Nripendra N. Halder
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Nripendra N. Halder has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
D. Biswas
Advanced Technology Development Center, Indian Institute of Technology Kharagpur, Kharagpur, India
4 shared publications- Pranab Biswas
Materials Science Centre, Indian Institute of Technology, Kharagpur 721302, India
4 shared publications P. Banerji
Indian Institute of Technology
3 shared publicationsSanjay Kumar Jana
Advanced Technology Development Center, Indian Institute of Technology Kharagpur, Kharagpur, India
2 shared publications- Souvik Kundu
Department of Electrical & Electronics Engineering, Birla Institute of Technology and Science (BITS) Pilani, Hyderabad, India
2 shared publications - Ankush Bag
IIT Kharagpur
1 shared publication
Latest Publications
- 1 January 2015
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 132, 230-236
Au/p-Si Schottky junction solar cell: Effect of barrier height modification by InP quantum dots
- 1 January 2015
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 132, 230-236
Au/p-Si Schottky junction solar cell: Effect of barrier height modification by InP quantum dots
- 18 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 13 (5) , 917-925
Growth and Characterization of Self-Assembled InAs Quantum Dots on Si (100) for Monolithic Integration by MBE
High-density, self-assembled InAs quantum dots were grown on Si (100) substrates without any buffer layer by solidsource molecular beam epitaxy, following Volmer-Weber growth mode. The reconstructed (2 × 1) Si surface and growth transition from two-dimensional (2-D) to three-dimensional (3-D) were observed by in situ reflection high energy electron diffraction (RHEED). Surface morphology, shape, and chemical composition of these dots were investigated through scanning electron microscopy (SEM), atomic force microscopy (AFM), and energy dispersive X-ray (EDX) analysis, respectively. The dot densities were found to be 4 × 1014 m -2 for the samples grown at 380°C with a V/III ratio of 13. Optical properties of InAs quantum dots were observed by photoluminescence (PL) spectroscopy both at room and low temperatures. Room-temperature PL (RTPL) peak was observed at 1.016 eV (~1220 nm) and 1.05 eV (~1180.95 nm) presumably originating from the ground state (GS) and excited state (ES), respectively. The 3-D carrier confinement rather than the strain is found to have the dominating role, which causes blueshift of 0.662 eV. The theoretical PL spectrum of dots was obtained by using Gaussian size distribution where the dots were assumed to be cubic in shape. The low-temperature PL (LTPL) peak position was observed at 1.16 eV. The experimentally observed variation of the bandgap with temperature was in close proximity with both Varshini and Vina model. Raman spectroscopic analysis confirms the carrier confinement in the InAs quantum dots by the downward frequency shift at 216.57 and 237.96 cm -1 corresponding to the transverse optical (TO) and longitudinal optical (LO) phonon modes, respectively. The qualitative strain analysis was investigated by high-resolution X-ray diffractions (HRXRD) where the strain state was observed from the reciprocal space mapping in symmetric (004), as well as grazing exit and grazing incidence mode at (224) plane.
- 18 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 13 (5) , 917-925
Growth and Characterization of Self-Assembled InAs Quantum Dots on Si (100) for Monolithic Integration by MBE
High-density, self-assembled InAs quantum dots were grown on Si (100) substrates without any buffer layer by solidsource molecular beam epitaxy, following Volmer-Weber growth mode. The reconstructed (2 × 1) Si surface and growth transition from two-dimensional (2-D) to three-dimensional (3-D) were observed by in situ reflection high energy electron diffraction (RHEED). Surface morphology, shape, and chemical composition of these dots were investigated through scanning electron microscopy (SEM), atomic force microscopy (AFM), and energy dispersive X-ray (EDX) analysis, respectively. The dot densities were found to be 4 × 1014 m -2 for the samples grown at 380°C with a V/III ratio of 13. Optical properties of InAs quantum dots were observed by photoluminescence (PL) spectroscopy both at room and low temperatures. Room-temperature PL (RTPL) peak was observed at 1.016 eV (~1220 nm) and 1.05 eV (~1180.95 nm) presumably originating from the ground state (GS) and excited state (ES), respectively. The 3-D carrier confinement rather than the strain is found to have the dominating role, which causes blueshift of 0.662 eV. The theoretical PL spectrum of dots was obtained by using Gaussian size distribution where the dots were assumed to be cubic in shape. The low-temperature PL (LTPL) peak position was observed at 1.16 eV. The experimentally observed variation of the bandgap with temperature was in close proximity with both Varshini and Vina model. Raman spectroscopic analysis confirms the carrier confinement in the InAs quantum dots by the downward frequency shift at 216.57 and 237.96 cm -1 corresponding to the transverse optical (TO) and longitudinal optical (LO) phonon modes, respectively. The qualitative strain analysis was investigated by high-resolution X-ray diffractions (HRXRD) where the strain state was observed from the reciprocal space mapping in symmetric (004), as well as grazing exit and grazing incidence mode at (224) plane.
- 1 January 2014
- Published by Springer Nature in Environmental Science and Engineering
- p. 815-818
Fabrication of n-ZnO/p-GaAs Heterojunction and Prediction of Its Luminescence Based on Photoluminescence Study
- 1 January 2014
- Published by Springer Nature in Environmental Science and Engineering
- p. 815-818
Fabrication of n-ZnO/p-GaAs Heterojunction and Prediction of Its Luminescence Based on Photoluminescence Study
- 1 January 2014
- Published by AIP Publishing in AIP Conference Proceedings
Photoluminescence study based prediction on visible luminescence from n-Zno/p-GaAs heterojunction
Semiconductor heterojunction is an alternate approach in device fabrication where p-n homojunction could not be made possible due to nonavailability of a particular type of doping with required stability and carrier concentration as a fall out of self-compensation arising out of the non-stoichiometry. ZnO is one such material. In the present investigation a heterojunction of n-ZnO with p-GaAs has been made to investigate the light emission properties of the heterojunction. From the room temperature photoluminescence spectrum of the heterojunction, efforts have been made to predict the colour of the light emitted from it based on spectral response. It is observed that n-ZnO/p-GaAs heterojunction could emit in the purplish red region though the band gap of the constituent materials do not have the requisite band gap for such an emission. The color temperature is found to be less than 1000 K.
- 1 January 2014
- Published by AIP Publishing in AIP Conference Proceedings
Photoluminescence study based prediction on visible luminescence from n-Zno/p-GaAs heterojunction
Semiconductor heterojunction is an alternate approach in device fabrication where p-n homojunction could not be made possible due to nonavailability of a particular type of doping with required stability and carrier concentration as a fall out of self-compensation arising out of the non-stoichiometry. ZnO is one such material. In the present investigation a heterojunction of n-ZnO with p-GaAs has been made to investigate the light emission properties of the heterojunction. From the room temperature photoluminescence spectrum of the heterojunction, efforts have been made to predict the colour of the light emitted from it based on spectral response. It is observed that n-ZnO/p-GaAs heterojunction could emit in the purplish red region though the band gap of the constituent materials do not have the requisite band gap for such an emission. The color temperature is found to be less than 1000 K.
- 19 November 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (21) , 212108
Charge storage properties of InP quantum dots in GaAs metal-oxide-semiconductor based nonvolatile flash memory devices
Metal organic vapor phase epitaxially grown 5 nm InP quantum dots (QDs) were embedded as charge storage elements between high-k control and tunneling dielectric layers in GaAs metal-oxide-semiconductor based nonvolatile memory devices. The QDs trap more electrons resulting in a large memory window (6.3 V) along with low leakage due to Coulomb blockade effect. 16.5% charge loss was found even after 105 s indicating its good charge storing potential. The programming and erasing operations were discussed with proposed band diagram.
- 19 November 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (21) , 212108
Charge storage properties of InP quantum dots in GaAs metal-oxide-semiconductor based nonvolatile flash memory devices
Metal organic vapor phase epitaxially grown 5 nm InP quantum dots (QDs) were embedded as charge storage elements between high-k control and tunneling dielectric layers in GaAs metal-oxide-semiconductor based nonvolatile memory devices. The QDs trap more electrons resulting in a large memory window (6.3 V) along with low leakage due to Coulomb blockade effect. 16.5% charge loss was found even after 105 s indicating its good charge storing potential. The programming and erasing operations were discussed with proposed band diagram.