Janusz Wojdalski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Janusz Wojdalski has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Bogdan Dróżdż
Department of Production Management and Engineering
2 shared publications - Małgorzata Smuga-Kogut
Department of Mechanical and Power Engineering, Koszalin University of Technology, 75-620 Koszalin, Poland
2 shared publications - Adam Ekielski
Department of Production Engineering, Institute of Mechanical Engineering, Warsaw University of Life Sciences (SGGW), Nowoursynowska 164, 02-787 Warsaw, Poland
1 shared publication Adam Kupczyk
Warsaw University of Life Sciences, Department of Production Management and Engineering, ul. Nowoursynowska 166, 02-787 Warsaw, Poland
1 shared publication- Adam Luberański
Institute of Agricultural Engineering, Wroclaw University of Environmental and Life Sciences
1 shared publication Anna Magryś
Warsaw University of Life Sciences
1 shared publication
Latest Publications
- 28 May 2019
- Published by HARD Publishing Company in Polish Journal of Environmental Studies
- Vol. 28 (5) , 3505-3511
Microbiological Analysis and Concentration of Organic Dust in an Herb Processing Plant
In the dust of organic plant origin the presence of micro organisms, particularly moulds and endotoxins, is recorded to have harmful effects on the human body and cause many diseases. The microbiological quality of the processed plants is largely dependent on the fragment of the plant used as raw material, since the microbial contaminants are the result of different contacts of each particular part of the plant with the external environment during cultivation and further processing. Organic dust present in the plant raw material may be varied not only in terms of microbial contamination, but also regarding the size of particles thereof. In the presented study an attempt was made to identify fungi found in the organic dust sampled in an herb processing plant located in eastern Poland. The concentrations of PM10 and PM 1.0 were determined within two production lines, and these values were then referred to the existing regulations. The mean concentration of PM10 significantly exceeded the alert level. University of Life Sciences in Lublin, Department of Food Engineering and Machines, Doświadczalna 44, 20-280 Lublin, Poland
- 28 May 2019
- Published by HARD Publishing Company in Polish Journal of Environmental Studies
- Vol. 28 (5) , 3505-3511
Microbiological Analysis and Concentration of Organic Dust in an Herb Processing Plant
In the dust of organic plant origin the presence of micro organisms, particularly moulds and endotoxins, is recorded to have harmful effects on the human body and cause many diseases. The microbiological quality of the processed plants is largely dependent on the fragment of the plant used as raw material, since the microbial contaminants are the result of different contacts of each particular part of the plant with the external environment during cultivation and further processing. Organic dust present in the plant raw material may be varied not only in terms of microbial contamination, but also regarding the size of particles thereof. In the presented study an attempt was made to identify fungi found in the organic dust sampled in an herb processing plant located in eastern Poland. The concentrations of PM10 and PM 1.0 were determined within two production lines, and these values were then referred to the existing regulations. The mean concentration of PM10 significantly exceeded the alert level. University of Life Sciences in Lublin, Department of Food Engineering and Machines, Doświadczalna 44, 20-280 Lublin, Poland
- Open Access
Comparison of Bioethanol Preparation from Triticale Straw Using the Ionic Liquid and Sulfate Methods
Triticale straw constitutes a potential raw material for biofuel production found in Poland in considerable quantities. Thus far, production of bioethanol has been based on food raw materials such as cereal seeds, sugar beets or potatoes, and the biofuel production methods developed for these lignocellulose raw materials can threaten the environment and are inefficient. Therefore, this study aimed to compare of methods for pretreatment of triticale straw using 1-ethyl-3-methylimidazolium acetate and the sulfate method in the aspect of ethanol production intended for fuel. Based on the conducted experiments it has been determined that the use of 1-ethyl-3-methylimidazolium acetate for the pretreatment of triticale straw resulted in an increase of reducing sugars after enzymatic hydrolysis and ethyl alcohol after alcoholic fermentation. Furthermore, the study compared the efficiency of enzymatic hydrolysis of triticale straw without pretreatment, after processing with ionic liquid, recycled ionic liquid and using sulfate method, allowing a comparison of these methods. The more favorable method of lignocellulose material purification was the use of ionic liquid, due to the lower amount of toxic byproducts formed during the process, and the efficiency test results of bioethanol production using pretreatment with ionic liquid and sulfate method were similar. Ionic liquid recycling after pretreatment of rye straw using lyophilization allowed us to reuse this solvent to purify rye straw, yet the efficiency of this method remained at a low level. As a result of the conducted study it was determined that the use of ionic liquid-1-ethyl-3-methylimidazolium acetate enhanced the yield of bioethanol from triticale straw from 1.60 g/dm3 after processing without pre-treatment to 10.64 g/dm3 after pre-treatment.
Open AccessComparison of Bioethanol Preparation from Triticale Straw Using the Ionic Liquid and Sulfate Methods
Triticale straw constitutes a potential raw material for biofuel production found in Poland in considerable quantities. Thus far, production of bioethanol has been based on food raw materials such as cereal seeds, sugar beets or potatoes, and the biofuel production methods developed for these lignocellulose raw materials can threaten the environment and are inefficient. Therefore, this study aimed to compare of methods for pretreatment of triticale straw using 1-ethyl-3-methylimidazolium acetate and the sulfate method in the aspect of ethanol production intended for fuel. Based on the conducted experiments it has been determined that the use of 1-ethyl-3-methylimidazolium acetate for the pretreatment of triticale straw resulted in an increase of reducing sugars after enzymatic hydrolysis and ethyl alcohol after alcoholic fermentation. Furthermore, the study compared the efficiency of enzymatic hydrolysis of triticale straw without pretreatment, after processing with ionic liquid, recycled ionic liquid and using sulfate method, allowing a comparison of these methods. The more favorable method of lignocellulose material purification was the use of ionic liquid, due to the lower amount of toxic byproducts formed during the process, and the efficiency test results of bioethanol production using pretreatment with ionic liquid and sulfate method were similar. Ionic liquid recycling after pretreatment of rye straw using lyophilization allowed us to reuse this solvent to purify rye straw, yet the efficiency of this method remained at a low level. As a result of the conducted study it was determined that the use of ionic liquid-1-ethyl-3-methylimidazolium acetate enhanced the yield of bioethanol from triticale straw from 1.60 g/dm3 after processing without pre-treatment to 10.64 g/dm3 after pre-treatment.
- Open Access
- 1 September 2015
- Published by Walter de Gruyter GmbH in Polish Journal of Chemical Technology
- Vol. 17 (3) , 89-94
Production of ethanol from wheat straw
This study proposes a method for the production of ethanol from wheat straw lignocellulose where the raw material is chemically processed before hydrolysis and fermentation. The usefulness of wheat straw delignification was evaluated with the use of a 4:1 mixture of 95% ethanol and 65% HNO3 (V). Chemically processed lignocellulose was subjected to enzymatic hydrolysis to produce reducing sugars, which were converted to ethanol in the process of alcoholic fermentation. Chemical processing damages the molecular structure of wheat straw, thus improving ethanol yield. The removal of lignin from straw improves fermentation by eliminating lignin’s negative influence on the growth and viability of yeast cells. Straw pretreatment facilitates enzymatic hydrolysis by increasing the content of reducing sugars and ethanol per g in comparison with untreated wheat straw.
- 1 September 2015
- Published by Walter de Gruyter GmbH in Polish Journal of Chemical Technology
- Vol. 17 (3) , 89-94
Open AccessProduction of ethanol from wheat straw
This study proposes a method for the production of ethanol from wheat straw lignocellulose where the raw material is chemically processed before hydrolysis and fermentation. The usefulness of wheat straw delignification was evaluated with the use of a 4:1 mixture of 95% ethanol and 65% HNO3 (V). Chemically processed lignocellulose was subjected to enzymatic hydrolysis to produce reducing sugars, which were converted to ethanol in the process of alcoholic fermentation. Chemical processing damages the molecular structure of wheat straw, thus improving ethanol yield. The removal of lignin from straw improves fermentation by eliminating lignin’s negative influence on the growth and viability of yeast cells. Straw pretreatment facilitates enzymatic hydrolysis by increasing the content of reducing sugars and ethanol per g in comparison with untreated wheat straw.
- Open Access
- 1 July 2013
- Published by Walter de Gruyter GmbH in Polish Journal of Chemical Technology
- Vol. 15 (2) , 61-72
Determinants of water consumption in the dairy industry
This paper analyzes the correlations between selected technical, process and production factors, equipment profiles and water consumption statistics in four types of dairy plants. Dairy plants were surveyed both individually and in groups. Water consumption was most highly correlated (r > 0.868) with equipment profiles. The highest water consumption was observed in dairy plants operating milk powder departments. In those plants, organization and production factors could significantly reduce water consumption levels because in addition to milk powder, those plants also supplied eight other products. The indicators of water consumption per unit of the final product were correlated (at 0.820 > | r | > 0.663) with equipment profiles, the degree of process automation and employment. Variations in water consumption per unit of the final product were best explained in small plants supplying several products. The presented equations can be used to optimize water demand of various types of equipment and to determine the correlations with energy consumption for wastewater treatment. Our results can contribute to the development of water consumption models in dairy plants and the implementation of clean production standards.
- 1 July 2013
- Published by Walter de Gruyter GmbH in Polish Journal of Chemical Technology
- Vol. 15 (2) , 61-72
Open AccessDeterminants of water consumption in the dairy industry
This paper analyzes the correlations between selected technical, process and production factors, equipment profiles and water consumption statistics in four types of dairy plants. Dairy plants were surveyed both individually and in groups. Water consumption was most highly correlated (r > 0.868) with equipment profiles. The highest water consumption was observed in dairy plants operating milk powder departments. In those plants, organization and production factors could significantly reduce water consumption levels because in addition to milk powder, those plants also supplied eight other products. The indicators of water consumption per unit of the final product were correlated (at 0.820 > | r | > 0.663) with equipment profiles, the degree of process automation and employment. Variations in water consumption per unit of the final product were best explained in small plants supplying several products. The presented equations can be used to optimize water demand of various types of equipment and to determine the correlations with energy consumption for wastewater treatment. Our results can contribute to the development of water consumption models in dairy plants and the implementation of clean production standards.
- 18 July 2012
- Published by Springer Nature in Food and Bioprocess Technology
- Vol. 6 (10) , 2621-2629
Assessment of Energy Consumption in a Meat-Processing Plant—a Case Study
- 18 July 2012
- Published by Springer Nature in Food and Bioprocess Technology
- Vol. 6 (10) , 2621-2629
Assessment of Energy Consumption in a Meat-Processing Plant—a Case Study