Qiang Cheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Qiang Cheng has a total of 154 co-authors. Here are the top co-authors by number of shared publications:
Jinlin Song
34 shared publicationsZixue Luo
25 shared publications- Huaichun Zhou
Xihua University, China
19 shared publications Lu Lu
Hubei Key Laboratory for High-Efficiency Utilization of Solar Energy and Operation Control of Energy Storage System, Hubei University of Technology, Wuhan 430068, Hubei, People’s Republic of China
19 shared publicationsKun Zhou
State Key Laboratory of Coal Combustion School of Energy and Power Engineering Huazhong University of Science and Technology Wuhan Hubei 430074 China
17 shared publications- Zixue Luo
State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology, Wuhan 430074, China
15 shared publications
Latest Publications
- Open Access
- 10 June 2026
- Published by Frontiers Media SA in Frontiers in Thermal Engineering
- Vol. 6, 1864229
Regulation of near-field radiative heat transfer between two-dimensional borophene sheets under uniaxial strain based on first-principles calculations
This study investigates the near field radiative heat transfer (NFRHT) regulation behavior of χ 3 -phase two-dimensional borophene (Bχ 3 ) sheets under uniaxial strain, based on first-principles calculations and fluctuation-dissipation theory. By analyzing the dielectric functions and spectral heat transfer coefficients of borophene under different strain conditions, the near-field radiative heat transfer properties of single-layer and bilayer borophene under x / y -axis strain are explored, where the x -direction corresponds to the Bχ 3 lattice direction a , and the y -axis is perpendicular to the x -axis. Results indicate that strain significantly alters the optical properties of borophene. Under x -axis strain, the normalized heat transfer coefficient first decreases then increases with strain, reaching a maximum increase of 3.6 times compared to the unstrained state. In contrast, y -axis strain exhibits a monotonic increase, with a maximum enhancement of approximately 126 times. Furthermore, bilayer borophene exhibited more pronounced near-field radiative heat transfer modulation effects than monolayer borophene, particularly under tensile strain. The study demonstrates that carefully designing the direction and magnitude of strain enables precise control over near-field heat transport, providing a theoretical basis for developing efficient thermal management devices based on borophene.
- 10 June 2026
- Published by Frontiers Media SA in Frontiers in Thermal Engineering
- Vol. 6, 1864229
Open AccessRegulation of near-field radiative heat transfer between two-dimensional borophene sheets under uniaxial strain based on first-principles calculations
This study investigates the near field radiative heat transfer (NFRHT) regulation behavior of χ 3 -phase two-dimensional borophene (Bχ 3 ) sheets under uniaxial strain, based on first-principles calculations and fluctuation-dissipation theory. By analyzing the dielectric functions and spectral heat transfer coefficients of borophene under different strain conditions, the near-field radiative heat transfer properties of single-layer and bilayer borophene under x / y -axis strain are explored, where the x -direction corresponds to the Bχ 3 lattice direction a , and the y -axis is perpendicular to the x -axis. Results indicate that strain significantly alters the optical properties of borophene. Under x -axis strain, the normalized heat transfer coefficient first decreases then increases with strain, reaching a maximum increase of 3.6 times compared to the unstrained state. In contrast, y -axis strain exhibits a monotonic increase, with a maximum enhancement of approximately 126 times. Furthermore, bilayer borophene exhibited more pronounced near-field radiative heat transfer modulation effects than monolayer borophene, particularly under tensile strain. The study demonstrates that carefully designing the direction and magnitude of strain enables precise control over near-field heat transport, providing a theoretical basis for developing efficient thermal management devices based on borophene.
- 25 March 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (13) , 9209-9216
Modulation of Near-Field Radiative Heat Transfer between Weyl Semimetal/hBN Multilayers
Weyl semimetals (WSMs) have attracted a considerable amount of attention in many fields due to their appealing optical properties. In this work, we study the near-field radiative heat transfer (NFRHT) between two WSM/hBN multilayer structures to analyze the coupling of surface plasmons of WSMs and nonresonant hyperbolic modes. We find that the WSM/hBN multilayer structure not only combines the SPPs and ENZ effect of WSM plates and HMs of hBN plates but also yields HSPPs that play an important role in the enhancement of NFRHT. Hence, a high total HTC of 1.80 × 104 W K-1 m-2 at d = 10 nm can be achieved, which is 1.89 and 6.45 times higher than the values of the pure WSM and pure hBN cases, respectively. The Fermi level and number of Weyl nodes of WSM plates allow for high tunability of NFRHT of the system. The effects of geometry and the topmost layer material on NFRHT are also discussed. We hope that our findings are beneficial for thermal management in WSM-based systems at the nanoscale.
- 25 March 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (13) , 9209-9216
Modulation of Near-Field Radiative Heat Transfer between Weyl Semimetal/hBN Multilayers
Weyl semimetals (WSMs) have attracted a considerable amount of attention in many fields due to their appealing optical properties. In this work, we study the near-field radiative heat transfer (NFRHT) between two WSM/hBN multilayer structures to analyze the coupling of surface plasmons of WSMs and nonresonant hyperbolic modes. We find that the WSM/hBN multilayer structure not only combines the SPPs and ENZ effect of WSM plates and HMs of hBN plates but also yields HSPPs that play an important role in the enhancement of NFRHT. Hence, a high total HTC of 1.80 × 104 W K-1 m-2 at d = 10 nm can be achieved, which is 1.89 and 6.45 times higher than the values of the pure WSM and pure hBN cases, respectively. The Fermi level and number of Weyl nodes of WSM plates allow for high tunability of NFRHT of the system. The effects of geometry and the topmost layer material on NFRHT are also discussed. We hope that our findings are beneficial for thermal management in WSM-based systems at the nanoscale.
- 11 March 2026
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 226
Broadband metamaterial absorber based on photon-assisted tunneling diode for solar power generation
- 11 March 2026
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 226
Broadband metamaterial absorber based on photon-assisted tunneling diode for solar power generation
- Open Access
Multi-Step Kinetic and Mechanistic Study of Oil-Based Drill Cuttings Pyrolysis Based on the Frazer–Suzuki Deconvolution Method
To achieve the safe reuse of oil-based drill cuttings, this study employs thermogravimetric analysis and pyrolysis-gas chromatography/mass spectrometry to investigate the formation patterns and kinetic characteristics of pyrolysis products in oil-based drill cuttings. The study included a broad temperature range of 100–980 °C and heating rates of 10, 15, and 20 K/min. Employing the Frazer–Suzuki approach from a multi-step-over-single-step perspective, six pseudo-processes (P1–P6) are isolated for the overall pyrolysis reaction of oil-based drill cuttings. Differences in contributions and activation energies were quantified for each stage. The activation energies for the six pseudo-processes are determined to be 60.81, −59.77, 421.10, 231.64, 225.96, and 349.04 kJ/mol, respectively. With increasing temperature, long-chain aliphatic hydrocarbons in products from oil-based drill cuttings pyrolysis tend to convert into short-chain hydrocarbons and form unsaturated hydrocarbons through dehydrogenation. The oil-based drill cuttings pyrolysis process does not follow a single mechanism but is primarily nucleation-controlled, incorporating multiple reaction mechanisms including geometric contraction, diffusion, and power-law effects.
Open AccessMulti-Step Kinetic and Mechanistic Study of Oil-Based Drill Cuttings Pyrolysis Based on the Frazer–Suzuki Deconvolution Method
To achieve the safe reuse of oil-based drill cuttings, this study employs thermogravimetric analysis and pyrolysis-gas chromatography/mass spectrometry to investigate the formation patterns and kinetic characteristics of pyrolysis products in oil-based drill cuttings. The study included a broad temperature range of 100–980 °C and heating rates of 10, 15, and 20 K/min. Employing the Frazer–Suzuki approach from a multi-step-over-single-step perspective, six pseudo-processes (P1–P6) are isolated for the overall pyrolysis reaction of oil-based drill cuttings. Differences in contributions and activation energies were quantified for each stage. The activation energies for the six pseudo-processes are determined to be 60.81, −59.77, 421.10, 231.64, 225.96, and 349.04 kJ/mol, respectively. With increasing temperature, long-chain aliphatic hydrocarbons in products from oil-based drill cuttings pyrolysis tend to convert into short-chain hydrocarbons and form unsaturated hydrocarbons through dehydrogenation. The oil-based drill cuttings pyrolysis process does not follow a single mechanism but is primarily nucleation-controlled, incorporating multiple reaction mechanisms including geometric contraction, diffusion, and power-law effects.
- 19 September 2024
- Published by Springer Nature in Science China Technological Sciences
- Vol. 67 (11) , 3405-3412
Surface plasmon-coupled radiative heat transfer between graphene-covered magnetic Weyl semimetals
- 19 September 2024
- Published by Springer Nature in Science China Technological Sciences
- Vol. 67 (11) , 3405-3412
Surface plasmon-coupled radiative heat transfer between graphene-covered magnetic Weyl semimetals
- 14 September 2024
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 208
Improved performance of thermophotovoltaic energy conversion with Tamm plasmon emitters enabled by back gapped reflectors
- 14 September 2024
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 208
Improved performance of thermophotovoltaic energy conversion with Tamm plasmon emitters enabled by back gapped reflectors
- 6 September 2024
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 208
Experimental observation of near-field thermal radiation between dielectric/organic multilayers
- 6 September 2024
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 208
Experimental observation of near-field thermal radiation between dielectric/organic multilayers