Edsger C. P. Smits
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Edsger C. P. Smits has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Gerwin H. Gelinck
Holst Centre/TNO High Tech Campus 31 5656AE Eindhoven The Netherlands
2 shared publicationsAlbert J.J.M. van Breemen
1 shared publicationAlfred Neuhold
Institute of Solid State Physics, Graz University of Technology, Petersgasse 16, A‐8010 Graz, Austria
1 shared publicationAndreas Ringk
Macromolecular Chemistry I, University of Bayreuth, 95440 Bayreuth, Germany
1 shared publicationArmin Moser
Institute of Solid State Physics, Graz University of Technology, Petersgasse 16, A‐8010 Graz, Austria
1 shared publicationCees Van der Marel
Philips Innovation Services–Materials Analysis, High Tech Campus 11, 5656 AE Eindhoven, The Netherlands
1 shared publication
Latest Publications
- 3 December 2018
- Published by Wiley in Advanced Electronic Materials
- Vol. 5 (2)
Large‐Area All‐Printed Temperature Sensing Surfaces Using Novel Composite Thermistor Materials
Surfaces which can accurately distinguish spatial and temporal changes in temperature are critical for not only flow sensors, microbolometers, process control, but also future applications like electronic skins and soft robotics. Realizing such surfaces requires the deposition of thousands of thermal sensors over large areas, a task ideally suited for printing technologies. Negative temperature coefficient (NTC) ceramics represent the industry standard in temperature sensing due to their high thermal coefficient and excellent stability. A drawback is their complex and high temperature fabrication process and high stiffness, prohibiting their monolithic integration in large area or flexible applications. As a remedy, a printable NTC composite that combines a rapid and scalable all‐printed fabrication process with performances that are on par with conventional NTC ceramics is demonstrated. The composite consists of micrometer‐sized manganese spinel oxide particles dispersed in a benzocyclobutene matrix. The sensor has a B coefficient of 3500 K, with a 4.0% change in resistance at 25 °C, comparable to bulk ceramics. The selected polymer binder yields a composite exhibiting less than a 1 °C change in resistance to changes in humidity. The sensor's scalability is validated by demonstration of a A4‐sized temperature sensing sheet consisting of over 400 sensors.
- 3 December 2018
- Published by Wiley in Advanced Electronic Materials
- Vol. 5 (2)
Large‐Area All‐Printed Temperature Sensing Surfaces Using Novel Composite Thermistor Materials
Surfaces which can accurately distinguish spatial and temporal changes in temperature are critical for not only flow sensors, microbolometers, process control, but also future applications like electronic skins and soft robotics. Realizing such surfaces requires the deposition of thousands of thermal sensors over large areas, a task ideally suited for printing technologies. Negative temperature coefficient (NTC) ceramics represent the industry standard in temperature sensing due to their high thermal coefficient and excellent stability. A drawback is their complex and high temperature fabrication process and high stiffness, prohibiting their monolithic integration in large area or flexible applications. As a remedy, a printable NTC composite that combines a rapid and scalable all‐printed fabrication process with performances that are on par with conventional NTC ceramics is demonstrated. The composite consists of micrometer‐sized manganese spinel oxide particles dispersed in a benzocyclobutene matrix. The sensor has a B coefficient of 3500 K, with a 4.0% change in resistance at 25 °C, comparable to bulk ceramics. The selected polymer binder yields a composite exhibiting less than a 1 °C change in resistance to changes in humidity. The sensor's scalability is validated by demonstration of a A4‐sized temperature sensing sheet consisting of over 400 sensors.
- 30 September 2014
- Published by Springer Nature in Journal of Fluorescence
- Vol. 24 (6) , 1735-1744
Gas Response Behaviour and Photochemistry of Borondiketonate in Acrylic Polymer Matrices for Sensing Applications
The fluorescent spectra in combination with gas response behavior of acrylic polymers doped with dibenzoyl(methanato)boron difluoride (DBMBF2) were studied by fluorescence spectroscopy and time-resolved fluorescence lifetime. The role of acrylic matrix polarity upon the fluorescence spectra and fluorescence lifetime was analyzed. Changes in emission of the dye doped polymers under exposure to toluene, n-hexane and ethanol were monitored. The fluorescence lifetimes were measured for the singlet excited state as well as the exciplex formed between DBMBF2 and toluene. A reduction of the transition energy to the first singlet-excited state in the four polymers was observed, compared to solution. Reversible exciplex formation, viz. a red shifted fluorescence emission was perceived when exposing the polymers to toluene, while for hexane and ethanol only reversible reduction of the fluorescence occurred. Longer singlet and shorter exciplex lifetimes were observed for non-polar matrixes. The latter mechanism is explained in function of the lower charge transfer character of the exciplex in non-polar matrixes. Additionally, the quantum yield of the dye in the polymer matrix increased almost seventh-fold compared to values for solution.
- 30 September 2014
- Published by Springer Nature in Journal of Fluorescence
- Vol. 24 (6) , 1735-1744
Gas Response Behaviour and Photochemistry of Borondiketonate in Acrylic Polymer Matrices for Sensing Applications
The fluorescent spectra in combination with gas response behavior of acrylic polymers doped with dibenzoyl(methanato)boron difluoride (DBMBF2) were studied by fluorescence spectroscopy and time-resolved fluorescence lifetime. The role of acrylic matrix polarity upon the fluorescence spectra and fluorescence lifetime was analyzed. Changes in emission of the dye doped polymers under exposure to toluene, n-hexane and ethanol were monitored. The fluorescence lifetimes were measured for the singlet excited state as well as the exciplex formed between DBMBF2 and toluene. A reduction of the transition energy to the first singlet-excited state in the four polymers was observed, compared to solution. Reversible exciplex formation, viz. a red shifted fluorescence emission was perceived when exposing the polymers to toluene, while for hexane and ethanol only reversible reduction of the fluorescence occurred. Longer singlet and shorter exciplex lifetimes were observed for non-polar matrixes. The latter mechanism is explained in function of the lower charge transfer character of the exciplex in non-polar matrixes. Additionally, the quantum yield of the dye in the polymer matrix increased almost seventh-fold compared to values for solution.
- 19 November 2012
- Published by Wiley in Advanced Functional Materials
- Vol. 23 (16) , 2016-2023
N‐Type Self‐Assembled Monolayer Field‐Effect Transistors and Complementary Inverters
This work describes n‐type self‐assembled monolayer field‐effect transistors (SAMFETs) based on a perylene derivative which is covalently fixed to an aluminum oxide dielectric via a phosphonic acid linker. N‐type SAMFETs spontaneously formed by a single layer of active molecules are demonstrated for transistor channel length up to 100 μm. Highly reproducible transistors with electron mobilities of 1.5 × 10−3 cm2 V−1 s−1 and on/off current ratios up to 105 are obtained. By implementing n‐type and p‐type transistors in one device, a complimentary inverter based solely on SAMFETs is demonstrated for the first time.
- 19 November 2012
- Published by Wiley in Advanced Functional Materials
- Vol. 23 (16) , 2016-2023
N‐Type Self‐Assembled Monolayer Field‐Effect Transistors and Complementary Inverters
This work describes n‐type self‐assembled monolayer field‐effect transistors (SAMFETs) based on a perylene derivative which is covalently fixed to an aluminum oxide dielectric via a phosphonic acid linker. N‐type SAMFETs spontaneously formed by a single layer of active molecules are demonstrated for transistor channel length up to 100 μm. Highly reproducible transistors with electron mobilities of 1.5 × 10−3 cm2 V−1 s−1 and on/off current ratios up to 105 are obtained. By implementing n‐type and p‐type transistors in one device, a complimentary inverter based solely on SAMFETs is demonstrated for the first time.
- 30 September 2012
- Published by Elsevier in Organic Electronics
- Vol. 13 (9) , 1742-1749
Programmable polymer light emitting transistors with ferroelectric polarization-enhanced channel current and light emission
- 30 September 2012
- Published by Elsevier in Organic Electronics
- Vol. 13 (9) , 1742-1749
Programmable polymer light emitting transistors with ferroelectric polarization-enhanced channel current and light emission