RKRichard Klop

Richard Klop

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Richard Klop has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Investigation of Noise Sources on a Series Hybrid Transmission

    by Richard Klop, Monika Ivantysynova

    Advanced hydrostatic transmissions and hydraulic hybrids show potential in new market segments such as commercial vehicles and passenger cars. Such new applications regard low noise generation as a high priority, thus, demanding new quiet hydrostatic transmission designs. The aim of this paper is to investigate noise sources on a series hybrid transmission through simulation and measurements. A model has been developed to capture the interaction of a pump and motor working in a hydrostatic transmission and to predict overall noise sources. The model describes dynamics of the system by coupling lumped parameter pump and motor models with a one-dimensional unsteady compressible transmission line model including a dynamic model of an accumulator. A semi-anechoic chamber has been designed and constructed for sound intensity measurements that can be used to derive sound power. Sound power measurements were conducted on a series hybrid transmission test bench inside the semi-anechoic chamber in order to study the relationship between sound power and two types of noise sources, fluid and structure borne. The focus of these measurements was to investigate the impact of an accumulator in the high pressure line as well as the influence of varying high pressure line length. Results show a strong influence of changing line length and the addition of an accumulator on pressure ripple, but with little impact on sound power. A high correlation was found between sound power levels and control moment amplitudes on the swash plate. This study demonstrates the usefulness of predicting transmission noise sources, and how this information is beneficial in the design process of a transmission.


  • A Numerical Approach for the Evaluation of the Effects of Air Release and Vapour Cavitation on Effective Flow Rate of Axial Piston Machines

    by Andrea Vacca, Richard Klop, Monika Ivantysynova

    This work illustrates a numerical methodology for the description of effective flow rate of axial piston pumps and motors. The presented mathematical model is similar to classical lumped parameter approaches that are commonly used to simulate hydraulic units; however, this work uniquely utilises a mathematical formulation for compressible flows based on an original description of fluid density. Assuming the behaviour of typical mineral oil, the model can evaluate fluid density for all possible values of pressure while considering the occurrence of gas cavitation (due to the release of air normally dissolved into liquid) below saturation pressure, and of vapour cavitation (due to liquid change of phase) below vapour pressure. The developed simulation model allows a description of several characteristics of the machine (i.e. instantaneous cylinder pressure and density, delivery and inlet flow rates, etc.) in its whole field of operation taking into account conditions of insufficient flow due to cavitation at the low pressure port. Tests were carried out on a swash plate type axial piston pump for open circuit applications to verify potentials of the developed numerical model. Experiments were conducted to test the pump under typical operating conditions as well as situations critical from the point of view of cavitation (high shaft speed, low values of inlet pressure), thus permitting the comparison between the prediction given by the developed model and experimental results over a wide range of data. Results highlight how fluid density changes can be used to characterize effective flow rate but also to justify, in particular operating conditions, the utilization of the approach for compressible flows. Results show that the developed model uniquely allows the calculation of effective flow rate through the pump at fair and extreme conditions, thus permitting the ability to predict limitations of the machine. Furthermore, the realistic prediction of pressures throughout the machine in these conditions leads the accurate predictions of pressure forces and of flow through the lubricating gaps that may be critical in other models.