Pierre Jouy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Pierre Jouy has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Jérôme Faist
ETH Zurich
3 shared publications Alexander Wirthmueller
UNINE, Laboratoire temps-fréquence, Avenue de Bellevaux 51, 2000 Neuchâtel, Switzerland
1 shared publicationAlexandra Homsy
Ecole Polytechnique Fédérale de Lausanne (EPFL), Institute of Microengineering, Sensors, Actuators and Microsystems Laboratory (SAMLAB), Rue Jaquet-Droz 1, Neuchâtel, Switzerland
1 shared publication- Borislav Hinkov
Silicon Austria Labs Villach Austria
1 shared publication Béla Tuzson
Empa, Swiss Federal Laboratories for Materials Science and Technology, Überlandstrasse 129, 8600 Dübendorf, Switzerland
1 shared publication- Christopher Bonzon
Institute for Quantum Electronics, ETH Zürich, CH-8093 Zürich, Switzerland
1 shared publication
Latest Publications
- 2 October 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (14)
Dual comb operation of λ ∼ 8.2 μm quantum cascade laser frequency comb with 1 W optical power
In this work, we report the characterization of a quantum cascade laser frequency comb with an optical power of 1.05 W at λ∼8.2 μm. A 4.5 mm long device has a high reflectivity coating on the back facet as well as a top cladding designed to lower the group velocity dispersion and is operated at 258 K. Very strong (more than 60 dB) narrow beatnotes are shown, and frequency comb operation is obtained on a bandwidth of 85 cm−1 in a very large range of light-versus current characteristics. A bandwidth of 82 cm−1 has a power per mode of more than 1 mW and an average power per mode of 4.1 mW. Finally, a multi-heterodyne spectrum with 215 lines covering an optical bandwidth of more than 70 cm−1 measured with lasers showing similar performances is presented with very good line separation.
- 2 October 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (14)
Dual comb operation of λ ∼ 8.2 μm quantum cascade laser frequency comb with 1 W optical power
In this work, we report the characterization of a quantum cascade laser frequency comb with an optical power of 1.05 W at λ∼8.2 μm. A 4.5 mm long device has a high reflectivity coating on the back facet as well as a top cladding designed to lower the group velocity dispersion and is operated at 258 K. Very strong (more than 60 dB) narrow beatnotes are shown, and frequency comb operation is obtained on a bandwidth of 85 cm−1 in a very large range of light-versus current characteristics. A bandwidth of 82 cm−1 has a power per mode of more than 1 mW and an average power per mode of 4.1 mW. Finally, a multi-heterodyne spectrum with 215 lines covering an optical bandwidth of more than 70 cm−1 measured with lasers showing similar performances is presented with very good line separation.
- Open Access
Advanced Fabrication of Single-Mode and Multi-Wavelength MIR-QCLs
In this article we present our latest work on the optimization of mid-infrared quantum cascade laser fabrication techniques. Our efforts are focused on low dissipation devices, broad-area high-power photonic crystal lasers, as well as multi-wavelength devices realized either as arrays or multi-section distributed feedback (DFB) devices. We summarize our latest achievements and update them with our most recent results.
Open AccessAdvanced Fabrication of Single-Mode and Multi-Wavelength MIR-QCLs
In this article we present our latest work on the optimization of mid-infrared quantum cascade laser fabrication techniques. Our efforts are focused on low dissipation devices, broad-area high-power photonic crystal lasers, as well as multi-wavelength devices realized either as arrays or multi-section distributed feedback (DFB) devices. We summarize our latest achievements and update them with our most recent results.
- 23 September 2013
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 139 (9) , 2039-2046
Mid-infrared spectroscopy for gases and liquids based on quantum cascade technologies
In this paper we present two compact, quantum cascade laser absorption spectroscopy based, sensors developed for trace substance detection in gases and liquids. The gas sensor, in its most integrated version, represents the first system combining a quantum cascade laser and a quantum cascade detector. Furthermore, it uses a toroidal mirror cell with a volume of only 40 cm3 for a path length of up to 4 m. The analytical performance is assessed by the measurements of isotope ratios of CO2 at ambient abundance. For the 13CO2/12CO2 isotope ratio, a measurement precision of 0.2‰ is demonstrated after an integration time of 600 s. For the liquid sensor, a microfluidic system is used to extract cocaine from saliva into a solvent (PCE) transparent in the mid-infrared. This system is bonded on top of a Si/Ge waveguide and the concentration of cocaine in PCE is measured through the interaction of the evanescent part of the waveguide optical mode and the solvent flowing on top. A detection limit of −1 was achieved with this system and down to 10 μg mL−1 with a simplified, but improved system.
- 23 September 2013
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 139 (9) , 2039-2046
Mid-infrared spectroscopy for gases and liquids based on quantum cascade technologies
In this paper we present two compact, quantum cascade laser absorption spectroscopy based, sensors developed for trace substance detection in gases and liquids. The gas sensor, in its most integrated version, represents the first system combining a quantum cascade laser and a quantum cascade detector. Furthermore, it uses a toroidal mirror cell with a volume of only 40 cm3 for a path length of up to 4 m. The analytical performance is assessed by the measurements of isotope ratios of CO2 at ambient abundance. For the 13CO2/12CO2 isotope ratio, a measurement precision of 0.2‰ is demonstrated after an integration time of 600 s. For the liquid sensor, a microfluidic system is used to extract cocaine from saliva into a solvent (PCE) transparent in the mid-infrared. This system is bonded on top of a Si/Ge waveguide and the concentration of cocaine in PCE is measured through the interaction of the evanescent part of the waveguide optical mode and the solvent flowing on top. A detection limit of −1 was achieved with this system and down to 10 μg mL−1 with a simplified, but improved system.