F. Ellinger
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
F. Ellinger has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
H. Jackel
3 shared publicationsC. Kromer
Electron. Lab., Swiss Fed. Inst. of Technol., Zurich, Switzerland
1 shared publicationD. Barras
Electron. Lab., Swiss Fed. Inst. of Technol., Zurich, Switzerland
1 shared publicationG. Sialm
Electron. Lab., Swiss Fed. Inst. of Technol., Zurich, Switzerland
1 shared publicationG. von Buren
Electron. Lab., Swiss Fed. Inst. of Technol., Zurich, Switzerland
1 shared publicationM. Schmatz
1 shared publication
Latest Publications
- 25 September 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 16 (10) , 564-566
A 40-GHz static frequency divider with quadrature outputs in 80-nm CMOS
The implemented static frequency divider provides quadrature (Q) clock outputs and divides frequencies up to 44GHz. The core divider circuit consists of two current-mode logic (CML) latches and consumes 3.2mW from a 1.1-V supply. The divided outputs result in a peak-to-peak and rms jitter of 6.3 and 0.8ps, respectively, and the maximum phase mismatch between the in-phase (I) and Q-outputs amounts to 1ps at an input frequency of 40GHz. The high division frequency is achieved by employing resistive loads, inductive peaking, and optimizing the circuit layout for reduced parasitic capacitances in the latches. The core divider consumes a chip area of 30mumtimes40mum only
- 25 September 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 16 (10) , 564-566
A 40-GHz static frequency divider with quadrature outputs in 80-nm CMOS
The implemented static frequency divider provides quadrature (Q) clock outputs and divides frequencies up to 44GHz. The core divider circuit consists of two current-mode logic (CML) latches and consumes 3.2mW from a 1.1-V supply. The divided outputs result in a peak-to-peak and rms jitter of 6.3 and 0.8ps, respectively, and the maximum phase mismatch between the in-phase (I) and Q-outputs amounts to 1ps at an input frequency of 40GHz. The high division frequency is achieved by employing resistive loads, inductive peaking, and optimizing the circuit layout for reduced parasitic capacitances in the latches. The core divider consumes a chip area of 30mumtimes40mum only
- 19 October 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 13-16 Vol.1
A low power DC-7.8 GHz BiCMOS LNA for UWB and optical communication
A low noise amplifier (LNA) for ultra wideband (UWB) and optical communication is presented in this paper. Active impedance matching allows a -3dB bandwidth from dc to 7.8GHz at 50/spl Omega/ port impedances. At a low power consumption of 1.8 V /spl times/ 3.6 mA, the amplifier has a power gain of 10.6 dB, a noise figure below 4.4 dB, an input compression of -12 dBm and return losses above 7.8 dB. The fully integrated circuit is fabricated on commercial 0.25/spl mu/m BiCMOS technology and requires a chip area of 0.45 mm/sup 2/.
- 19 October 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 13-16 Vol.1
A low power DC-7.8 GHz BiCMOS LNA for UWB and optical communication
A low noise amplifier (LNA) for ultra wideband (UWB) and optical communication is presented in this paper. Active impedance matching allows a -3dB bandwidth from dc to 7.8GHz at 50/spl Omega/ port impedances. At a low power consumption of 1.8 V /spl times/ 3.6 mA, the amplifier has a power gain of 10.6 dB, a noise figure below 4.4 dB, an input compression of -12 dBm and return losses above 7.8 dB. The fully integrated circuit is fabricated on commercial 0.25/spl mu/m BiCMOS technology and requires a chip area of 0.45 mm/sup 2/.
- 26 February 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 14 (2) , 53-55
Ultracompact SOI CMOS frequency doubler for low power applications at 26.5-28.5 GHz
In this paper, a complementary metal oxide semiconductor (CMOS) frequency doubler for wireless applications at Ka-band is presented. The microwave monolithic integrated circuit (MMIC) is fabricated using digital 90 nm silicon on insulator (SOI) technology. All impedance matching, filter and bias elements are implemented on the chip, which has a very compact size of 0.37 mm/spl times/0.27 mm. At an output frequency of 27 GHz, source/load impedances of 50 /spl Omega/, a supply voltage of 1.25 V, a supply current of 8 mA and an input power of -4.5 dBm, a conversion gain of 1.5 dB was measured. To the knowledge of the authors, the circuit has by far the highest operation frequency for a CMOS frequency multiplier reported to date and requires lower supply power than circuits using leading edge III/V and silicon germanium (SiGe) technologies.
- 26 February 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 14 (2) , 53-55
Ultracompact SOI CMOS frequency doubler for low power applications at 26.5-28.5 GHz
In this paper, a complementary metal oxide semiconductor (CMOS) frequency doubler for wireless applications at Ka-band is presented. The microwave monolithic integrated circuit (MMIC) is fabricated using digital 90 nm silicon on insulator (SOI) technology. All impedance matching, filter and bias elements are implemented on the chip, which has a very compact size of 0.37 mm/spl times/0.27 mm. At an output frequency of 27 GHz, source/load impedances of 50 /spl Omega/, a supply voltage of 1.25 V, a supply current of 8 mA and an input power of -4.5 dBm, a conversion gain of 1.5 dB was measured. To the knowledge of the authors, the circuit has by far the highest operation frequency for a CMOS frequency multiplier reported to date and requires lower supply power than circuits using leading edge III/V and silicon germanium (SiGe) technologies.