HSH. Sakaki

H. Sakaki

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


H. Sakaki has a total of 136 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • X-ray spectral diagnostics of laser harmonic generation in the interaction of relativistic femtosecond laser pulses with clusters

    by A Ya Faenov, E Oks, E Dalimier, I Yu Skobelev, S A Pikuz, T A Pikuz, I A Zhvaniya, Y Fukuda, A Andreev, J Koga, et al.


  • Measurements of electron-induced neutrons as a tool for determination of electron temperature of fast electrons in the task of optimization laser-produced plasma ions acceleration

    by H. Sakaki, M. Nishiuchi, S. Maeda, A. Sagisaka, A. S. Pirozhkov, T. Pikuz, A. Faenov, K. Ogura, T. Fukami, K. Matsukawa, et al.

    High intensity laser-plasma interaction has attracted considerable interest for a number of years. The laser-plasma interaction is accompanied by generation of various charged particle beams, such as high-energy proton and ions with high charge to mass ratio (Q/M; same as multi-charged ions). Results of simultaneous novel measurements of electron-induced photonuclear neutrons (photoneutron), which are a diagnostic of the laser-plasma interaction, are proposed to use for optimization of the laser-plasma ion generation. The proposed method is demonstrated by the laser irradiation with the intensity of 1 × 1021 W/cm2 on the metal foil target. The photoneutrons are measured by using NE213 liquid scintillation detectors. Heavy-ion signal is registered with the CR-39 track detector simultaneously. The measured signals of the electron-induced photoneutrons are well reproduced by using the Particle and Heavy Ion Transport code System. The results obtained provide useful approach for analyzing the various laser based ion beams.


  • Development of a single-shot-imaging thin film for an online Thomson parabola spectrometer

    by H. Sakaki, M. Kanasaki, Y. Fukuda, M. Nishiuchi, T. Hori, A. Yogo, S. Jinno, K. Niita

    A single-shot-imaging thin scintillator film was developed for an online Thomson parabola (TP) spectrometer and the first analysis of laser accelerated ions, using the online TP spectrometer, was demonstrated at the JAEA-Kansai Advanced Relativistic Engineering Laser System (J-KAREN). An energy spectrum of ∼4.0 MeV protons is obtained using only this imaging film without the need of a microchannel plate that is typically utilized in online ion analyses. A general-purpose Monte Carlo particle and heavy ion-transport code system, which consists of various quantum dynamics models, was used for the prediction of the luminescent properties of the scintillator. The simulation can reasonably predict not only the ion trajectories detected by the spectrometer, but also luminescence properties.


  • Ion Acceleration in Subcritical Density Plasma via Interaction of Intense Laser Pulse with Cluster-Gas Target

    by Y. Fukuda, A. Ya. Faenov, M. Tampo, T. A. Pikuz, T. Nakamura, M. Kando, Y. Hayashi, A. Yogo, H. Sakaki, T. Kameshima, et al.

  • Laser driven proton beam for the applications: toward ultra-high intensity & short pulse proton beam

    by M. Nishiuchi, I. Daito, M. Ikegami, M. Mori, S. Orimo, K. Ogura, A. Sagisaka, A. Yogo, A. S. Pirozhkov, H. Sugiyama, et al.

    As a benchmark experiment to realize a novel and compact laser driven proton accelerator whose significant features are high number density in a short pulse width (∼ns), 2.4 MeV laser driven proton beam is stably focused at 1 Hz repetition rate by using a pair of permanent quadrupole magnets (PMQs) with large apertures whose diameters and field strengths are 3.5 cm and 55 T/m for the first and 2.3 cm and 60 T/m for the second magnets, respectively. The proton beam has been focused to a focal spot of 3×8 mm2 in horizontal and vertical direction (full width at half maximum) at 650∼mm from the source, which is well reproduced by the simulation. The further optimization of the focusing system will sure to pave a way to the novel proton accelerator with which we can investigate the physics appeared in the short time scale as well as that in a high energy density matter, oncology, astrophysics, and so on.

  • Ion acceleration in the interaction of short pulse laser radiation with the cluster-gas target

    by Y. Fukuda, A. Ya. Faenov, M. Tampo, T. A. Pikuz, T. Nakamura, M. Kando, Y. Hayashi, A. Yogo, H. Sakaki, T. Kameshima, et al.

    We demonstrate generation of 10–20 MeV/u ions with a compact 4 TW laser using a gas target mixed with submicron clusters, corresponding to tenfold increase in the ion energies compared to previous experiments with solid targets. It is inferred that the high energy ions are generated due to formation of a strong dipole vortex structure. The demonstrated method has a potential to construct compact and high repetition rate ion sources for hadron therapy and other applications.


  • Femtosecond-Laser-Driven Cluster-Based Plasma Source for High-Resolution Ionography

    by A. Ya. Faenov, T. A. Pikuz, Y. Fukuda, M. Kando, H. Kotaki, T. Homma, K. Kawase, T. Kameshima, A. Pirozhkov, A. Yogo, et al.

    The intense isotropic source of multicharged ions, with energy above 300 keV, was produced by femtosecond Ti:Sa laser pulses irradiation (intensity of ∼4×1017 W/cm2 ) of the He and CO2 gases mixture expanded in supersonic jet. High contrast ionography images have been obtained for 2000 dpi metal mesh, 1 μm polypropylene and 100 nm Zr foils, as well as for different biological objects. Images were recorded on 1 mm thick CR‐39 ion detector placed in contact with back surface of the imaged samples, at the distances 140–160 mm from the plasma source. The obtained spatial resolution of the image was ∼600 nm. A 100 nm object thickness difference was resolved very well for both Zr and polymer foils. The multicharged ion energy for Carbon and Oxygen ions passing through the 1 μm polypropylene foil is estimated to give the energy of more than 300 keV. An almost equal number of ions were measured with total number of about 108 per shot at a different direction from plasma source. Easy production of different sub‐MeV ions in wide space angle, recognizes femtosecond‐laser‐driven‐cluster‐based plasma as a well‐suited bright source for novel type of submicron ionography to image different media, including nanofoils, membranes, and other low‐contrast objects.

  • Present Status of the J-PARC Control System

    by T. Katoh, K. Furukawa, N. Kamikubota, H. Nakagawa, J. Odagiri, G. Shen, N. Takeuchi, N. Yamamoto, M. Yoshii, H. Sakaki, et al.

    The present status of the design and construction of the control system for Japan Proton Accelerator Research Complex (J-PARC) is given. J-PARC is a 3-stage accelerator complex with a 200MeV Linac, a 3GeV Rapid Cycling Synchrotron (RCS) and a 50GeV Main Ring synchrotron (MR). The accelerators are under construction jointly by Japan Atomic Energy Research Institute (JAERI) and KEK, High Energy Accelerator Research Organization. Linac and RCS are being constructed mainly by JAERI and MR is mainly by KEK. [1,2] And the control systems for Linac and RCS [17] are constructed mainly by JAERI and that of MR is done mainly by KEK. [3] Commissioning of Linac, RCS and MR are scheduled in September 2006, May 2007, and January 2008, respectively. There are three control systems under construction corresponding to three accelerators. These three control systems will be operated from one central control room when each control system is completed construction. We chose Experimental Physics and Industrial System (EPICS) [4] as the software environment so that three control systems can be unified easily to single control system. J-PARC control system has the three-layer standard model architecture for accelerator controls that is very common in the EPICS world. We have chosen the standard network protocol TCP/IP and UDP/IP as the J-PARC standard field-bus used to connect interface units that links accelerator component to the control system.


  • Control System of 3 GeV Rapid Cycling Synchrotron at J-PARC

    by H. Takahashi, H. Sakaki, H. Sako, H. Yoshikawa, M. Kawase, Y. Kato, Y. Itoh, M. Sugimoto

    Since the 3GeV Rapid Cycling Synchrotron (RCS) produces huge beam power of 1 MW, extreme cares must be taken to design the control system in order to minimize radiation due to beam loss. Another complexity appears in the control system, because each beam bunch of 25 Hz is required to be injected either into the Material and Life Science Facility (MLF) or into the 50GeV Main Ring (MR). Therefore, each bunch of 25 Hz must be operated with different parameters, and the data acquisition system also must collect synchronized data within each pulse. To achieve these goals, a control system via reflective memory and wave endless recorders have been developed. EPICS is adopted in the control system. Since the number of devices is huge, the management of EPICS records and their configurations need huge amount of time and man power. To reduce this work significantly, a Relational Data Base (RDB) for static machine information has been developed. This RDB stores (1) EPICS related information of devices, interfaces, and Input Output Controller (IOC) with a capability to generate EPICS records automatically, and (2) geometrical information of components with a capability to generate lattice files for various simulation codes. The status of the RCS control system focusing on the data acquisition system and the RDB will be presented.


  • Fast beam current monitor for SPring-8 linac

    by K. Yanagida, H. Yoshikawa, S. Suzuki, A. Mizuno, H. Sakaki, T. Taniuchi, T. Hori, T. Kobayashi, T. Asaka, H. Yokomizo

    A fast rise time, broad band width and wide dynamic range current monitor was developed for SPring-8 linac. The current monitor has the structure of wall current monitor that is a single-turn current transformer. The measured characteristics are the rise time of ∼250 ps, the output of 1.4∼1.5 V/A (effective impedance of 1.4∼1.5 Ω ), the broad bandwidth (20 kHz–2 GHz) and the output linearity in the current range of 0–12 A.