John Adam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
John Adam has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Erik H. Hauri
Carnegie Institution of Washington, 5424 Broad Branch Road, Washington, D.C. 20005, U.S.A.
1 shared publication- Juan Carlos Afonso
Faculty of Geo-Information Science and Earth Observation (ITC), University of Twente
1 shared publication - Marco L. Fiorentini
Centre for Exploration Targeting, School of Earth Sciences, University of Western Australia, Australia
1 shared publication Marek Locmelis
Centre for Exploration Targeting, Australian Research Council Centre of Excellence for Core to Crust Fluid Systems, School of Earth and Environment The University of Western Australia Crawley, Western Australia Australia
1 shared publicationMichael Turner
Department of Earth and Planetary Sciences, Macquarie University, New South Wales 2109, Australia
1 shared publication- Simon Turner
Macquarie University
1 shared publication
Latest Publications
- 1 April 2016
- Published by Mineralogical Society of America in American Mineralogist: Journal of Earth and Planetary Materials
- Vol. 101 (4) , 876-888
Crystal/melt partitioning of water and other volatiles during the near-solidus melting of mantle peridotite: Comparisons with non-volatile incompatible elements and implications for the generation of intraplate magmatism
Concentrations of H2O, F, Cl, C, P, and S have been measured by secondary ion mass spectrometry (SIMS) in experimentally produced peridotite phases (including clinopyroxene, orthopyroxene, olivine, garnet, amphibole, and mica) and coexisting basanitic glasses. Because only two experiments produced glasses on quenching (with the melt phase in others reverting to felt-like crystallite masses) H2O concentrations in melts were also separately determined from mass-balance relationships and by assuming constant H2O/La in melts and starting materials. The resulting values were used to calculate mineral/melt partition coefficients (D values) for H2O [where DH2Ocrystal/melt = (mass fraction of H2O in crystal)/(mass fraction of H2O in melt)] for conditions of 1025–1190 °C and 1.0–3.5 GPa. These gave 0.0064–0.0164 for clinopyroxene, 0.0046–0.0142 for orthopyroxene, 0.0015–0.0016 for olivine, and 0.0016–0.0022 for garnet. Although less information was obtained for the other volatiles, F was found to be significantly more compatible than H2O during peridotite melting, whereas Cl is significantly less compatible. S also has small but appreciable solubilities in amphiboles and micas, but not in pyroxenes or olivine. The solubility of C in silicate minerals appears to be negligible, although C was present in coexisting melts (~0.5 wt% as CO2) and as residual graphite during experiments. The D values for H2O in clinopyroxene and orthopyroxene are positively correlated with ivAl but negatively correlated with the H2O concentrations of melts (when considered as wt%). These relationships are consistent with the broad trends of previously published partitioning data. Although some of the concentration dependence can be related to cross-correlation between ivAl in pyroxenes and H2O concentrations in melts (via the latter’s control of liquidus temperatures) this relationship is too inconsistent to be a complete explanation. A concentration dependence for DH2Omineral/melt can also be independently predicted from speciation models for H2O in silicate melts. Thus it is likely that DH2Opyx/melt is influenced by both ivAl and the absolute concentration of H2O in melts. DH2O/DCe for clinopyroxene is inversely correlated with M2 site radii. Because the latter decrease with increasing pressure and temperature, relatively hot and/or deeply derived melts should be enriched in Ce relative to H2O when compared to melts from cooler and shallower mantle sources. Conversely, melts from H2O-rich settings (e.g., subduction zones) should have higher H2O/Ce than their source rocks. When combined with previously obtained partitioning data for non-volatile elements (from the same experiments), our data are consistent with the enrichment of intraplate basalt sources in both volatile and non-volatile incompatible elements by small-degree melts derived from local mid-ocean ridge basalt sources. In this way, volatiles can be seen to play an active role (via their promotion of partial-melting and metasomatic processes) in the auto-regulation of incompatible element concentrations in the depleted upper mantle.
- 1 April 2016
- Published by Mineralogical Society of America in American Mineralogist: Journal of Earth and Planetary Materials
- Vol. 101 (4) , 876-888
Crystal/melt partitioning of water and other volatiles during the near-solidus melting of mantle peridotite: Comparisons with non-volatile incompatible elements and implications for the generation of intraplate magmatism
Concentrations of H2O, F, Cl, C, P, and S have been measured by secondary ion mass spectrometry (SIMS) in experimentally produced peridotite phases (including clinopyroxene, orthopyroxene, olivine, garnet, amphibole, and mica) and coexisting basanitic glasses. Because only two experiments produced glasses on quenching (with the melt phase in others reverting to felt-like crystallite masses) H2O concentrations in melts were also separately determined from mass-balance relationships and by assuming constant H2O/La in melts and starting materials. The resulting values were used to calculate mineral/melt partition coefficients (D values) for H2O [where DH2Ocrystal/melt = (mass fraction of H2O in crystal)/(mass fraction of H2O in melt)] for conditions of 1025–1190 °C and 1.0–3.5 GPa. These gave 0.0064–0.0164 for clinopyroxene, 0.0046–0.0142 for orthopyroxene, 0.0015–0.0016 for olivine, and 0.0016–0.0022 for garnet. Although less information was obtained for the other volatiles, F was found to be significantly more compatible than H2O during peridotite melting, whereas Cl is significantly less compatible. S also has small but appreciable solubilities in amphiboles and micas, but not in pyroxenes or olivine. The solubility of C in silicate minerals appears to be negligible, although C was present in coexisting melts (~0.5 wt% as CO2) and as residual graphite during experiments. The D values for H2O in clinopyroxene and orthopyroxene are positively correlated with ivAl but negatively correlated with the H2O concentrations of melts (when considered as wt%). These relationships are consistent with the broad trends of previously published partitioning data. Although some of the concentration dependence can be related to cross-correlation between ivAl in pyroxenes and H2O concentrations in melts (via the latter’s control of liquidus temperatures) this relationship is too inconsistent to be a complete explanation. A concentration dependence for DH2Omineral/melt can also be independently predicted from speciation models for H2O in silicate melts. Thus it is likely that DH2Opyx/melt is influenced by both ivAl and the absolute concentration of H2O in melts. DH2O/DCe for clinopyroxene is inversely correlated with M2 site radii. Because the latter decrease with increasing pressure and temperature, relatively hot and/or deeply derived melts should be enriched in Ce relative to H2O when compared to melts from cooler and shallower mantle sources. Conversely, melts from H2O-rich settings (e.g., subduction zones) should have higher H2O/Ce than their source rocks. When combined with previously obtained partitioning data for non-volatile elements (from the same experiments), our data are consistent with the enrichment of intraplate basalt sources in both volatile and non-volatile incompatible elements by small-degree melts derived from local mid-ocean ridge basalt sources. In this way, volatiles can be seen to play an active role (via their promotion of partial-melting and metasomatic processes) in the auto-regulation of incompatible element concentrations in the depleted upper mantle.
- Open Access
- 26 March 2014
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 15 (6) , 2241-2253
The capacity of hydrous fluids to transport and fractionate incompatible elements and metals within the Earth's mantle
Both silicate melts and aqueous fluids are thought to play critical roles in the chemical differentiation of the Earth's crust and mantle. Yet their relative effects are poorly constrained. We have addressed this issue by measuring partition coefficients for 50 trace and minor elements in experimentally produced aqueous fluids, coexisting basanite melts, and peridotite minerals. The experiments were conducted at 1.0–4.0 GPa and 950–1200°C in single capsules containing (either 40 or 50 wt %) H2O and trace element‐enriched basanite glass. This allowed run products to be easily identified and analyzed by a combination of electron microprobe and LAM‐ICP‐MS. Fluid and melt compositions were reconstructed from mass balances and published solubility data for H2O in silicate melts. Relative to the basanite melt, the solutes from H2O‐fluids are enriched in SiO2, alkalis, Ba, and Pb, but depleted in FeO, MgO, CaO, and REE. With increasing pressure, the mutual solubility of fluids and melts increases rapidly with complete miscibility between H2O and basanitic melts occurring between 3.0 and 4.0 GPa at 1100°C. Although LREE are favored over HREE in the fluid phase, they are less soluble than the HFSE (Nb, Ta, Zr, Hf, and Ti). Thus, the relative depletions of HFSE that are characteristic of arc magmas must be due to a residual phase that concentrates HFSE (e.g., rutile). Otherwise, H2O‐fluids have the capacity to impart many of the geochemical characteristics that distinguish some rocks and melts from the deep mantle lithosphere (e.g., MARID and lamproites).
- 26 March 2014
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 15 (6) , 2241-2253
Open AccessThe capacity of hydrous fluids to transport and fractionate incompatible elements and metals within the Earth's mantle
Both silicate melts and aqueous fluids are thought to play critical roles in the chemical differentiation of the Earth's crust and mantle. Yet their relative effects are poorly constrained. We have addressed this issue by measuring partition coefficients for 50 trace and minor elements in experimentally produced aqueous fluids, coexisting basanite melts, and peridotite minerals. The experiments were conducted at 1.0–4.0 GPa and 950–1200°C in single capsules containing (either 40 or 50 wt %) H2O and trace element‐enriched basanite glass. This allowed run products to be easily identified and analyzed by a combination of electron microprobe and LAM‐ICP‐MS. Fluid and melt compositions were reconstructed from mass balances and published solubility data for H2O in silicate melts. Relative to the basanite melt, the solutes from H2O‐fluids are enriched in SiO2, alkalis, Ba, and Pb, but depleted in FeO, MgO, CaO, and REE. With increasing pressure, the mutual solubility of fluids and melts increases rapidly with complete miscibility between H2O and basanitic melts occurring between 3.0 and 4.0 GPa at 1100°C. Although LREE are favored over HREE in the fluid phase, they are less soluble than the HFSE (Nb, Ta, Zr, Hf, and Ti). Thus, the relative depletions of HFSE that are characteristic of arc magmas must be due to a residual phase that concentrates HFSE (e.g., rutile). Otherwise, H2O‐fluids have the capacity to impart many of the geochemical characteristics that distinguish some rocks and melts from the deep mantle lithosphere (e.g., MARID and lamproites).