Gilles Renand
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Gilles Renand has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
C. Denoyelle
Institut de l'Elevage, F-75595 Paris Cedex 12, France
1 shared publicationD. Maupetit
1 shared publication- Dominique Rocha
INRAE, AgroParisTech, GABI Université Paris‐Saclay Jouy‐en‐Josas France
1 shared publication H. Levéziel
INRA, Université de Limoges, UMR1061 Unité de Génétique Moléculaire Animale, F-87060 Limoges, France
1 shared publication- Jean-François Hocquette
INRAE, Université Clermont Auvergne, VetAgroSup
1 shared publication L. Journaux
Institut de l'Elevage, F-75595 Paris Cedex 12, France
1 shared publication
Latest Publications
- Open Access
- 23 April 2016
- Published by Springer Nature in Genetics Selection Evolution
- Vol. 48 (1) , 37
Multi-breed and multi-trait co-association analysis of meat tenderness and other meat quality traits in three French beef cattle breeds
Studies to identify markers associated with beef tenderness have focused on Warner–Bratzler shear force (WBSF) but the interplay between the genes associated with WBSF has not been explored. We used the association weight matrix (AWM), a systems biology approach, to identify a set of interacting genes that are co-associated with tenderness and other meat quality traits, and shared across the Charolaise, Limousine and Blonde d’Aquitaine beef cattle breeds. Genome-wide association studies were performed using ~500K single nucleotide polymorphisms (SNPs) and 17 phenotypes measured on more than 1000 animals for each breed. First, this multi-trait approach was applied separately for each breed across 17 phenotypes and second, between- and across-breed comparisons at the AWM and functional levels were performed. Genetic heterogeneity was observed, and most of the variants that were associated with WBSF segregated within rather than across breeds. We identified 206 common candidate genes associated with WBSF across the three breeds. SNPs in these common genes explained between 28 and 30 % of the phenotypic variance for WBSF. A reduced number of common SNPs mapping to the 206 common genes were identified, suggesting that different mutations may target the same genes in a breed-specific manner. Therefore, it is likely that, depending on allele frequencies and linkage disequilibrium patterns, a SNP that is identified for one breed may not be informative for another unrelated breed. Well-known candidate genes affecting beef tenderness were identified. In addition, some of the 206 common genes are located within previously reported quantitative trait loci for WBSF in several cattle breeds. Moreover, the multi-breed co-association analysis detected new candidate genes, regulators and metabolic pathways that are likely involved in the determination of meat tenderness and other meat quality traits in beef cattle. Our results suggest that systems biology approaches that explore associations of correlated traits increase statistical power to identify candidate genes beyond the one-dimensional approach. Further studies on the 206 common genes, their pathways, regulators and interactions will expand our knowledge on the molecular basis of meat tenderness and could lead to the discovery of functional mutations useful for genomic selection in a multi-breed beef cattle context.
- 23 April 2016
- Published by Springer Nature in Genetics Selection Evolution
- Vol. 48 (1) , 37
Open AccessMulti-breed and multi-trait co-association analysis of meat tenderness and other meat quality traits in three French beef cattle breeds
Studies to identify markers associated with beef tenderness have focused on Warner–Bratzler shear force (WBSF) but the interplay between the genes associated with WBSF has not been explored. We used the association weight matrix (AWM), a systems biology approach, to identify a set of interacting genes that are co-associated with tenderness and other meat quality traits, and shared across the Charolaise, Limousine and Blonde d’Aquitaine beef cattle breeds. Genome-wide association studies were performed using ~500K single nucleotide polymorphisms (SNPs) and 17 phenotypes measured on more than 1000 animals for each breed. First, this multi-trait approach was applied separately for each breed across 17 phenotypes and second, between- and across-breed comparisons at the AWM and functional levels were performed. Genetic heterogeneity was observed, and most of the variants that were associated with WBSF segregated within rather than across breeds. We identified 206 common candidate genes associated with WBSF across the three breeds. SNPs in these common genes explained between 28 and 30 % of the phenotypic variance for WBSF. A reduced number of common SNPs mapping to the 206 common genes were identified, suggesting that different mutations may target the same genes in a breed-specific manner. Therefore, it is likely that, depending on allele frequencies and linkage disequilibrium patterns, a SNP that is identified for one breed may not be informative for another unrelated breed. Well-known candidate genes affecting beef tenderness were identified. In addition, some of the 206 common genes are located within previously reported quantitative trait loci for WBSF in several cattle breeds. Moreover, the multi-breed co-association analysis detected new candidate genes, regulators and metabolic pathways that are likely involved in the determination of meat tenderness and other meat quality traits in beef cattle. Our results suggest that systems biology approaches that explore associations of correlated traits increase statistical power to identify candidate genes beyond the one-dimensional approach. Further studies on the 206 common genes, their pathways, regulators and interactions will expand our knowledge on the molecular basis of meat tenderness and could lead to the discovery of functional mutations useful for genomic selection in a multi-breed beef cattle context.
- 1 January 2016
- Published by CSIRO Publishing in Animal Production Science
- Vol. 56 (3) , 218-223
Assessing individual differences in enteric methane emission among beef heifers using the GreenFeed Emission Monitoring system: effect of the length of testing period on precision
The GreenFeed Emission Monitoring system was used to measure individual greenhouse gas (GHG) emissions while recording feed intake of beef heifers. That technique provides spot-measures of methane (CH4) and carbon dioxide (CO2) fluxes at each visit to the GreenFeed feeder. A sampling variance is attached at each spot-measure due to circadian variation in GHG emission. Averaging spot-measures is required for reducing that sampling error when evaluating GHG emissions of individual cattle. The objective of the present study was to evaluate the length of test period and number of spot-measures for precisely assessing differences among beef heifers. The within-individual (σ2r) and across-individual (σ2i) variances of GHG-flux measures were estimated for 124 Charolais beef heifers fed a roughage diet during an 8-week test period, following 3–4 weeks of adaptation. High repeatability coefficients (>0.77) were obtained with 4-week test averages and ~100 spot-measures for CH4 and CO2 fluxes. Equivalent repeatability was obtained for dry matter intake (DMI). Lower repeatability (<0.7) was obtained for combined traits, namely, CH4/CO2, CH4/DMI and CO2/DMI. Higher precision would have been obtained if the first 2 weeks were not used but considered as further adaptation. In that case, about 50 spot-measures recorded during a 2-week test would be sufficient for a precise individual measure of CH4 emissions. For genetic evaluation, test duration of 5 weeks may be recommended for the simultaneous recording of CH4 emission and feed intake.
- 1 January 2016
- Published by CSIRO Publishing in Animal Production Science
- Vol. 56 (3) , 218-223
Assessing individual differences in enteric methane emission among beef heifers using the GreenFeed Emission Monitoring system: effect of the length of testing period on precision
The GreenFeed Emission Monitoring system was used to measure individual greenhouse gas (GHG) emissions while recording feed intake of beef heifers. That technique provides spot-measures of methane (CH4) and carbon dioxide (CO2) fluxes at each visit to the GreenFeed feeder. A sampling variance is attached at each spot-measure due to circadian variation in GHG emission. Averaging spot-measures is required for reducing that sampling error when evaluating GHG emissions of individual cattle. The objective of the present study was to evaluate the length of test period and number of spot-measures for precisely assessing differences among beef heifers. The within-individual (σ2r) and across-individual (σ2i) variances of GHG-flux measures were estimated for 124 Charolais beef heifers fed a roughage diet during an 8-week test period, following 3–4 weeks of adaptation. High repeatability coefficients (>0.77) were obtained with 4-week test averages and ~100 spot-measures for CH4 and CO2 fluxes. Equivalent repeatability was obtained for dry matter intake (DMI). Lower repeatability (<0.7) was obtained for combined traits, namely, CH4/CO2, CH4/DMI and CO2/DMI. Higher precision would have been obtained if the first 2 weeks were not used but considered as further adaptation. In that case, about 50 spot-measures recorded during a 2-week test would be sufficient for a precise individual measure of CH4 emissions. For genetic evaluation, test duration of 5 weeks may be recommended for the simultaneous recording of CH4 emission and feed intake.
- 1 October 2014
- Published by Oxford University Press (OUP) in Journal of Animal Science
- Vol. 92 (10) , 4329-4341
Fine mapping of quantitative trait loci underlying sensory meat quality traits in three French beef cattle breeds1
Improving the traits that underlie meat quality is a major challenge in the beef industry. The objective of this paper was to detect QTL linked to sensory meat quality traits in 3 French beef cattle breeds. We genotyped 1,059, 1,219, and 947 young bulls and their sires belonging to the Charolais, Limousin, and Blonde d’Aquitaine breeds, respectively, using the Illumina BovineSNP50 BeadChip (Illumina Inc., San Diego, CA). After estimating relevant genetic parameters using VCE software, we performed a linkage disequilibrium and linkage analysis on 4 meat traits: intramuscular fat content, muscle lightness, shear force, and tenderness score. Heritability coefficients largely ranged between 0.10 and 0.24; however, they reached a maximum of 0.44 and 0.50 for intramuscular fat content and tenderness score, respectively, in the Charolais breed. The 2 meat texture traits, shear force and tenderness score, were strongly genetically correlated (–0.91 in the Charolais and Limousin breed and –0.86 in the Blonde d’Aquitaine breed), indicating that they are 2 different measures of approximately the same trait. The genetic correlation between tenderness and intramuscular fat content differed across breeds. Using a significance threshold of 5 × 10–4 for QTL detection, we found more than 200 significant positions across the 29 autosomal chromosomes for the 4 traits in the Charolais and Blonde d’Aquitaine breeds; in contrast, there were only 78 significant positions in the Limousin breed. Few QTL were common across breeds. We detected QTL for intramuscular fat content located near the myostatin gene in the Charolais and Blonde d’Aquitaine breeds. No mutation in this gene has been reported for the Blonde d’Aquitaine breed; therefore, it suggests that an unknown mutation could be segregating in this breed. We confirmed that, in certain breeds, markers in the calpastatin and calpain 1 gene regions affect tenderness. We also found new QTL as several QTL on chromosome 3 that are significantly associated with meat tenderness in the Blonde d’Aquitaine breed. Overall, these results greatly contribute to the goal of building a panel of markers that can be used to select animals of high meat quality. Copyright © 2014. American Society of Animal Science .
- 1 October 2014
- Published by Oxford University Press (OUP) in Journal of Animal Science
- Vol. 92 (10) , 4329-4341
Fine mapping of quantitative trait loci underlying sensory meat quality traits in three French beef cattle breeds1
Improving the traits that underlie meat quality is a major challenge in the beef industry. The objective of this paper was to detect QTL linked to sensory meat quality traits in 3 French beef cattle breeds. We genotyped 1,059, 1,219, and 947 young bulls and their sires belonging to the Charolais, Limousin, and Blonde d’Aquitaine breeds, respectively, using the Illumina BovineSNP50 BeadChip (Illumina Inc., San Diego, CA). After estimating relevant genetic parameters using VCE software, we performed a linkage disequilibrium and linkage analysis on 4 meat traits: intramuscular fat content, muscle lightness, shear force, and tenderness score. Heritability coefficients largely ranged between 0.10 and 0.24; however, they reached a maximum of 0.44 and 0.50 for intramuscular fat content and tenderness score, respectively, in the Charolais breed. The 2 meat texture traits, shear force and tenderness score, were strongly genetically correlated (–0.91 in the Charolais and Limousin breed and –0.86 in the Blonde d’Aquitaine breed), indicating that they are 2 different measures of approximately the same trait. The genetic correlation between tenderness and intramuscular fat content differed across breeds. Using a significance threshold of 5 × 10–4 for QTL detection, we found more than 200 significant positions across the 29 autosomal chromosomes for the 4 traits in the Charolais and Blonde d’Aquitaine breeds; in contrast, there were only 78 significant positions in the Limousin breed. Few QTL were common across breeds. We detected QTL for intramuscular fat content located near the myostatin gene in the Charolais and Blonde d’Aquitaine breeds. No mutation in this gene has been reported for the Blonde d’Aquitaine breed; therefore, it suggests that an unknown mutation could be segregating in this breed. We confirmed that, in certain breeds, markers in the calpastatin and calpain 1 gene regions affect tenderness. We also found new QTL as several QTL on chromosome 3 that are significantly associated with meat tenderness in the Blonde d’Aquitaine breed. Overall, these results greatly contribute to the goal of building a panel of markers that can be used to select animals of high meat quality. Copyright © 2014. American Society of Animal Science .