Khalid Sbiaai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Khalid Sbiaai has a total of 99 co-authors. Here are the top co-authors by number of shared publications:
- Abdellatif Hasnaoui
Sultan Moulay Slimane University of Beni Mellal, Polydisciplinary Faculty of Khouribga, LS2ME Laboratory, B.P. 145, 25000 Khouribga, Morocco
18 shared publications Y. Boughaleb
Laboratory of Condensed Matter Physics (LCMP), Univ. Chouaib Doukkali, El Jadida, Morocco
12 shared publications- Abdessamad Hassani
Laboratory LS3M, Polydisciplinary Faculty, Sultan Moulay Slimane University of Beni Mellal, Khouribga, Morocco
10 shared publications M. Mazroui
8 shared publicationsYahia Boughaleb
Univ. Chouaib Doukkali
8 shared publicationsA. Arbaoui
Laboratory of Condensed Matter Physics (LCMP), Univ. Chouaib Doukkali, El Jadida, Morocco
5 shared publications
Latest Publications
- 19 January 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (5) , 4216-4229
Kinetic Monte Carlo simulation of polycrystalline silver metal electrodeposition: scaling of roughness and effects of deposition parameters
In this work, a kinetic Monte Carlo (KMC) technique was used to simulate the growth morphology of electrodeposited polycrystalline Ag thin films under a galvanostatic condition (current density). The many-body Embedded Atom Method (EAM) potential has been used to describe the Ag–Ag atomic interaction. Herein, the surface morphology is affected by the kinetic diffusion of adatoms where four jump processes are considered, namely hopping, exchange, step-edge exchange and grain boundary. The results have shown that the surface roughness follows a power law behavior versus film thickness (∝Lα) and time (∝tβ), with the roughness and growth exponents α and β found to be α = 1.14 ± 0.01 and β = 0.57 ± 0.01. The surface morphology under different deposition parameters (current density and substrate temperature) has been discussed in detail. The surface roughness increases where the current density increases due to high deposition rates, which can accelerate the growth of island mode, especially on the (111) surface. In contrast, the surface roughness decreases the temperature of the substrate increases due to thermal agitation, allowing to transform nearly columnar grains to grains with a flat and smooth surface. Finally, the simulations provided information on the subsurface deposition rate of each grain that is not directly available for experimental investigations. It was observed that the (111) grain has a faster deposition rate compared to the (100) and (110) grains due to the low surface energy of the (111) grain.
- 19 January 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (5) , 4216-4229
Kinetic Monte Carlo simulation of polycrystalline silver metal electrodeposition: scaling of roughness and effects of deposition parameters
In this work, a kinetic Monte Carlo (KMC) technique was used to simulate the growth morphology of electrodeposited polycrystalline Ag thin films under a galvanostatic condition (current density). The many-body Embedded Atom Method (EAM) potential has been used to describe the Ag–Ag atomic interaction. Herein, the surface morphology is affected by the kinetic diffusion of adatoms where four jump processes are considered, namely hopping, exchange, step-edge exchange and grain boundary. The results have shown that the surface roughness follows a power law behavior versus film thickness (∝Lα) and time (∝tβ), with the roughness and growth exponents α and β found to be α = 1.14 ± 0.01 and β = 0.57 ± 0.01. The surface morphology under different deposition parameters (current density and substrate temperature) has been discussed in detail. The surface roughness increases where the current density increases due to high deposition rates, which can accelerate the growth of island mode, especially on the (111) surface. In contrast, the surface roughness decreases the temperature of the substrate increases due to thermal agitation, allowing to transform nearly columnar grains to grains with a flat and smooth surface. Finally, the simulations provided information on the subsurface deposition rate of each grain that is not directly available for experimental investigations. It was observed that the (111) grain has a faster deposition rate compared to the (100) and (110) grains due to the low surface energy of the (111) grain.
- 22 March 2022
- Published by Wiley in Physica Status Solidi (b)
- Vol. 259 (7)
Morphological Surface Study of Silver Electrodeposition by Kinetic Monte Carlo‐Embedded Atom Method
Herein, a kinetic Monte Carlo (KMC) simulation of the 3D electrodeposition of Ag metal on Ag cathode surface is carried out under galvanostatic, different substrate temperatures, and current density conditions. Both deposition and diffusion processes are considered during the film electrodeposition, where each adatom diffuses via nearest‐neighbor hopping, exchange, and step‐edge atom exchange mechanisms. The interatomic interaction is described within the well‐known embedded atomic method (EAM) framework. The number of hopping, exchange, and step‐edge exchange mechanisms is evaluated using a power law of time , , and , respectively. However, the step‐edge exchange mechanism depends on current density. The effects of deposited atom number, current density, and substrate temperature on the transitions of surface morphologies of the electrodeposited thin film are studied considering different combinations of the mechanisms. The results indicate that surface roughness increases when the number of deposited atoms and the current density increase, but when the substrate temperature increases the roughness decreases. In addition, the resulting surface has been found to be smooth if all diffusion mechanisms are involved in the electrodeposition phenomenon, while roughness occurs when diffusion takes place only via hopping mechanism. Furthermore, the surface roughness behavior is found to be related to clusters and islands distribution.
- 22 March 2022
- Published by Wiley in Physica Status Solidi (b)
- Vol. 259 (7)
Morphological Surface Study of Silver Electrodeposition by Kinetic Monte Carlo‐Embedded Atom Method
Herein, a kinetic Monte Carlo (KMC) simulation of the 3D electrodeposition of Ag metal on Ag cathode surface is carried out under galvanostatic, different substrate temperatures, and current density conditions. Both deposition and diffusion processes are considered during the film electrodeposition, where each adatom diffuses via nearest‐neighbor hopping, exchange, and step‐edge atom exchange mechanisms. The interatomic interaction is described within the well‐known embedded atomic method (EAM) framework. The number of hopping, exchange, and step‐edge exchange mechanisms is evaluated using a power law of time , , and , respectively. However, the step‐edge exchange mechanism depends on current density. The effects of deposited atom number, current density, and substrate temperature on the transitions of surface morphologies of the electrodeposited thin film are studied considering different combinations of the mechanisms. The results indicate that surface roughness increases when the number of deposited atoms and the current density increase, but when the substrate temperature increases the roughness decreases. In addition, the resulting surface has been found to be smooth if all diffusion mechanisms are involved in the electrodeposition phenomenon, while roughness occurs when diffusion takes place only via hopping mechanism. Furthermore, the surface roughness behavior is found to be related to clusters and islands distribution.
- Open Access
- 5 April 2021
- Published by Springer Nature in Journal of Molecular Modeling
- Vol. 27 (5) , 1-13
Shape transition and coalescence of Au islands on Ag (110) by molecular dynamics simulation
We have used molecular dynamics simulations based on many body semi-empirical potentials described by the embedded atom method, to analyze and understand the diffusion and coalescence phenomena of Au-clusters during the heteroepitaxial growth on Ag (110) surface. Temperature ranging from 300 to 700 K were considered. In this study, we examined the heterogeneous system Aun/Ag(110), where n is the number of atoms in each cluster/island (with n = 15, ….35). Our results show that the clusters diffuse on the Ag (110) surface via different diffusion processes, namely, the exchange mechanism and the simple jump, which generate a 2D to 3D transition. Formation and adsorption energies of clusters with different sizes have been computed using static simulations. The dynamic study of coalescence for two islands of system Au15; Au0 − 9/Ag(110) at different temperatures makes it possible to deduce the detail of cluster shape and the influence of its temperature on the stability of the system and its growth during this evolution.
- 5 April 2021
- Published by Springer Nature in Journal of Molecular Modeling
- Vol. 27 (5) , 1-13
Open AccessShape transition and coalescence of Au islands on Ag (110) by molecular dynamics simulation
We have used molecular dynamics simulations based on many body semi-empirical potentials described by the embedded atom method, to analyze and understand the diffusion and coalescence phenomena of Au-clusters during the heteroepitaxial growth on Ag (110) surface. Temperature ranging from 300 to 700 K were considered. In this study, we examined the heterogeneous system Aun/Ag(110), where n is the number of atoms in each cluster/island (with n = 15, ….35). Our results show that the clusters diffuse on the Ag (110) surface via different diffusion processes, namely, the exchange mechanism and the simple jump, which generate a 2D to 3D transition. Formation and adsorption energies of clusters with different sizes have been computed using static simulations. The dynamic study of coalescence for two islands of system Au15; Au0 − 9/Ag(110) at different temperatures makes it possible to deduce the detail of cluster shape and the influence of its temperature on the stability of the system and its growth during this evolution.
- 22 September 2020
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 91 (3) , 30301
NiAl thin film growth on Ni(001) substrate using molecular dynamics simulations
We have studied thin film growth of NiAl on Nickel (001) substrate using molecular dynamics simulations (MD) based on the Embedded Atom Method (EAM) potential. An incidence energy of 0.06eV at 800K, 900K and 1000K was considered. After the deposition process, we have obtained a B2-NiAl structure film with different percentages; 32.6% for the temperature 1000K, 30% for 900K and 25% for 800K. Our investigation has prompt us to analyze the crystalline structure. During the evolution of deposited film, we observe the formation of grains with different orientation, as well as the appearance of vacancies in Ni and Al sublattices and antisites.
- 22 September 2020
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 91 (3) , 30301
NiAl thin film growth on Ni(001) substrate using molecular dynamics simulations
We have studied thin film growth of NiAl on Nickel (001) substrate using molecular dynamics simulations (MD) based on the Embedded Atom Method (EAM) potential. An incidence energy of 0.06eV at 800K, 900K and 1000K was considered. After the deposition process, we have obtained a B2-NiAl structure film with different percentages; 32.6% for the temperature 1000K, 30% for 900K and 25% for 800K. Our investigation has prompt us to analyze the crystalline structure. During the evolution of deposited film, we observe the formation of grains with different orientation, as well as the appearance of vacancies in Ni and Al sublattices and antisites.
- 2 November 2019
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 693 (1) , 39-48
Anisotropy diffusion in monolayer growth of Au on Cu (110) by kinetic Monte Carlo method
Morphological and Structural transitions during epitaxial growth of surface and interface are an important nanoscal phenomena. Understanding the diffusion of adatom in anisotropic surface on the fcc (110), presents a challenge because of the various processes and energy activation of diffusion. During monolayer formation, adatoms could aggregate and forming islands. the stability of these latter is related the its shapes and adatom bonding. In this work, we used the Kinetic Monte Carlo method, implementing anisotropic bond-breaking model (ABBM) to simulate the evolution of anisotropic islands. In order to discuss the monolayer growing, many parameters are taken into account such as potential barriers, temperatures, deposition rates at fixed coverage of 10% monolayer.
- 2 November 2019
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 693 (1) , 39-48
Anisotropy diffusion in monolayer growth of Au on Cu (110) by kinetic Monte Carlo method
Morphological and Structural transitions during epitaxial growth of surface and interface are an important nanoscal phenomena. Understanding the diffusion of adatom in anisotropic surface on the fcc (110), presents a challenge because of the various processes and energy activation of diffusion. During monolayer formation, adatoms could aggregate and forming islands. the stability of these latter is related the its shapes and adatom bonding. In this work, we used the Kinetic Monte Carlo method, implementing anisotropic bond-breaking model (ABBM) to simulate the evolution of anisotropic islands. In order to discuss the monolayer growing, many parameters are taken into account such as potential barriers, temperatures, deposition rates at fixed coverage of 10% monolayer.
- 1 September 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 522, 139-150
Kinetic Monte Carlo simulations of coverage effect on Ag and Au monolayers growth on Cu (1 1 0)
- 1 September 2019
- Published by Elsevier in Journal of Crystal Growth
- Vol. 522, 139-150
Kinetic Monte Carlo simulations of coverage effect on Ag and Au monolayers growth on Cu (1 1 0)
- 1 July 2019
- Published by Elsevier in Thin Solid Films
- Vol. 682, 99-108
Cluster adsorption and migration energetics on hcp Ti (0001) surfaces via atomistic simulations
- 1 July 2019
- Published by Elsevier in Thin Solid Films
- Vol. 682, 99-108
Cluster adsorption and migration energetics on hcp Ti (0001) surfaces via atomistic simulations
- 26 April 2019
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 134 (4) , 175
Silver monolayer formation on Cu(110) by kinetic Monte Carlo method
- 26 April 2019
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 134 (4) , 175
Silver monolayer formation on Cu(110) by kinetic Monte Carlo method