XLXiangdong Luo

Xiangdong Luo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Xiangdong Luo has a total of 49 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Dynamic Nonlinear Mismatch Correction Method for TIADC Based on GRU Network

    by Zhichao Wang, Cheng Liu, Yizhen Xu, Jiawei Deng, Hanchong Wei, Dian Sun, Xiangdong Luo

  • Calibration on timing skew mismatch of time‐interleaved ADC based on optimized adaptive genetic algorithm back‐propagation neural network

    by Cheng Liu, Jiaqing Zhao, Yang Zhang, Zhennan Xi, Jiawei Deng, Xiangdong Luo

    Aiming to address the timing skew mismatch in the time‐interleaved analog‐to‐digital converter (TIADC) system, this paper presents a timing skew mismatch calibration method based on a back propagation (BP) neural network optimized by an adaptive genetic algorithm (AGA). In this paper, a trained BP neural network is used to detect the timing skew mismatch in the TIADC system, and the variable delay line is used to calibrate it. In this paper, AGA is used to optimize the BP neural network, accelerating its training speed and improving the detection accuracy of timing skew mismatch in the system. The proposed approach boasts superior detection speed and accuracy compared to other methods. In this paper, an 18‐bit 1GS/S 4‐channel TIADC system is simulated and the timing skew mismatch in the system is corrected. Simulation results show that the proposed calibration method has fast detection speed, high detection accuracy, and calibration accuracy. After completing the timing skew mismatch correction, the performance of the TIADC system is dramatically improved. The effective number of bits (ENOB) of the system increases by 9.5 bits, and the spurious‐free dynamic range (SFDR) increases by 59.9 dB.


  • Open Access

    Error Detection and Correction of Mismatch Errors in M-Channel TIADCs Based on Genetic Algorithm Optimization

    by Yuehui Li, Cong Liu, Guangshan Niu, Xiangdong Luo, Haocheng Ma, Yiqiang Zhao

    In order to achieve higher system performance, a digital calibration technique for the sub-channel mismatches of time-interleaved ADCs (TIADCs) is proposed in this paper. The sine-fit-based estimation algorithm is introduced to estimate the channel mismatches and a calibration algorithm is proposed to compensate for the mismatches. Subsequently, the genetic algorithm (GA) is firstly utilized to detect the mismatch errors of the outputs of sub-channels after frequency domain filtering. The detected offset error and gain error are then corrected by performing the calibration algorithm, and the time errors are corrected by fractional delay filters based on Farrow structure. The spurious-free dynamic range (SFDR) is enhanced from 19.69 dB to 108.12 dB, and the signal to noise and distortion ratio (SNDR) is enhanced from 16.02 dB to 97.63 dB. The proposed technique is further validated on the FPGA. Compared with existing calibration techniques, the proposed technique has the advantages of simple algorithm structure, low hardware resource consumption, and high calibration accuracy and can be applied to the calibration of high-resolution (18-bit) TIADCs for low-frequency inputs.


  • Open Access

    Joint Error Estimation and Calibration Method of Memory Nonlinear Mismatch for a Four-Channel 16-Bit TIADC System

    by Jianwei Zhang, Yuxiang Zhou, Jiaqing Zhao, Guangshan Niu, Xiangdong Luo

    Memory nonlinear error greatly reduces the performance of analog-to-digital converters (ADCs), and this effect is more serious in a time-interleaved analog-to-digital converter (TIADC) system. In this study, the sinusoidal wave fitting method was adopted and a joint error estimation method was proposed to address the memory nonlinear mismatch problem of the current TIADC system. This method divides the nonlinear error estimation method into two steps: the nonlinear mismatch error is coarsely estimated offline using the least squares (LS) method, and then accurately estimated online using the recursive least squares (RLS) method. After the estimation, digital post-compensation method is adopted. The obtained error parameters are used to reconstruct the error and then the reconstructed error is reduced at the output. This study used a four-channel 16-bit TIADC system with an effective number of bits (ENOB) value of 10.06 bits after the introduction of a memory nonlinearity error, which was increased to 15.42 bits after calibration by the joint error estimation method. As a result, the spurious-free dynamic range (SFDR) increased by 36.22 dB. This error estimation method can improve the error estimation accuracy and reduce the hardware complexity of implementing the error estimation system using a field programmable gate array (FPGA).


  • Open Access

    Detection of weak Modulation signal by Digital Phase-locked Amplifier

    by Wang Weiming, Mao Shengyuan, Luo Xiangdong

    In the signal detection of two-dimensional material light modulation spectrum, the modulation signal is very weak and often submerged in the noise, so it is difficult to detect the modulation signal in the research. In order to detect weak modulation signals, according to the principle of digital phase lock amplification, this paper realizes the orthogonal digital phase lock method in MATLAB, and studies the extraction of modulation signals in the optical modulation spectrum. The results show that when the average noise is 20 μV, the digital phase-locked amplifier can effectively extract the modulation signal of 1 μV. When the amplitude, phase and type of modulation signal change, the extraction of modulation signal will not be affected.


  • Open Access

    Design of weak signal detection circuit of CMOS detector with large dynamic range by twice sampling method

    by Wang Weiming, Gu Yuanqing, Luo Xiangdong

    In the field of detecting weak signals with large dynamic range, CMOS image sensor, as an optical sensor component, has the advantages of large dynamic range and wide spectral response range, and is often used to detect weak signals. The commercial CMOS image sensor system usually adopts the ADC with 16-bit accuracy, which can not satisfy the detection of weak signal in some cases. In this study, CMOS image sensor S10122 chip from Hammatsu company of Japan was used as the core device. ADI company’s 16-bit ADC chip LTC2182 and 16-bit DAC chip LTC1668 were used. The circuit was designed according to twice sampling principles to improve ADC accuracy. The results show that the accuracy of ADC can be improved from 16 to 18 bits under certain conditions.

  • Open Access

    Influence of Quantum-Well Width on the Electroluminescence Properties of AlGaN Deep Ultraviolet Light-Emitting Diodes at Different Temperatures

    by Shuxin Tan, Jicai Zhang, Takashi Egawa, Gang Chen, Xiangdong Luo, Ling Sun, Youhua Zhu

    The influence of quantum-well (QW) width on electroluminescence properties of AlGaN deep ultraviolet light-emitting diodes (DUV LEDs) was studied at different temperatures. The maximum external quantum efficiency (EQE) ratios of LED with 3.5 nm QW to that with 2 nm increased from 6.8 at room temperature (RT) to 8.2 at 5 K. However, the ratios for LED with 3.5 nm QW to that with 5 nm QW decreased from 4.8 at RT to 1.6 at 5 K. The different changes of EQE ratios were attributed to the decrease of non-radiative recombination and the increase of volume of the active region. From theoretical analysis, the LED with 2-nm wells had a shallowest barrier for electron overflow due to the quantum-confined effect, whereas the LED with 5-nm wells showed the least overlap of electron and hole due to the large internal field. Therefore, the LED with 3.5 nm QW had the highest maximum EQE at the same temperature. As temperature decreased, the current for maximum EQE decreased for all the LEDs, which was believed to be due to the increase of electron which overflowed out of QWs and the decrease of hole concentration. The results were helpful for understanding the combination of polarization effect and electron overflow in DUV LEDs.


  • Dual-modulated photoreflectance spectra of semi-insulating GaAs

    by Liu Xue-Lu, Wu Jiang-Bin, Luo Xiang-Dong, Tan Ping-Heng

    半导体材料电子能带结构的确定对研究其物理性质及其在半导体器件方面的应用有重要意义.光调制反射光谱是一种无损和高灵敏度的表征半导体材料电子能带结构的光学手段.光调制反射光谱中激光调制导致的材料介电函数的变化在联合态密度奇点附近表现得更为明显.通过测量这些变化,可以得到有关材料能带结构临界点的信息.然而在传统的单调制反射光谱中,激光调制信号的光谱线型拟合和临界点数目的分析往往被瑞利散射和荧光信号所干扰.本文将双调制技术与双通道锁相放大器结合,消除了瑞利信号和荧光信号的干扰,获得了具有较高信噪比的调制反射光谱信号.双通道锁相放大器可以同时解调出反射光谱信号及其经泵浦激光调制后的细微变化量,避免了多次采集时可能存在的系统误差.利用这种技术,在可见激光(2.33 eV)泵浦下,我们测量了半绝缘GaAs体材料从近红外至紫外波段(1.1-6.0 eV)的双调制反射光谱,获得了多个能带结构临界点的信息.探测到了高于泵浦能量之上的与GaAs能带结构高阶临界点对应的特征光谱信号,说明带隙以上高阶临界点的光调制反射光谱本质是光生载流子对内建电场的调制,并不是来自该临界点附近的能带填充效应.这一结果表明双调制反射光谱能够对半导体材料能带结构带隙及其带隙以上临界点进行更准确的表征.