M. Ryyan Khan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
M. Ryyan Khan has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Muhammad Ashraful Alam
Elmore Family School of Electrical and Computer Engineering, Purdue University, West Lafayette, IN, USA
3 shared publications Biswajit Ray
Purdue Univ, Sch Elect & Comp Engn, W Lafayette, IN 47906 USA
1 shared publication- Muhammed Tahir Patel
Department of Electrical and Computer Engineering, Purdue University, West Lafayette, IN, USA
1 shared publication - Peter Bermel
School of Electrical and Computer Engineering, Purdue University, West Lafayette, Indiana 47907, USA
1 shared publication Xufeng Wang
School of Electrical and Computer Engineering, Purdue University, West Lafayette, IN 47907, USA
1 shared publication
Latest Publications
- 11 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 8 (4) , 1082-1089
Thermodynamic Limit of Solar to Fuel Conversion for Generalized Photovoltaic–Electrochemical Systems
Daily and seasonal variability of the solar irradiation poses a major hurdle to the widespread adoption of photovoltaic (PV) systems. An integrated photovoltaic–electrochemical (EC)-storage system offers a solution, but the thermodynamic efficiency $({\eta _{{\rm{sys}}}})$ of the “ideal” integrated system and the optimum configuration needed to realize the limit is known only for a few simple cases. Moreover, these limits are often derived through complex numerical simulations. In this paper, we show that a simple, conceptually transparent and physically intuitive analytical formula can precisely describe the ${\eta _{{\rm{sys}}}}$ of a “generalized” PV-EC integrated system. An M-cell PV module of N-junction bifacial tandem cells is illuminated under S-suns and mounted over ground of albedo ${\bm{\ }}R$. There are $K$-EC cells in series, each defined by their reaction potential, exchange current, and Tafel slope. We derive the optimum thermodynamic limit ${\eta _{{\rm{sys}}}}({N,M,K,R,S})$ for all possible combinations of a PV-EC design. For a setup with optimal-$({M,K})$ and large ${\bm{\ }}N$, under 1-sun illumination and albedo = 0, the ultimate limit is ${\bm{\ }}{\eta _{{\rm{sys}}}}{\bm{\ }}\sim {\bm{\ }}52$%. A comparison of our results with experimental results published by various groups worldwide suggests opportunities for further progress toward the corresponding thermodynamic limit.- 11 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 8 (4) , 1082-1089
Thermodynamic Limit of Solar to Fuel Conversion for Generalized Photovoltaic–Electrochemical Systems
Daily and seasonal variability of the solar irradiation poses a major hurdle to the widespread adoption of photovoltaic (PV) systems. An integrated photovoltaic–electrochemical (EC)-storage system offers a solution, but the thermodynamic efficiency $({\eta _{{\rm{sys}}}})$ of the “ideal” integrated system and the optimum configuration needed to realize the limit is known only for a few simple cases. Moreover, these limits are often derived through complex numerical simulations. In this paper, we show that a simple, conceptually transparent and physically intuitive analytical formula can precisely describe the ${\eta _{{\rm{sys}}}}$ of a “generalized” PV-EC integrated system. An M-cell PV module of N-junction bifacial tandem cells is illuminated under S-suns and mounted over ground of albedo ${\bm{\ }}R$. There are $K$-EC cells in series, each defined by their reaction potential, exchange current, and Tafel slope. We derive the optimum thermodynamic limit ${\eta _{{\rm{sys}}}}({N,M,K,R,S})$ for all possible combinations of a PV-EC design. For a setup with optimal-$({M,K})$ and large ${\bm{\ }}N$, under 1-sun illumination and albedo = 0, the ultimate limit is ${\bm{\ }}{\eta _{{\rm{sys}}}}{\bm{\ }}\sim {\bm{\ }}52$%. A comparison of our results with experimental results published by various groups worldwide suggests opportunities for further progress toward the corresponding thermodynamic limit.- Open Access
- 23 April 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (S3) , A973-A985
Enhanced light trapping in solar cells with a meta-mirror following generalized Snell’s law
As the performance of photovoltaic cells approaches the Shockley-Queisser limit, appropriate schemes are needed to minimize the losses without compromising the current performance. In this paper we propose a planar absorber-mirror light trapping structure where a conventional mirror is replaced by a meta-mirror with asymmetric light scattering properties. The meta-mirror is tailored to have reflection in asymmetric modes that stay outside the escape cone of the dielectric, hence trapping light with unit probability. Ideally, the meta-mirror can be designed to have such light trapping for any angle of incidence onto the absorber-mirror structure. We illustrate the concept by using a simple gap-plasmon meta-mirror. Even though the response of the mirror is non-ideal with the unwanted scattering modes reducing the light absorption, we observe an order of magnitude enhancement compared to single pass absorption in the absorber. The bandwidth of the enhancement can be matched with the range of wavelengths close to the solar cell absorber band-edge where improved light absorption is required.
- 23 April 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (S3) , A973-A985
Open AccessEnhanced light trapping in solar cells with a meta-mirror following generalized Snell’s law
As the performance of photovoltaic cells approaches the Shockley-Queisser limit, appropriate schemes are needed to minimize the losses without compromising the current performance. In this paper we propose a planar absorber-mirror light trapping structure where a conventional mirror is replaced by a meta-mirror with asymmetric light scattering properties. The meta-mirror is tailored to have reflection in asymmetric modes that stay outside the escape cone of the dielectric, hence trapping light with unit probability. Ideally, the meta-mirror can be designed to have such light trapping for any angle of incidence onto the absorber-mirror structure. We illustrate the concept by using a simple gap-plasmon meta-mirror. Even though the response of the mirror is non-ideal with the unwanted scattering modes reducing the light absorption, we observe an order of magnitude enhancement compared to single pass absorption in the absorber. The bandwidth of the enhancement can be matched with the range of wavelengths close to the solar cell absorber band-edge where improved light absorption is required.
- 1 January 2014
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 120, 716-723
Prospects of layer-split tandem cells for high-efficiency OPV
- 1 January 2014
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 120, 716-723
Prospects of layer-split tandem cells for high-efficiency OPV