Afsaneh Afzali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Afsaneh Afzali has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Fatemeh Hadian
Department of Natural Resources, Isfahan University of Technology, Isfahan, Iran
2 shared publicationsLeila Yaghmaei
Department of Natural Resources, Isfahan University of Technology, Isfahan, Iran
2 shared publicationsSoheil Sabri
Center for Spatial Data Infrastructures and Land Administration, The University of Melbourne, Melbourne, Australia
2 shared publications- Hoda Allami
Department of Environment, Faculty of Natural Resources and Earth Sciences, University of Kashan, Kashan, Iran
1 shared publication Hossein Vahidi
Department of Environment, Institute of Science and High Technology and Environmental Sciences, Graduate University of Advanced Technology, Kerman, Iran
1 shared publicationKatayoun Omidi
Department of Environment, Faculty of Natural Resources and Earth Sciences, University of Kashan, Kashan, Iran
1 shared publication
Latest Publications
- 16 May 2024
- Published by Springer Nature in International Journal of Biometeorology
- Vol. 68 (7) , 1357-1370
Investigating net primary production in climate regions of Khuzestan Province, Iran using CASA model
This study aimed to investigate the vegetation production changes in Khuzestan province, Iran using MODIS data production, meteorological data, vegetation maps as well as topographic and field monitoring data in CASA model. The study area was divided into different climatic classes based on multivariate statistical method, so the vegetation of each climatic region was examined separately for changes in NPP values. Production changes due to degradation were calculated using the Miami model and subsequently, the rain use efficiency (RUE) and the light use efficiency (LUE) and correlation indices between the CASA model and ground data were determined. The results of this study (R2) showed that the accuracy of this model varies depending on the type of climatic regions (R2 = 0.80 to R2 = 0.15). In different climatic regions, the rate of NPP changes (very humid 68 gC/m2 to ultra-dry 15 gC/m2) varies in rangeland types. The highest rate of vegetation production is observed seasonally in May. Degradation conditions also reduced RUE and LUE. However, in hyper-arid regions, adaptations of plants in some different species (Hammada Spp.) increase their efficiency compared to other vegetation types. The results showed the importance of vegetation and climate classification in vegetation production studies.
- 16 May 2024
- Published by Springer Nature in International Journal of Biometeorology
- Vol. 68 (7) , 1357-1370
Investigating net primary production in climate regions of Khuzestan Province, Iran using CASA model
This study aimed to investigate the vegetation production changes in Khuzestan province, Iran using MODIS data production, meteorological data, vegetation maps as well as topographic and field monitoring data in CASA model. The study area was divided into different climatic classes based on multivariate statistical method, so the vegetation of each climatic region was examined separately for changes in NPP values. Production changes due to degradation were calculated using the Miami model and subsequently, the rain use efficiency (RUE) and the light use efficiency (LUE) and correlation indices between the CASA model and ground data were determined. The results of this study (R2) showed that the accuracy of this model varies depending on the type of climatic regions (R2 = 0.80 to R2 = 0.15). In different climatic regions, the rate of NPP changes (very humid 68 gC/m2 to ultra-dry 15 gC/m2) varies in rangeland types. The highest rate of vegetation production is observed seasonally in May. Degradation conditions also reduced RUE and LUE. However, in hyper-arid regions, adaptations of plants in some different species (Hammada Spp.) increase their efficiency compared to other vegetation types. The results showed the importance of vegetation and climate classification in vegetation production studies.
- Open Access
- 23 January 2024
- Published by Maad Rayan Publishing Company in Environmental Health Engineering and Management
- Vol. 11 (1) , 31-38
Assessment of pollution and ecological risk of heavy metals in the sediments of the western coast of Persian Gulf: A case study in Dayer port
Background: In recent years, the pollution of heavy metals in the beaches has been noticed due to the increase of human activities. This study aimed to evaluate heavy metal pollution, its ecological risk, and possible sources in the coastline of Dayer Port, Bushehr province. Methods: The sediment samples were collected from 8 stations with different uses in 0-5 and 5-20 cm depths. The samples were evaluated to measure the concentration of Pb, Cu, Ni, and Mn after acid digestion by atomic absorption spectrometry (AAS). Subsequently, the ecological risk index was used to evaluate the environmental risk potential caused by heavy metal pollution. The statistical analysis was used to determine the source of pollutants and their relationship. Results: The average concentration of Mn, Ni, Cu, and Pb were 218.59, 10.44, 11.78, and 7.81 μg g-1 in surface sediments and 278.05, 15.79, 12.74, and 10. 75 μg g-1 in deep sediments, respectively. The results of evaluating the ecological risk index caused by heavy metal pollution in the coastal sediments of the studied area showed that the environmental risk is low (>150). The results of multivariate statistical analyses showed that the investigated metals are of natural and anthropogenic origin mainly natural sources. Conclusion: The presence of heavy metals in all collected sediment samples shows that heavy metals are common pollutants in the study area. As a result, regular monitoring of the area is important to control and reduce heavy metal pollution.
- 23 January 2024
- Published by Maad Rayan Publishing Company in Environmental Health Engineering and Management
- Vol. 11 (1) , 31-38
Open AccessAssessment of pollution and ecological risk of heavy metals in the sediments of the western coast of Persian Gulf: A case study in Dayer port
Background: In recent years, the pollution of heavy metals in the beaches has been noticed due to the increase of human activities. This study aimed to evaluate heavy metal pollution, its ecological risk, and possible sources in the coastline of Dayer Port, Bushehr province. Methods: The sediment samples were collected from 8 stations with different uses in 0-5 and 5-20 cm depths. The samples were evaluated to measure the concentration of Pb, Cu, Ni, and Mn after acid digestion by atomic absorption spectrometry (AAS). Subsequently, the ecological risk index was used to evaluate the environmental risk potential caused by heavy metal pollution. The statistical analysis was used to determine the source of pollutants and their relationship. Results: The average concentration of Mn, Ni, Cu, and Pb were 218.59, 10.44, 11.78, and 7.81 μg g-1 in surface sediments and 278.05, 15.79, 12.74, and 10. 75 μg g-1 in deep sediments, respectively. The results of evaluating the ecological risk index caused by heavy metal pollution in the coastal sediments of the studied area showed that the environmental risk is low (>150). The results of multivariate statistical analyses showed that the investigated metals are of natural and anthropogenic origin mainly natural sources. Conclusion: The presence of heavy metals in all collected sediment samples shows that heavy metals are common pollutants in the study area. As a result, regular monitoring of the area is important to control and reduce heavy metal pollution.
- Open Access
- 23 May 2023
- Published by Springer Nature in Research Square
Investigating Net Primary Production in Climate Regions of Khuzestan Province, Iran using CASA model
This study aimed to investigate the vegetation production changes in Khuzestan province, Iran using MODIS data production, meteorological data, vegetation maps as well as topographic and field monitoring data in CASA model. The study area was divided into different climatic classes based on multivariate statistical method, so the vegetation of each climatic region was examined separately for changes in NPP values. Production changes due to degradation were calculated using the Miami model and subsequently, the rain use efficiency (RUE) and the light use efficiency (LUE) and correlation indices between the CASA model and ground data were determined. The results of this study (R2) showed that the accuracy of this model varies depending on the type of climatic regions (R2 = 80 to R2 = 15). In different climatic regions, the rate of NPP changes (very humid 68 gC/m2 to ultra-dry 15 gC/m2) varies in rangeland types. The highest rate of vegetation production is observed seasonally in May. Degradation conditions also reduced RUE and LUE. However, in hyper-arid regions, adaptations of plants in some different species (Hammada sp.) increase their efficiency compared to other vegetation types. The results showed the importance of vegetation and climate classification in vegetation production studies.
- 23 May 2023
- Published by Springer Nature in Research Square
Open AccessInvestigating Net Primary Production in Climate Regions of Khuzestan Province, Iran using CASA model
This study aimed to investigate the vegetation production changes in Khuzestan province, Iran using MODIS data production, meteorological data, vegetation maps as well as topographic and field monitoring data in CASA model. The study area was divided into different climatic classes based on multivariate statistical method, so the vegetation of each climatic region was examined separately for changes in NPP values. Production changes due to degradation were calculated using the Miami model and subsequently, the rain use efficiency (RUE) and the light use efficiency (LUE) and correlation indices between the CASA model and ground data were determined. The results of this study (R2) showed that the accuracy of this model varies depending on the type of climatic regions (R2 = 80 to R2 = 15). In different climatic regions, the rate of NPP changes (very humid 68 gC/m2 to ultra-dry 15 gC/m2) varies in rangeland types. The highest rate of vegetation production is observed seasonally in May. Degradation conditions also reduced RUE and LUE. However, in hyper-arid regions, adaptations of plants in some different species (Hammada sp.) increase their efficiency compared to other vegetation types. The results showed the importance of vegetation and climate classification in vegetation production studies.
- 14 October 2022
- Published by Maad Rayan Publishing Company in Environmental Health Engineering and Management
- Vol. 9 (4) , 409-418
The assessment of groundwater vulnerability: A case study in the Doroud-Boroujerd aquifer, Iran
- 14 October 2022
- Published by Maad Rayan Publishing Company in Environmental Health Engineering and Management
- Vol. 9 (4) , 409-418
The assessment of groundwater vulnerability: A case study in the Doroud-Boroujerd aquifer, Iran
- Open Access
- 1 April 2022
- Published by Maad Rayan Publishing Company in Journal of Advances in Environmental Health Research
- Vol. 10 (2) , 133-148
Ranking of Suitable Areas for Establishing Industries in Kashan City Using VIKOR and TOPSIS Methods in Fuzzy Environment
Background: In this research, among the Multi Criteria Decision Making (MCDM) methods, a combination of VIKOR and TOPSIS methods with fuzzy set theory was used to overcome the uncertainty in the ranking of alternatives. The purpose of this paper was to locate the industries of Kashan City and rank the appropriate alternatives using analytic hierarchical process (AHP) and the prioritization methods of fuzzy VIKOR and fuzzy TOPSIS.Methods: In this study, first, the effective criteria in GIS (Geographic Information System) were examined and standardized according to fuzzy logic. Then, by presenting expert opinion through AHP, the criteria were weighted, and in order to determine suitable places for establishing industries, according to the required minimum area, six alternatives were extracted from the weighted linear combination method. Subsequently, the alternatives were ranked using fuzzy VIKOR and fuzzy TOPSIS methods. The sensitivity analysis was performed in the fuzzy TOPSIS method by shifting the criteria weights and producing different weighting scenarios. The fuzzy VIKOR method was analyzed for different values of the υ variable.Results: Weighting of criteria by AHP showed that the distance from surface water with a weight coefficient of 0.200 was the most important one. according to the required minimum area, six alternatives were extracted from the weighted linear combination method.Conclusion: The sensitivity analysis of both methods showed that 405 hectares in the Southeast of Kashan are the best ones to establish industries.
- 1 April 2022
- Published by Maad Rayan Publishing Company in Journal of Advances in Environmental Health Research
- Vol. 10 (2) , 133-148
Open AccessRanking of Suitable Areas for Establishing Industries in Kashan City Using VIKOR and TOPSIS Methods in Fuzzy Environment
Background: In this research, among the Multi Criteria Decision Making (MCDM) methods, a combination of VIKOR and TOPSIS methods with fuzzy set theory was used to overcome the uncertainty in the ranking of alternatives. The purpose of this paper was to locate the industries of Kashan City and rank the appropriate alternatives using analytic hierarchical process (AHP) and the prioritization methods of fuzzy VIKOR and fuzzy TOPSIS.Methods: In this study, first, the effective criteria in GIS (Geographic Information System) were examined and standardized according to fuzzy logic. Then, by presenting expert opinion through AHP, the criteria were weighted, and in order to determine suitable places for establishing industries, according to the required minimum area, six alternatives were extracted from the weighted linear combination method. Subsequently, the alternatives were ranked using fuzzy VIKOR and fuzzy TOPSIS methods. The sensitivity analysis was performed in the fuzzy TOPSIS method by shifting the criteria weights and producing different weighting scenarios. The fuzzy VIKOR method was analyzed for different values of the υ variable.Results: Weighting of criteria by AHP showed that the distance from surface water with a weight coefficient of 0.200 was the most important one. according to the required minimum area, six alternatives were extracted from the weighted linear combination method.Conclusion: The sensitivity analysis of both methods showed that 405 hectares in the Southeast of Kashan are the best ones to establish industries.