Liang Tan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Liang Tan has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
C. -F. Yao
Northwestern Polytechnical University
1 shared publicationChangfeng Yao
Northwestern Polytechnical University
1 shared publicationDinghua Zhang
Northwestern Polytechnical University
1 shared publicationJ. -X. Ren
Northwestern Polytechnical University
1 shared publicationMinchao Cui
Northwestern Polytechnical University
1 shared publicationQ. Lin
Northwestern Polytechnical University
1 shared publication
Latest Publications
- Open Access
- 26 March 2021
- Published by Springer Nature in Research Square
Effects of Tool Wear on Machined Surface Integrity During Milling of Inconel 718
This paper investigates the effects of tool wear on the machined surface integrity characteristics, including the surface roughness, surface topography, residual stress, microhardness and microstructure, during ball-end milling of Inconel 718. Tool wear, tool lifetime, and cutting force are measured. In addition, a two-dimensional finite element-based model is developed to investigate the cutting temperature distribution in the chip–tool–workpiece contact area. Results show that the ball nose end mill achieves tool lifetime of approximately 350 min. The cutting forces increase sharply with a greater tool flank wear width, while the highest cutting temperature has a decreasing tend at a flank wear width of 0.3 mm. Higher tool flank wear width produces larger surface roughness and deteriorative surface topography. A high-amplitude (approximately −700 MPa) and deep layer (approximately 120 mm) of compressive residual stress are induced by a worn tool with 0.3 mm flank wear width. The surface microhardness induced by new tool is larger than that induced by worn tool. Plastic deformation and strain streamlines are observed within 10 mm depth beneath the surface. The results in this paper provide an optimal tool wear criterion which integrates the surface integrity requirements and the tool lifetime for ball-end finish milling of Inconel 718.
- 26 March 2021
- Published by Springer Nature in Research Square
Open AccessEffects of Tool Wear on Machined Surface Integrity During Milling of Inconel 718
This paper investigates the effects of tool wear on the machined surface integrity characteristics, including the surface roughness, surface topography, residual stress, microhardness and microstructure, during ball-end milling of Inconel 718. Tool wear, tool lifetime, and cutting force are measured. In addition, a two-dimensional finite element-based model is developed to investigate the cutting temperature distribution in the chip–tool–workpiece contact area. Results show that the ball nose end mill achieves tool lifetime of approximately 350 min. The cutting forces increase sharply with a greater tool flank wear width, while the highest cutting temperature has a decreasing tend at a flank wear width of 0.3 mm. Higher tool flank wear width produces larger surface roughness and deteriorative surface topography. A high-amplitude (approximately −700 MPa) and deep layer (approximately 120 mm) of compressive residual stress are induced by a worn tool with 0.3 mm flank wear width. The surface microhardness induced by new tool is larger than that induced by worn tool. Plastic deformation and strain streamlines are observed within 10 mm depth beneath the surface. The results in this paper provide an optimal tool wear criterion which integrates the surface integrity requirements and the tool lifetime for ball-end finish milling of Inconel 718.
- 5 December 2013
- Published by Springer Nature in Journal of Failure Analysis and Prevention
- Vol. 14 (1) , 102-112
Surface Integrity and Fatigue Behavior for High-Speed Milling Ti–10V–2Fe–3Al Titanium Alloy
- 5 December 2013
- Published by Springer Nature in Journal of Failure Analysis and Prevention
- Vol. 14 (1) , 102-112
Surface Integrity and Fatigue Behavior for High-Speed Milling Ti–10V–2Fe–3Al Titanium Alloy