the electrodes are fixed on the inner wall of the narrow channel, and the local void fractions were obtained by the electrical conductivity measurement between electrodes arranged on each wall. Therefore, the flow structure and the bubble behavior can be investigated in the channel with narrow gap. In this paper, a μWMS between parallel flat plates was developed for measurements of instantaneous void fraction distributions. The measured results were compared with high speed camera images, and three-dimensional bubble distributions were reconstructed from the void fraction distributions.
- 1 January 2009
- Published by Japan Society of Mechanical Engineers in The Proceedings of the National Symposium on Power and Energy Systems
- Vol. 2009.14, 115-116
D110 Gas-liquid two-phase flow measurement in narrow channel using micro wire-mesh sensor
A micro wire-mesh sensor (μWMS) based on an electrical conductivity measurement was developed for gas-liquid two-phase flow measurement in a narrow channel. The measuring method applies a principle of conventional wire-mesh tomography, which can measure the instantaneous void fraction distributions in the cross-section of the flow channel. In μWMS for narrow two-phase flow, the electrodes are fixed on the inner wall of the narrow channel, and the local void fractions were obtained by the electrical conductivity measurement between electrodes arranged on each wall. Therefore, the flow structure and the bubble behavior can be investigated in the channel with narrow gap. In this paper, a μWMS between parallel flat plates was developed for measurements of instantaneous void fraction distributions. The measured results were compared with high speed camera images, and three-dimensional bubble distributions were reconstructed from the void fraction distributions.
- Open Access
- 1 January 2008
- Published by The Visualization Society of Japan in Journal of the Visualization Society of Japan
- Vol. 28 (2) , 1097
Visualization of bubbly flow using an ultrasonic array sensor
- 1 January 2008
- Published by The Visualization Society of Japan in Journal of the Visualization Society of Japan
- Vol. 28 (2) , 1097
Open AccessVisualization of bubbly flow using an ultrasonic array sensor