Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Wei Deng has a total of 73 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Rethinking the Active-Power–Frequency Loop in Grid-Forming Converters: A Constant-Frequency Voltage-Source Perspective

    by Xingyu Mi, Wei Deng, Shuo Zhang, Weihua Zhao, Yanhong Yang, Wei Pei

    With the increasing penetration of renewable energy, power systems are transitioning from synchronous-machine-dominated to converter-dominated operation. Conventional VSG and droop control make the converter emulate synchronous-machine rotor dynamics by coupling active power with frequency. This design choice inevitably slows down the converter and may sacrifice its fast-regulation capability. The slow response of VSG-based GFMs is often treated as an inherent property of grid-forming operation, but it mainly arises from using the active-power–frequency loop to match synchronous-machine rotor dynamics. Rather than proposing another GFM control law, this paper revisits a basic assumption of VSG control: whether the active-power–frequency loop is still necessary when the converter is only required to provide fast support within its current margin, while steady-state support is assigned to the synchronous machine(SM). A voltage-oriented constant-frequency GFM strategy based on Q–Us droop control is adopted to decouple active-power regulation from frequency dynamics. Compared with conventional VSG control, the constant-frequency approach exhibits smaller voltage deviations and faster voltage recovery during disturbances. The results suggest that the relatively slow response associated with VSG control is primarily a consequence of its control design rather than an inherent requirement of grid-forming operation.

  • Open Access

    Quantitative Analysis Method of Stability Ability for Renewable Electric Energy Delivery System

    by Jiawang Xiong, Wei Pei, Guanqi Wang, Wei Deng, Hao Xiao

    One mainstream approach to alleviate insufficient voltage support in renewable‐energy power delivery systems is to introduce a portion of grid‐forming (GFM) inverters. However, the distinct characteristics of grid‐following (GFL) and grid‐forming (GFM) controls complicate the quantitative assessment of system stability capability. To address this issue, this paper proposes an amplitude mapping‐based method for quantitatively evaluating stability capability, yielding a simple and practical analytical expression. Specifically, we introduce the idea of assessing system stability through waveform‐amplitude stability. Based on this concept, the mathematical model of the renewable‐energy delivery system is established, and the expression of the stability capability index (SA) is derived. Next, the impacts of key parameters on SA are analysed, and the critical GFL–GFM power ratio is quantified. Finally, the theoretical findings are validated through case studies.

  • Flexible DC Interconnection Method of Urban Microgrids to Enhance Power Supply Capability Under Natural Disasters

    by Qi Wu, Wei Deng, Quanzhong Yue, Ying Zhuang, Wei Pei

    How to achieve urban power restoration with the help of microgrid (MG) in the face of natural disasters has become a research hotspot. This paper aims to research a flexible interconnection method to enhance power supply capacity. First, a flexible DC interconnection method covering a large spatial area is proposed. Then, based on a modular modeling method for high-order systems considering interaction characteristics of Voltage Source Converter (VSC) ports, an interconnection selection method is built to compare the power supply performance of system under star structure and hand-in-hand structure. Furthermore, a dynamic adjustment strategy based on control mode is formed. Finally, the corresponding simulation and experimental verification shows that the proposed method is able to obtain optimal structure and master station to get the maximum power supply capability, while still ensuring high reliability in the face of secondary disasters.


  • A Control Method for Improving Power Quality of Parallel Three-Level Rectifiers Under Unbalanced Grid Voltage Conditions

    by Xue Zhang, Wei Pei, Wei Deng

    In parallel three-level neutral point clamped (3L-NPC) rectifiers with the common dc and ac buses directly under unbalanced grid voltage operation conditions, the power quality issues such as neutral-point potential (NPP) unbalance, zero sequence circulating current (ZSCC), dc bus voltage fluctuations, grid current distortion, and inaccurate sharing of current must be considered to ensure high-quality operation of parallel 3L-NPC rectifiers. A controlmethod with carrier-based pulse width modulation (PWM) for improving power quality of parallel 3L-NPC rectifiers is proposed in the stationary reference frame. Themodel of parallel 3L-NPC rectifiers is established under unbalanced operation conditions. To simultaneously improve the power quality of dc bus voltage and grid-connected current, an improved control strategy with voltage outer-loop proportional integral multiresonant (PIMR) controller and current innerloop proportional feedback multiresonant (PFMR) controller is proposed. Meanwhile, a coordinated control method of ZSCC and NPPB with additional feedforward is proposed to overcome the coupling problembetween them. The dual control attribute and parameter design method of PFMR controller are analyzed. Finally, an experimental platform of parallel 3L-NPC rectifiers is established based on dSPACE 1007, the experimental results verify the effectiveness of the proposed controlmethod.


  • Open Access

    Phase Angle Feedforward Control for Oscillation Suppression of Multi‐VSGs Parallel Microgrid

    by Wei Deng, Shuo Zhang, Yuting Teng, Xue Zhang, Wei Pei

    In a microgrid system with multiple virtual synchronous generators (VSGs), the introduction of inertia makes the power oscillations of each VSG under an active power disturbance more obvious. Therefore, this paper establishes the active power frequency response model of the multi‐VSG parallel microgrid system. On this basis, combined with the system topology, phase angle feedforward control is proposed, and the difference between the initial power and the steady power caused by the power oscillations is compensated by the optimal compensation coefficient, which can improve the system power response speed, restrain the power oscillation between units, and retain the inertia response adjustment ability. Finally, simulation experiments are carried out on the Matlab/Simulink platform to verify the correctness of the proposed active power frequency response model and the effectiveness of the proposed method for suppressing power oscillation.

  • Open Access

    Coordinated Optimization of Active Distribution Network and Multi‐Microgrids Considering Voltage Robustness and Economic Efficiency: A Distributed Model Predictive Control Method

    by Daoxin Han, Wei Deng, Zhenxing Zhao, Wei Pei, Hao Xiao

    With the high penetration of renewable energy, the active distribution network (ADN) and multi‐microgrids (MMGs), as emerging multi‐layered energy management systems, face challenges such as voltage violations and conflicts of interest among multiple agents. To address these distributed coordinating optimization issues in the ADN‐MMGs system, this paper proposes a coordinating optimization method for ADN‐MMGs systems that balances voltage robustness and system economics. In the day‐ahead stage, the method considers MMGs' participation in the voltage regulation ancillary service market and decentralized peer‐to‐peer (P2P) trading market, and baseline plans are developed for voltage stability and economic operation. In the intra‐day stage, ADN and MMGs are treated as subsystems. Using voltage sensitivity matrices and consensus algorithms, a state‐space‐based distributed model predictive control (Di‐MPC) coordination model is constructed, effectively mitigating short‐term power fluctuations from renewable energy and load variability. An analysis on a modified IEEE 33‐bus system demonstrates that the proposed method enhances economic efficiency and voltage robustness by coordinating subsystem energy flows. Compared to the distributed economic model predictive control (MPC) scheme, the proposed method reduces the state of charge (SOC) tracking error of MMGs by 51.21% and ensures that the deviation in planned daily operating cost for the ADN‐MMGs system does not exceed 1%.


  • Open Access

    A Generalised Power Synchronisation Loop Design for Performance Enhancement of Grid‐Forming Converter

    by Yifeng Li, Wei Pei, Jiawang Xiong, Wei Deng

    The dynamic characteristics of a grid‐forming converter (GFM) directly affect the stable operation of converter‐based power systems, where the power synchronisation loop plays a critical role in the shaping of the dynamic characteristics of the GFM converter. Currently, the power synchronisation loop is generally designed by emulating the synchronous machine models and can only provide the inertia and damping characteristics. The stiffness, one of the most important dynamic features, is lacking in the dynamic design of the GFM converter. In this paper, we propose a generalised power synchronisation loop (GPSL) to enable the GFM converter with the inertia, the damping and the stiffness simultaneously. By properly choosing the loop parameters, the dynamic performance and flexibility of the GFM converter can be enhanced. The dynamic property of the GFM converter system and the multiple GFM converter system under the proposed GPSL is both analysed. Moreover, a parameter tunning procedure is given to facilitate the usage of the GPLS. Finally, simulation and experimental results verify the feasibility and effectiveness of the proposed method.


  • Open Access

    Research on Phase Angle Correction Control Strategy for Grid-Forming Cluster in Distributed Energy Resources

    by Shu Wang, Fan Yang, Zhizhen Ma, Ran Zhang, Chuhan Li, Shuping Wang, Jing Chen, Li Ju, Yongqi Zhao, Jiawang Xiong, et al.

    The active power-phase angle droop control avoids the frequency deviation problem caused by taking the frequency as the droop variable. However, the active power output of distributed generations (DGs) can only be allocated by adjusting the droop coefficient, and the reference value of active power output cannot be set arbitrarily. In this paper, a phase angle correction module attached to the active power-phase angle droop control is proposed. This correction module is based on the real-time data of the voltage and phase angle of the node at the generation end and the transmission end of the grid, and directly changes the phase angle reference value of the active power-phase angle droop control output. The correction can make the phase angle reference value reach the phase angle value corresponding to the active power reference value without changing the actual characteristics of the droop control, so as to adjust the active power output of the converter to reach the active power reference value. Finally, the feasibility of the correction method in different cases is verified by Matlab 23.2.0.2365128 (R2023b)/Simulink simulation.


  • A New Secondary Frequency Control Method for Distributed VSGs in Island Operation

    by Yuting Teng, Wei Deng, Guoju Zhang, Shiyi Zhang, Wei Pei