Elisane Longhinotti
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Elisane Longhinotti has a total of 244 co-authors. Here are the top co-authors by number of shared publications:
Helena Becker
12 shared publications- Eduardo Henrique Silva Sousa
Federal University of Ceará
11 shared publications - Izaura Cirino Nogueira Diógenes
Laboratório de Bioinorgânica, Departamento de Química Orgânica E Inorgânica, Universidade Federal Do Ceará, Fortaleza, Brazil
10 shared publications - Antoninho Valentini
Department of Analytical Chemistry and Physical Chemistry, Federal University of Ceará, Campus of Pici, 60440-554, Fortaleza, Ceará, Brazil
8 shared publications - Luiz Gonzaga de França Lopes
Federal University of Ceará
7 shared publications - André Luiz Melo Camelo
Laboratory of Analysis of Biomolecules Tiselius, Department of Analytical Chemistry, Institute of Chemistry, Universidade Estadual de Campinas (UNICAMP), São Paulo, Brazil
6 shared publications
Latest Publications
- 6 October 2026
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 14 (6)
Granulometry-dependent hydroxyl radical generation by steel mill scale: A comparative investigation
- 6 October 2026
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 14 (6)
Granulometry-dependent hydroxyl radical generation by steel mill scale: A comparative investigation
- 29 January 2026
- Published by Elsevier in Journal of Chromatography A
- Vol. 1770, 466758
A fast and efficient GC-BID approach for the simultaneous analysis of H2, CO, CH4, and CO2 in vehicle exhaust
- 29 January 2026
- Published by Elsevier in Journal of Chromatography A
- Vol. 1770, 466758
A fast and efficient GC-BID approach for the simultaneous analysis of H2, CO, CH4, and CO2 in vehicle exhaust
- 1 January 2025
- Published by Sociedade Brasileira de Quimica (SBQ) in Journal of the Brazilian Chemical Society
Chitosan Pretreatment: Evidence of Enhanced Mechanical Stability and Adsorption Capacity to Produce a Hybrid Material
Securing a food supply is a global issue that must be integrated into a sustainable framework to mitigate the effects of climate change. This study focuses on the synthesis of a hybrid material for detecting heterocyclic aromatic amines (HAAs), which are potential mutagenic and carcinogenic compounds generated during the heat processing of food. A novel approach was applied to produce films based on chitosan biopolymer incorporated with [Fe(CN)5(OH2)]3−, CS-Fe, which functions as the active moiety for the detection of quinoxaline (IQx), a molecule similar to HAAs. The pretreatment of the chitosan (CS) films significantly improved mechanical stability and more than doubled the adsorption capacity for [Fe(CN)5(OH2)]3−. The measurements from real samples indicated that the CS-Fe film can selectively detect IQx, even amidst common interfering amino acids like methionine, tryptophan, and histidine. In summary, the CS-Fe film may be regarded as an eco-friendly and cost-effective material suitable for food safety applications.
- 1 January 2025
- Published by Sociedade Brasileira de Quimica (SBQ) in Journal of the Brazilian Chemical Society
Chitosan Pretreatment: Evidence of Enhanced Mechanical Stability and Adsorption Capacity to Produce a Hybrid Material
Securing a food supply is a global issue that must be integrated into a sustainable framework to mitigate the effects of climate change. This study focuses on the synthesis of a hybrid material for detecting heterocyclic aromatic amines (HAAs), which are potential mutagenic and carcinogenic compounds generated during the heat processing of food. A novel approach was applied to produce films based on chitosan biopolymer incorporated with [Fe(CN)5(OH2)]3−, CS-Fe, which functions as the active moiety for the detection of quinoxaline (IQx), a molecule similar to HAAs. The pretreatment of the chitosan (CS) films significantly improved mechanical stability and more than doubled the adsorption capacity for [Fe(CN)5(OH2)]3−. The measurements from real samples indicated that the CS-Fe film can selectively detect IQx, even amidst common interfering amino acids like methionine, tryptophan, and histidine. In summary, the CS-Fe film may be regarded as an eco-friendly and cost-effective material suitable for food safety applications.
- 22 October 2024
- Published by Elsevier in European Journal of Pharmacology
- Vol. 985, 177071
Pharmacological evaluation of a new nanoformulation in the erectile tissue of rabbits and humans
- 22 October 2024
- Published by Elsevier in European Journal of Pharmacology
- Vol. 985, 177071
Pharmacological evaluation of a new nanoformulation in the erectile tissue of rabbits and humans
- 5 October 2024
- Published by Elsevier in Journal of Chromatography A
- Vol. 1736, 465417
Evaluating BTEX in vehicle exhaust gas: A fast and efficient approach using SPME and GC-BID
- 5 October 2024
- Published by Elsevier in Journal of Chromatography A
- Vol. 1736, 465417
Evaluating BTEX in vehicle exhaust gas: A fast and efficient approach using SPME and GC-BID
- 1 January 2024
- Published by Sociedade Brasileira de Quimica (SBQ) in Revista Virtual de Química
- Vol. 16 (2) , 223-233
Anchoring of a Ruthenium Complex in Mesoporous Silica Via a Covalent Route
- 1 January 2024
- Published by Sociedade Brasileira de Quimica (SBQ) in Revista Virtual de Química
- Vol. 16 (2) , 223-233
Anchoring of a Ruthenium Complex in Mesoporous Silica Via a Covalent Route
- 6 November 2023
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 26 (1) , 392-399
Blast furnace sludge loaded with phosphate: a potential low-cost fertilizer
- 6 November 2023
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 26 (1) , 392-399
Blast furnace sludge loaded with phosphate: a potential low-cost fertilizer
- 23 September 2023
- Published by Springer Nature in Photochemical & Photobiological Sciences
- Vol. 22 (12) , 2699-2714
Degradation of xanthene-based dyes by photoactivated persulfate: experimental and computational studies
Dyes are naked-eye detectable even at low concentration levels and can cause environmental damage when released into aquatic effluents; therefore, methods for removing the residual color from the aquatic media are always a current issue. In this paper, degradation of three xanthene dyes, Rhodamine B, Eosin Y, and Sodium Fluorescein, using photoactivated persulfate was evaluated at pH 3.0 and 11.0. The dyes’ degradation followed a pseudo-first-order reaction. Although the solution is completely decolorized in 40 min at pH 3.0, achieving 75% mineralization requires a longer reaction time of 180 min. Furthermore, GC–MS analyses indicate that degradation products are mainly low-molecular weight acids, CO2 and H2O. Experiments carried out in dark and under UV irradiation showed substantial contribution of radical (SO4•− and HO•) and non-radical pathways to dye degradation in both pH. Additionally, to get more insights into the degradation pathways, HOMO–LUMO energy gaps of the dyes were calculated by DFT using MPW1PW91/MidiXo level of theory and, in general, the lower the bandgap, the faster the degradation. Fukui functions revealed that the preferential sites to radical attack were the xanthene or the benzoate portion depending on the pH, wherein attack to the xanthene ring provided better kinetic and mineralization results. Graphical abstract
- 23 September 2023
- Published by Springer Nature in Photochemical & Photobiological Sciences
- Vol. 22 (12) , 2699-2714
Degradation of xanthene-based dyes by photoactivated persulfate: experimental and computational studies
Dyes are naked-eye detectable even at low concentration levels and can cause environmental damage when released into aquatic effluents; therefore, methods for removing the residual color from the aquatic media are always a current issue. In this paper, degradation of three xanthene dyes, Rhodamine B, Eosin Y, and Sodium Fluorescein, using photoactivated persulfate was evaluated at pH 3.0 and 11.0. The dyes’ degradation followed a pseudo-first-order reaction. Although the solution is completely decolorized in 40 min at pH 3.0, achieving 75% mineralization requires a longer reaction time of 180 min. Furthermore, GC–MS analyses indicate that degradation products are mainly low-molecular weight acids, CO2 and H2O. Experiments carried out in dark and under UV irradiation showed substantial contribution of radical (SO4•− and HO•) and non-radical pathways to dye degradation in both pH. Additionally, to get more insights into the degradation pathways, HOMO–LUMO energy gaps of the dyes were calculated by DFT using MPW1PW91/MidiXo level of theory and, in general, the lower the bandgap, the faster the degradation. Fukui functions revealed that the preferential sites to radical attack were the xanthene or the benzoate portion depending on the pH, wherein attack to the xanthene ring provided better kinetic and mineralization results. Graphical abstract
- 24 June 2023
- Published by Elsevier in Environmental Nanotechnology, Monitoring & Management
- Vol. 20
Functionalized magnetic graphene oxide composites for selective toxic metal adsorption
- 24 June 2023
- Published by Elsevier in Environmental Nanotechnology, Monitoring & Management
- Vol. 20
Functionalized magnetic graphene oxide composites for selective toxic metal adsorption
- 23 May 2023
- Published by Elsevier in International Journal of Pharmaceutics
- Vol. 641, 123074
Antibacterial and antifungal action of CTAB-containing silica nanoparticles against human pathogens
- 23 May 2023
- Published by Elsevier in International Journal of Pharmaceutics
- Vol. 641, 123074
Antibacterial and antifungal action of CTAB-containing silica nanoparticles against human pathogens