S. Raghavan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
S. Raghavan has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Anthonisamy Arockia Bazil Raj
Department of Electronics Engineering, Defence Institute of Advanced Technology (DIAT), Pune, India
2 shared publications - D. Kumar
Periyar Maniammai University
2 shared publications - J. Arputha Vijaya Selvi
Kings College of Engineering
2 shared publications - S. Imaculate Rosaline
Department of Electronics and Communication Engineering National Institute of Technology (NIT) Tiruchirappalli Tamilnadu India
2 shared publications - Divya Chaturvedi
Department of Electronics and Communication Engineering, Indian Institute of Information Technology, Pune, Maharashtra, India
1 shared publication - Harikumar Rajaguru
Department of Electronics and Communicaiton Engineering, Bannari Amman Institute of Technology, Sathyamangalam 638 401, India
1 shared publication
Latest Publications
- 11 April 2018
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 65 (5) , 582-588
A Half-Mode SIW Cavity-Backed Semi-Hexagonal Slot Antenna for WBAN Application
A half-mode substrate integrated waveguide (HMSIW) antenna covering industrial, scientific, and medical radio band at 5.8 GHz is designed, fabricated, and tested. An HMSIW technique is used to reduce the size to almost 50% while maintaining the same performance of the antenna. Afterwards, a semi-hexagonal slot is etched on the patch, which excites and tunes the dominant-mode of the cavity in the band of interest. Inspite of a substantial miniaturization, the proposed antenna provides a gain of 6.1 with front to back ratio of more than 10 dB along with a fair radiation efficiency of 83% in free space. In order to examine the performance of the antenna in the presence of a body, the antenna is tested on pork tissues. The measured on-body peak gain and simulated radiation efficiency are obtained as 5.25 and 69%, respectively. The antenna shows robust performance in the presence of pork tissues and the specific absorption rate value is under the Federal Communications Commission (FCC) guidelines, which makes it a suitable choice for wireless body area network applications.
- 11 April 2018
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 65 (5) , 582-588
A Half-Mode SIW Cavity-Backed Semi-Hexagonal Slot Antenna for WBAN Application
A half-mode substrate integrated waveguide (HMSIW) antenna covering industrial, scientific, and medical radio band at 5.8 GHz is designed, fabricated, and tested. An HMSIW technique is used to reduce the size to almost 50% while maintaining the same performance of the antenna. Afterwards, a semi-hexagonal slot is etched on the patch, which excites and tunes the dominant-mode of the cavity in the band of interest. Inspite of a substantial miniaturization, the proposed antenna provides a gain of 6.1 with front to back ratio of more than 10 dB along with a fair radiation efficiency of 83% in free space. In order to examine the performance of the antenna in the presence of a body, the antenna is tested on pork tissues. The measured on-body peak gain and simulated radiation efficiency are obtained as 5.25 and 69%, respectively. The antenna shows robust performance in the presence of pork tissues and the specific absorption rate value is under the Federal Communications Commission (FCC) guidelines, which makes it a suitable choice for wireless body area network applications.
- 27 June 2016
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 58 (9) , 2117-2122
Design of split ring antennas for WLAN and WiMAX applications
This paper compares the design of two compact monopole antennas based on metamaterial inspired split ring structures. The effect of orientation of split axis to the direction of an incident EM wave is discussed. When the axis of the split is parallel to the direction of EM wave propagation, it results in a narrow band creation and when it is perpendicular, it leads to a notch frequency. Antenna 1 is intended for WLAN (2.4/5.2/5.8 GHz) application whereas antenna 2 operates on both WLAN and WiMAX (3.5 GHz) frequency bands. Both the antennas are printed on a 30 × 30 × 0.8 mm3 FR‐4 substrate with a partial ground plane and is fed by a microstrip line. The structures mainly differ in their split positions. Analysis of the split ring structures is also discussed. Prototype of the proposed structures are fabricated and the measured results comply greatly with the simulated results. The antenna has consistent radiation pattern over all the working region. © 2016 Wiley Periodicals, Inc. Microwave Opt Technol Lett 58:2117–2122, 2016
- 27 June 2016
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 58 (9) , 2117-2122
Design of split ring antennas for WLAN and WiMAX applications
This paper compares the design of two compact monopole antennas based on metamaterial inspired split ring structures. The effect of orientation of split axis to the direction of an incident EM wave is discussed. When the axis of the split is parallel to the direction of EM wave propagation, it results in a narrow band creation and when it is perpendicular, it leads to a notch frequency. Antenna 1 is intended for WLAN (2.4/5.2/5.8 GHz) application whereas antenna 2 operates on both WLAN and WiMAX (3.5 GHz) frequency bands. Both the antennas are printed on a 30 × 30 × 0.8 mm3 FR‐4 substrate with a partial ground plane and is fed by a microstrip line. The structures mainly differ in their split positions. Analysis of the split ring structures is also discussed. Prototype of the proposed structures are fabricated and the measured results comply greatly with the simulated results. The antenna has consistent radiation pattern over all the working region. © 2016 Wiley Periodicals, Inc. Microwave Opt Technol Lett 58:2117–2122, 2016
- 24 February 2016
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 58 (4) , 936-939
Metamaterial inspired monopole antenna for WLAN/WiMAX applications
- 24 February 2016
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 58 (4) , 936-939
Metamaterial inspired monopole antenna for WLAN/WiMAX applications
- 22 September 2015
- Published by ASME International in Journal of Solar Energy Engineering
- Vol. 137 (6) , 061005
Enhancement of Fuzzy Controlled Photovoltaic–Diesel System With Battery Storage Using Interleaved Converter With Hybrid MPPT for Rural Home
Hybrid energy systems normally comprise photovoltaic (PV) modules, diesel generator, a DC–DC converter with maximum power point tracking (MPPT) control, a DC–AC inverter with pulse width modulation (PWM) controller and storage system. In this paper, interleaved converter with an hybrid perturb and observe (P&O) fuzzy MPPT technique was proposed to enhance the effectiveness of the hybrid system. The enactment of unipolar sinusoidal pulse width modulation (SPWM) technique and proportional integral (PI) controller enhances the performance of bidirectional H-bridge inverter by getting rid of lower order harmonics, which leads to least possible switching losses, thus improves the inverter efficiency.
- 22 September 2015
- Published by ASME International in Journal of Solar Energy Engineering
- Vol. 137 (6) , 061005
Enhancement of Fuzzy Controlled Photovoltaic–Diesel System With Battery Storage Using Interleaved Converter With Hybrid MPPT for Rural Home
Hybrid energy systems normally comprise photovoltaic (PV) modules, diesel generator, a DC–DC converter with maximum power point tracking (MPPT) control, a DC–AC inverter with pulse width modulation (PWM) controller and storage system. In this paper, interleaved converter with an hybrid perturb and observe (P&O) fuzzy MPPT technique was proposed to enhance the effectiveness of the hybrid system. The enactment of unipolar sinusoidal pulse width modulation (SPWM) technique and proportional integral (PI) controller enhances the performance of bidirectional H-bridge inverter by getting rid of lower order harmonics, which leads to least possible switching losses, thus improves the inverter efficiency.
- 16 May 2015
- Published by Springer Nature in Wireless Personal Communications
- Vol. 84 (1) , 765-799
Design of Cognitive Decision Making Controller for Autonomous Online Adaptive Beam Steering in Free Space Optical Communication System
- 16 May 2015
- Published by Springer Nature in Wireless Personal Communications
- Vol. 84 (1) , 765-799
Design of Cognitive Decision Making Controller for Autonomous Online Adaptive Beam Steering in Free Space Optical Communication System
- 1 July 2014
- Published by Allerton Press in Optical Memory and Neural Networks
- Vol. 23 (3) , 111-129
A direct and neural controller performance study with beam wandering mitigation control in free space optical link
The beam wander on the detector plane is one of the main causes for major power loss which severely degrades the performance of Free Space Optical (FSO) link. Designing a suitable controller to correct the beam motion at a faster rate to increase the beam stability becomes significant. This paper presents an investigation on the performance of two types of controller designed for aiming a laser beam to be at a particular point under dynamic disturbances. The first design is based on the Taguchi’s method (direct controller) while the second is the Artificial Neural Network (ANN) method (neural-controller). These controllers process the beam location information and generate the necessary outputs to mitigate the beam wandering. The pipelined-parallel architecture for both controllers are developed in a Field Programmable Gate Array (FPGA) and installed at the receiver station. Evidence of the suitability and the effectiveness of the proposed controller in terms of prediction exactness, prediction error, reduction of focal point wander, response to impulse and scintillation are provided through experimental results from the FSO link established for the horizontal range of 0.5 km at an altitude of 15.25 m.
- 1 July 2014
- Published by Allerton Press in Optical Memory and Neural Networks
- Vol. 23 (3) , 111-129
A direct and neural controller performance study with beam wandering mitigation control in free space optical link
The beam wander on the detector plane is one of the main causes for major power loss which severely degrades the performance of Free Space Optical (FSO) link. Designing a suitable controller to correct the beam motion at a faster rate to increase the beam stability becomes significant. This paper presents an investigation on the performance of two types of controller designed for aiming a laser beam to be at a particular point under dynamic disturbances. The first design is based on the Taguchi’s method (direct controller) while the second is the Artificial Neural Network (ANN) method (neural-controller). These controllers process the beam location information and generate the necessary outputs to mitigate the beam wandering. The pipelined-parallel architecture for both controllers are developed in a Field Programmable Gate Array (FPGA) and installed at the receiver station. Evidence of the suitability and the effectiveness of the proposed controller in terms of prediction exactness, prediction error, reduction of focal point wander, response to impulse and scintillation are provided through experimental results from the FSO link established for the horizontal range of 0.5 km at an altitude of 15.25 m.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 389-392
Design of an Optimal G-shaped Monopole Antenna Using Particle Swarm Optimization
A dualband coplanar waveguide (CPW)-fed planar monopole antenna suitable for WLAN application is presented in this paper. The antenna resembling as a "G" shape and optimally designed by using the particle swarm optimization (PSO) algorithm can produce dual resonant modes. Prototypes of the obtained optimized antenna have been constructed and simulated using the Zeland's FIDELITY package. The measured results explore good dualband operation with -10 dB impedance bandwidths of 22.6% and 12.6% at bands of 2.57 and 5.53 GHz, respectively, which cover the 2.4 and 5.8 GHz WLAN operating bands, and show good agreement with the numerical prediction. Also, good antenna performances such as radiation patterns and antenna gains over the operating bands have been observed.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 389-392
Design of an Optimal G-shaped Monopole Antenna Using Particle Swarm Optimization
A dualband coplanar waveguide (CPW)-fed planar monopole antenna suitable for WLAN application is presented in this paper. The antenna resembling as a "G" shape and optimally designed by using the particle swarm optimization (PSO) algorithm can produce dual resonant modes. Prototypes of the obtained optimized antenna have been constructed and simulated using the Zeland's FIDELITY package. The measured results explore good dualband operation with -10 dB impedance bandwidths of 22.6% and 12.6% at bands of 2.57 and 5.53 GHz, respectively, which cover the 2.4 and 5.8 GHz WLAN operating bands, and show good agreement with the numerical prediction. Also, good antenna performances such as radiation patterns and antenna gains over the operating bands have been observed.
- 1 March 2008
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 54 (2) , 121-127
A CAD based Approach on Artificial Neural Networks for Conductor Backed Coplanar Waveguides
In this paper a computer aided design (CAD) approach based on artificial neural networks (ANNs) successfully simulated to determine the characteristics parameters such as effective dielectric constant and characteristic impedances of conductor backed coplanar waveguides (CBCPW). These neural models are trained with Levenberg-Marquardt, Bayesian regularization, gradient descent algorithms. The Levenberg-Marquardt algorithm and Bayesian regularization was found to be the best algorithm among all the three algorithms. As a result, ANN models presented in this work can be used easily, simply and accurately to determine the characteristic parameters of the Conductor Backed Coplanar Waveguides.
- 1 March 2008
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 54 (2) , 121-127
A CAD based Approach on Artificial Neural Networks for Conductor Backed Coplanar Waveguides
In this paper a computer aided design (CAD) approach based on artificial neural networks (ANNs) successfully simulated to determine the characteristics parameters such as effective dielectric constant and characteristic impedances of conductor backed coplanar waveguides (CBCPW). These neural models are trained with Levenberg-Marquardt, Bayesian regularization, gradient descent algorithms. The Levenberg-Marquardt algorithm and Bayesian regularization was found to be the best algorithm among all the three algorithms. As a result, ANN models presented in this work can be used easily, simply and accurately to determine the characteristic parameters of the Conductor Backed Coplanar Waveguides.