Olga Klimova-Korsmik

The manufacturing of personalized implants from Ti–6Al–4V alloy using additive manufacturing technologies is a promising direction in modern medicine. However, components produced by these methods are characterized by a non-equilibrium microstructure, high residual stresses, and anisotropy of mechanical properties, which necessitates subsequent heat treatment. The aim of the present work was a systematic comparative study of the effect of three heat treatment regimes—stress relief annealing (600 °C, 3 h), subtransus annealing in the (α + β) region (950 °C, 1 h, furnace cooling), and solution treatment followed by aging (STA: 950 °C, 0.5 h, water quenching + aging at 675 °C, 3 h)—on the microstructure and mechanical properties of Ti–6Al–4V alloy manufactured by laser powder bed fusion (L-PBF) and plasma arc directed energy deposition (PA-DED). The microstructure was examined using scanning electron microscopy, transmission electron microscopy, and electron backscatter diffraction (EBSD). Tensile mechanical properties were determined in two directions: parallel and perpendicular to the build direction. Stress-relief annealing led to an increase in the ductility of the alloy without a noticeable decrease in strength and without significant changes in the microstructure. Subtransus annealing resulted in the formation of an equilibrium lamellar (α + β) structure, which provided a substantial increase in ductility with a moderate decrease in strength. Solution treatment and aging resulted in formation of a bimodal microstructure. Subtransus annealing (both alloys), STA (L-PBF) and stress relief annealing (PA-DED) provided properties comparable to those of wrought material. The obtained results form the basis for a scientifically informed selection of both the manufacturing route and the heat treatment regime for biomedical implants made of Ti–6Al–4V alloy.

The pursuit of eco-friendly and renewable power generation has driven technological breakthroughs in nanoscale engineering, particularly regarding triboelectric nanogenerators (TENGs). These devices have become a focus of interest due to their capacity to effectively transform kinetic energy into electrical power via combined triboelectrification and electrostatic charge separation mechanisms. TENGs now find expanding implementations across multiple fields including in flexible electronics, autonomous sensing systems, and ambient energy conversion technologies. Enhancing TENG performance critically depends on the strategic design and application of nanostructures and nanomaterials. Nonetheless, challenges such as material selection, compatibility, homogeneous dispersion, interfacial stability, and production scalability must be overcome to advance TENG technology. Moreover, the mechanisms by which nanomaterials contribute to the triboelectric effect remain insufficiently understood, underscoring the necessity for systematic theoretical models. This review provides a comprehensive overview of recent advancements in integrating nanostructures and nanomaterials into TENGs, elucidating their roles, advantages, and underlying mechanisms in enhancing energy conversion efficiency, while identifying key challenges and proposing future research directions.

The results of investigations and design studies for the introduction of advanced highly efficient welding processes to the production cycle of manufacture of heat exchanger systems are presented. The optimum parameters of remotely controlled laser welding of tube-to-tube plate joints made of stainless steel and titanium and copper alloys are determined. Specialized equipment for laser welding of the tube-to-tube plate joints is constructed.