Salah Al Tahar Bouguecha
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Salah Al Tahar Bouguecha has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Ali Boubakri
Laboratory Water, Membranes and Environmental Biotechnology, Center of Water Research and Technologies (CERTE), PB 273, 8020, Soliman, Tunisia
2 shared publications Amor Hafiane
Center of Researches and Water Technologies
1 shared publication- Amor Hafiane
Laboratory, Water, Membrane and Environmental Biotechnology, Centre of Research and Water Technologies, Technopark of Borj-Cedria, BP 273, Soliman 8020, Tunisia
1 shared publication Raja Bouchrit
Center of Researches and Water Technologies
1 shared publication
Latest Publications
- Open Access
- 1 December 2015
- Published by Elsevier in Desalination and Water Treatment
- Vol. 56 (10) , 2723-2730
Nitrate removal from aqueous solution by direct contact membrane distillation using two different commercial membranes
In the present work, the removal of nitrate from aqueous solution by direct contact membrane distillation (DCMD) using flat sheets polypropylene (PP) and polyvinylidene fluoride (PVDF) membranes was studied. Effect of operating parameters, such as feed temperature, feed flow rate, initial nitrate concentration, feed ionic strength, and competing co-existing anions on permeate flux and nitrate rejection, was investigated. In all DCMD experimental runs, an almost complete nitrate rejection was achieved (higher than 99.90%) and the permeate nitrate concentration was largely below the maximum permissible level in potable water. Under the same operating conditions, PVDF hydrophobic membrane showed a higher permeate flux of 37.21 L/m2h than PP membrane with a permeate flux of 4.12 L/m2h. For both the membranes, feed temperature is the important operating parameter which enhanced exponentially the permeate flux. Likewise, a positive effect on permeate flux was found when feed flow rate was increased. However, no significant effect was found by varying initial nitrate concentration, feed ionic strength, and the presence of co-existing anions on DCMD permeate flux or nitrate rejection efficiency.
- 1 December 2015
- Published by Elsevier in Desalination and Water Treatment
- Vol. 56 (10) , 2723-2730
Open AccessNitrate removal from aqueous solution by direct contact membrane distillation using two different commercial membranes
In the present work, the removal of nitrate from aqueous solution by direct contact membrane distillation (DCMD) using flat sheets polypropylene (PP) and polyvinylidene fluoride (PVDF) membranes was studied. Effect of operating parameters, such as feed temperature, feed flow rate, initial nitrate concentration, feed ionic strength, and competing co-existing anions on permeate flux and nitrate rejection, was investigated. In all DCMD experimental runs, an almost complete nitrate rejection was achieved (higher than 99.90%) and the permeate nitrate concentration was largely below the maximum permissible level in potable water. Under the same operating conditions, PVDF hydrophobic membrane showed a higher permeate flux of 37.21 L/m2h than PP membrane with a permeate flux of 4.12 L/m2h. For both the membranes, feed temperature is the important operating parameter which enhanced exponentially the permeate flux. Likewise, a positive effect on permeate flux was found when feed flow rate was increased. However, no significant effect was found by varying initial nitrate concentration, feed ionic strength, and the presence of co-existing anions on DCMD permeate flux or nitrate rejection efficiency.
- 23 April 2014
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 21 (17) , 10493-10501
Fluoride removal from aqueous solution by direct contact membrane distillation: theoretical and experimental studies
Direct contact membrane distillation (DCMD) process using polyvinylidene fluoride (PVDF) membrane was used for fluoride removal from aqueous solution. This study has been carried out on heat and mass transfer analyses in DCMD. The dusty-gas model was used to analyze the mass transfer mechanism and to calculate the permeate flux. The heat transfer is analyzed based on energy balance, and the different layers are considered as a series of thermal resistances. Mass transfer analysis showed that the transition Knudsen-molecular diffusion is the dominant mechanism to describe the transport of water vapor through the pores of the PVDF membrane. The most significant operating parameter is the feed temperature. The permeate increases sensitively with feed temperature and velocity, and it shows insignificant change with feed salts concentration. Heat transfer analysis showed the conduction through the matrix of the membrane presents the major part of available energy. The increasing feed temperature leads to increase thermal efficiency (TE) and decrease temperature polarization coefficient (TPC). The experimental results are in good agreement with theoretical values. Therefore, it is suggested to work at high feed temperature, which will benefit both the thermal efficiency and permeate flux. The experimental results proved that DCMD process is able to produce almost fluoride-free water suitable for many beneficial uses.
- 23 April 2014
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 21 (17) , 10493-10501
Fluoride removal from aqueous solution by direct contact membrane distillation: theoretical and experimental studies
Direct contact membrane distillation (DCMD) process using polyvinylidene fluoride (PVDF) membrane was used for fluoride removal from aqueous solution. This study has been carried out on heat and mass transfer analyses in DCMD. The dusty-gas model was used to analyze the mass transfer mechanism and to calculate the permeate flux. The heat transfer is analyzed based on energy balance, and the different layers are considered as a series of thermal resistances. Mass transfer analysis showed that the transition Knudsen-molecular diffusion is the dominant mechanism to describe the transport of water vapor through the pores of the PVDF membrane. The most significant operating parameter is the feed temperature. The permeate increases sensitively with feed temperature and velocity, and it shows insignificant change with feed salts concentration. Heat transfer analysis showed the conduction through the matrix of the membrane presents the major part of available energy. The increasing feed temperature leads to increase thermal efficiency (TE) and decrease temperature polarization coefficient (TPC). The experimental results are in good agreement with theoretical values. Therefore, it is suggested to work at high feed temperature, which will benefit both the thermal efficiency and permeate flux. The experimental results proved that DCMD process is able to produce almost fluoride-free water suitable for many beneficial uses.