BAB. Abdulhay

B. Abdulhay

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


B. Abdulhay has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Experimental approach for thermal parameters estimation during glass forming process

    by B. Abdulhay, B. Bourouga, F. Alzetto, C. Challita

    In this paper, an experimental device designed and developedto estimate thermal conditions at the Glass / piston contact interface is presented. This deviceis made of two parts: the upper part contains the piston made of metal and a heating device to raise the temperature of the piston up to 500 °C. The lower part is composed of a lead crucible and a glass sample. The assembly is provided with a heating system, an induction furnace of 6 kW for heating the glass up to 950 °C.The developed experimental procedure has permitted in a previous published study to estimate the Thermal Contact Resistance TCR using the inverse technique developed by Beck [1]. The semi-transparent character of the glass has been taken into account by an additional radiative heat flux and an equivalent thermal conductivity. After the set-up tests, reproducibility experiments for a specific contact pressure have been carried outwith a maximum dispersion that doesn’t exceed 6%. Then, experiments under different conditions for a specific glass forming process regarding the application (Packaging, Buildings and Automobile) were carried out. The objective is to determine, experimentallyfor each application,the typical conditions capable to minimize the glass temperature loss during the glass forming process.

  • Development of an Experimental Procedure for Thermal Contact Resistance Estimation at the Glass/Metal Contact Interface

    by B. Abdulhay, B. Bourouga, F. Alzetto, C. Challita

    In this paper, an experimental device is designed and developed in order to estimate thermal conditions at the glass/metal contact interface. This device is made of two parts: The upper part contains the tool (piston) made of bronze and a heating device to raise the temperature of the piston to 700 °C. The lower part is composed of a lead crucible and a glass sample. The assembly is provided with a heating system, an induction furnace of 6 kW for heating the glass up to 950 °C. The developed experimental procedure has permitted the estimation of the thermal contact resistance (TCR) using a developed measurement principle based on the inverse technique developed by Beck et al. (1985, Inverse Heat Conduction: III Posed Problems, Wiley Inter-science, New York). The semitransparent character of the glass has been taken into account by an additional radiative heat flux and an equivalent thermal conductivity. After the set-up tests, reproducibility experiments for a specific contact pressure have been carried out. Results show a good repeatability of the registered and estimated parameters such as the piston surface temperature, heat flux density, and TCR. The estimated value of TCR reaches 2 × 10−3 K m2/W with a maximum dispersion that does not exceed 6%.