Hans-Petter Fjeldstad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Hans-Petter Fjeldstad has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Knut Alfredsen
Department of Civil and Environmental Engineering, Norwegian University of Science and Technology, Trondheim, Norway
3 shared publications - Torbjørn Forseth
Norwegian Institute for Nature Research (NINA) Trondheim Norway
3 shared publications - Ana Adeva-Bustos
SINTEF Energy Research
1 shared publication - Ana Teixeira da Silva
Norwegian Institute for Nature Research (NINA), Høgskoleringen 9, 7043 Trondheim, Norway
1 shared publication E. Kvingedal
Norwegian Institute for Nature Research, NO-7485 Trondheim, Norway
1 shared publicationF. Økland
Norwegian Institute for Nature Research, NO-7485 Trondheim, Norway
1 shared publication
Latest Publications
- Open Access
Validation of a Swimming Direction Model for the Downstream Migration of Atlantic Salmon Smolts
Fish swimming performance is strongly influenced by flow hydrodynamics, but little is known about the relation between fine-scale fish movements and hydrodynamics based on in-situ investigations. In the presented study, we validated the etho-hydraulic fish swimming direction model presented in the River Mandal from Southern Norway, using similar behavioral and hydraulic data on salmon smolts from the River Orkla in Central Norway. The re-parametrized model explained the variation of the swimming direction of fish in the Orkla system in same degree as the original model performed in the Mandal system (R2: 84% in both cases). The transferability of the model when using it from one river to predict swimming direction in the other river was lower (R2: 21% and 26%), but nevertheless relatively high given that the two localities differed in hydraulic conditions. The analyses thus provide support for the fact that the identified hydraulic parameters and their interaction affected smolt behavior in a similar way at the two sites, but that local parametrization of the base model is required. The developed etho-hydraulic models can provide important insights into fish behavior and fish migration trajectories and can be developed into prediction models important for the future development of behavioral downstream migration solutions.
Open AccessValidation of a Swimming Direction Model for the Downstream Migration of Atlantic Salmon Smolts
Fish swimming performance is strongly influenced by flow hydrodynamics, but little is known about the relation between fine-scale fish movements and hydrodynamics based on in-situ investigations. In the presented study, we validated the etho-hydraulic fish swimming direction model presented in the River Mandal from Southern Norway, using similar behavioral and hydraulic data on salmon smolts from the River Orkla in Central Norway. The re-parametrized model explained the variation of the swimming direction of fish in the Orkla system in same degree as the original model performed in the Mandal system (R2: 84% in both cases). The transferability of the model when using it from one river to predict swimming direction in the other river was lower (R2: 21% and 26%), but nevertheless relatively high given that the two localities differed in hydraulic conditions. The analyses thus provide support for the fact that the identified hydraulic parameters and their interaction affected smolt behavior in a similar way at the two sites, but that local parametrization of the base model is required. The developed etho-hydraulic models can provide important insights into fish behavior and fish migration trajectories and can be developed into prediction models important for the future development of behavioral downstream migration solutions.
- Open Access
- 12 March 2019
- Published by MDPI AG in Sustainability
- Vol. 11 (5) , 1500
Ecohydraulic Modelling to Support Fish Habitat Restoration Measures
Despite that hydromorphological restoration projects have been implemented since the 1940s, the key to improve the effectiveness of future restoration measures remains a challenge. This is in part related to the lack of adequate aims and objectives together with our limitations in understanding the effects on the physical habitat and ecosystems from interventions. This study shows the potential of using remote sensing techniques combined with hydraulic modelling to evaluate the success of physical restoration measures using habitat suitability as a quantifiable objective. Airborne light detection and ranging (LiDAR) was used to build a high-resolution two-dimensional model for Ljungan River, Sweden, using HEC-RAS 5.0. Two types of instream restoration measures were simulated according to the physical measures carried out in the river to improve salmonid habitat: (a) stones and rocks were moved from the bank sides to the main channel, and (b) a concrete wall was broken to open two channels to connect a side channel with the main river. Results showed that the hydraulic model could potentially be used to simulate the hydraulic conditions before and after instream modifications were implemented. A general improvement was found for the potential suitable habitat based on depth, velocity and shear stress values after the instream measures.
- 12 March 2019
- Published by MDPI AG in Sustainability
- Vol. 11 (5) , 1500
Open AccessEcohydraulic Modelling to Support Fish Habitat Restoration Measures
Despite that hydromorphological restoration projects have been implemented since the 1940s, the key to improve the effectiveness of future restoration measures remains a challenge. This is in part related to the lack of adequate aims and objectives together with our limitations in understanding the effects on the physical habitat and ecosystems from interventions. This study shows the potential of using remote sensing techniques combined with hydraulic modelling to evaluate the success of physical restoration measures using habitat suitability as a quantifiable objective. Airborne light detection and ranging (LiDAR) was used to build a high-resolution two-dimensional model for Ljungan River, Sweden, using HEC-RAS 5.0. Two types of instream restoration measures were simulated according to the physical measures carried out in the river to improve salmonid habitat: (a) stones and rocks were moved from the bank sides to the main channel, and (b) a concrete wall was broken to open two channels to connect a side channel with the main river. Results showed that the hydraulic model could potentially be used to simulate the hydraulic conditions before and after instream modifications were implemented. A general improvement was found for the potential suitable habitat based on depth, velocity and shear stress values after the instream measures.
- 1 January 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 647, 1368-1372
Hydropower and fish – Report and messages from workshop on research and innovation in the context of the European policy framework
- 1 January 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 647, 1368-1372
Hydropower and fish – Report and messages from workshop on research and innovation in the context of the European policy framework
- Open Access
- 7 November 2018
- Published by CSIRO Publishing in Marine and Freshwater Research
- Vol. 69 (12) , 1834-1847
Safe two-way migration for salmonids and eel past hydropower structures in Europe: a review and recommendations for best-practice solutions
This review provides a summary of knowledge on two-way fish migration of salmonids and eels past hydroelectric plants in Europe. On the basis of a summary of international literature, general designs and recommendations for best practices for fish-pass facilities are provided. The review is part of the Norwegian SafePass project, which focuses on Atlantic salmon, brown trout, grayling and European eel. According to recent international recommendations, many existing European fishways for upstream migration do not have an optimal design. This is especially evident for denil and pool-and-weir fishways in inland areas with species such as grayling and brown trout. Based on the review, we generally recommend (1) using ramps, nature-like channels and vertical-slot fishways for these species and (2) reducing water drop between the pools in pool-and-weir fishways and reducing energy dissipation compared with the design of traditional Atlantic salmon ladders. There are few well-functioning passages for downstream migration of fish in Europe and significant progress has been made in the past decade to improve technology and knowledge. Several international studies have shown that physical structures, such as fine-mesh trash racks with alternative escape routes and bypass arrangements, provide >90% passage efficiency for downstream migration, especially for brown trout and salmon, and have, in recent years, shown good results also for silver eels.
- 7 November 2018
- Published by CSIRO Publishing in Marine and Freshwater Research
- Vol. 69 (12) , 1834-1847
Open AccessSafe two-way migration for salmonids and eel past hydropower structures in Europe: a review and recommendations for best-practice solutions
This review provides a summary of knowledge on two-way fish migration of salmonids and eels past hydroelectric plants in Europe. On the basis of a summary of international literature, general designs and recommendations for best practices for fish-pass facilities are provided. The review is part of the Norwegian SafePass project, which focuses on Atlantic salmon, brown trout, grayling and European eel. According to recent international recommendations, many existing European fishways for upstream migration do not have an optimal design. This is especially evident for denil and pool-and-weir fishways in inland areas with species such as grayling and brown trout. Based on the review, we generally recommend (1) using ramps, nature-like channels and vertical-slot fishways for these species and (2) reducing water drop between the pools in pool-and-weir fishways and reducing energy dissipation compared with the design of traditional Atlantic salmon ladders. There are few well-functioning passages for downstream migration of fish in Europe and significant progress has been made in the past decade to improve technology and knowledge. Several international studies have shown that physical structures, such as fine-mesh trash racks with alternative escape routes and bypass arrangements, provide >90% passage efficiency for downstream migration, especially for brown trout and salmon, and have, in recent years, shown good results also for silver eels.
- 2 September 2013
- Published by Wiley in Fisheries Management and Ecology
- Vol. 21 (1) , 22-31
Optimising Atlantic salmon smolt survival by use of hydropower simulation modelling in a regulated river
Studies on downstream passage of diadromous fishes in northern Europe are rare, and in Norway, the problem is strongly linked to demands for efficient hydropower production. The current study explored mitigating measures using a hydropower simulation model for Atlantic salmon, Salmo salar L., smolt migration. Migration pattern and route choice at a hydropower intake for 22 years were described for a river in southern Norway, based on simulated data for discharge and water temperature. Subsequently, the potential for controlling the migration pattern and smolt routing past the intake by altering release patterns from the reservoirs was tested. Modelling of a general annual increase in bypass discharge from 3 to 15 m3 s−1 increased average bypass migration from 30 to 43% at the cost of 14 € per fish. Individual release schedules from reservoirs for selected years indicated that bypass rates could be increased to 80% at an average cost of 4.5 € per fish and 2.2 € in the best years. Mitigating measures presumably depend on the specific site, but the methods developed in this study represent a general technique for evaluating increased smolt survival past hydropower intakes.
- 2 September 2013
- Published by Wiley in Fisheries Management and Ecology
- Vol. 21 (1) , 22-31
Optimising Atlantic salmon smolt survival by use of hydropower simulation modelling in a regulated river
Studies on downstream passage of diadromous fishes in northern Europe are rare, and in Norway, the problem is strongly linked to demands for efficient hydropower production. The current study explored mitigating measures using a hydropower simulation model for Atlantic salmon, Salmo salar L., smolt migration. Migration pattern and route choice at a hydropower intake for 22 years were described for a river in southern Norway, based on simulated data for discharge and water temperature. Subsequently, the potential for controlling the migration pattern and smolt routing past the intake by altering release patterns from the reservoirs was tested. Modelling of a general annual increase in bypass discharge from 3 to 15 m3 s−1 increased average bypass migration from 30 to 43% at the cost of 14 € per fish. Individual release schedules from reservoirs for selected years indicated that bypass rates could be increased to 80% at an average cost of 4.5 € per fish and 2.2 € in the best years. Mitigating measures presumably depend on the specific site, but the methods developed in this study represent a general technique for evaluating increased smolt survival past hydropower intakes.
- 25 June 2012
- Published by Wiley in Journal of Fish Biology
- Vol. 81 (2) , 642-663
A concept for improving Atlantic salmon Salmo salar smolt migration past hydro power intakes
In this study, cost effective (in terms of reducing loss of power production) measures for increasing bypass migration of Atlantic salmon Salmo salar were developed and tested by establishing statistical models for timing of smolt migration and favourable diversion of water to the bypass. Initial tracking of radio‐tagged smolts showed very low bypass migration under normal hydropower operations. Bypass migration increased when bypass discharge was experimentally increased and a model was developed that described relationships between total river discharge, bypass diversion and smolt migration route. Further improvements were obtained by installing two strobe lights at the power‐production tunnel entrance that increased bypass migration during the night, but not during daytime. According to the behaviour of radio‐tagged fish, the implemented measures contributed to increasing the annual percentage of bypass migration from 11 to 64%, and according to model predictions to 60–74% when the hydropower facilities were operated according to the developed models. To ensure correct timing of discharge diversion a smolt migration model was developed based on environmental variables that could successfully predict the general pattern of migration timing. The concept presented for improving smolt migration past hydropower intakes should be applicable in many systems where migration past hydropower installations cannot easily be solved by screening systems.
- 25 June 2012
- Published by Wiley in Journal of Fish Biology
- Vol. 81 (2) , 642-663
A concept for improving Atlantic salmon Salmo salar smolt migration past hydro power intakes
In this study, cost effective (in terms of reducing loss of power production) measures for increasing bypass migration of Atlantic salmon Salmo salar were developed and tested by establishing statistical models for timing of smolt migration and favourable diversion of water to the bypass. Initial tracking of radio‐tagged smolts showed very low bypass migration under normal hydropower operations. Bypass migration increased when bypass discharge was experimentally increased and a model was developed that described relationships between total river discharge, bypass diversion and smolt migration route. Further improvements were obtained by installing two strobe lights at the power‐production tunnel entrance that increased bypass migration during the night, but not during daytime. According to the behaviour of radio‐tagged fish, the implemented measures contributed to increasing the annual percentage of bypass migration from 11 to 64%, and according to model predictions to 60–74% when the hydropower facilities were operated according to the developed models. To ensure correct timing of discharge diversion a smolt migration model was developed based on environmental variables that could successfully predict the general pattern of migration timing. The concept presented for improving smolt migration past hydropower intakes should be applicable in many systems where migration past hydropower installations cannot easily be solved by screening systems.