Shankar Subramaniyan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Shankar Subramaniyan has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Beatriz Quintal
Institute of Earth Sciences University of Lausanne Lausanne Switzerland
3 shared publications - Erik Hans Saenger
Hochschule Bochum, Bochum, Germany
3 shared publications Claudio Madonna
Department of Earth Sciences ETH Zurich Zurich Switzerland
2 shared publications- Nicola Tisato
Department of Earth and Planetary Sciences Jackson School of Geosciences The University of Texas at Austin Austin TX USA
1 shared publication
Latest Publications
- 10 February 2017
- Published by Springer Nature in Acta Geophysica
- Vol. 65 (1) , 165-172
Forced oscillation measurements of seismic attenuation in fluid saturated sandstone
- 10 February 2017
- Published by Springer Nature in Acta Geophysica
- Vol. 65 (1) , 165-172
Forced oscillation measurements of seismic attenuation in fluid saturated sandstone
- Open Access
- 28 October 2015
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 120 (11) , 7526-7535
Laboratory‐based seismic attenuation in Fontainebleau sandstone: Evidence of squirt flow
At seismic frequencies (1–100 Hz), we studied attenuation in the laboratory using the forced oscillation method. We adopted the longitudinal mode of oscillation, which yields the Young's modulus and the corresponding attenuation, here defined as the inverse quality factor. A Fontainebleau sandstone with a porosity of 8% and a permeability of 12 mD was saturated with different fluids and investigated at the confining pressures of 5, 10, and 15 MPa. At all the measured confining pressures, while attenuation was zero for the dry sample, for partial and full water saturation, it gradually increased from nearly zero to ~0.02 with increasing frequency. The sample was then fully saturated with glycerin‐water mixtures of varying viscosities, up to that of glycerin (8, 92, 485, and 1414 cP). At the confining pressure of 5 MPa, a bell‐shaped attenuation curve peaking at ~6 Hz with a magnitude of ~0.11 was observed when the sample was fully saturated with glycerin (1414 cP). A decrease in viscosity of the saturating fluid shifted the attenuation curve to higher frequencies, and an increase in confining pressure caused a decrease in the overall magnitude of attenuation. The data obtained for glycerin were compared to a simple squirt flow model with sufficient agreement, implying that squirt flow is the dominant mechanism responsible for the observed attenuation.
- 28 October 2015
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 120 (11) , 7526-7535
Open AccessLaboratory‐based seismic attenuation in Fontainebleau sandstone: Evidence of squirt flow
At seismic frequencies (1–100 Hz), we studied attenuation in the laboratory using the forced oscillation method. We adopted the longitudinal mode of oscillation, which yields the Young's modulus and the corresponding attenuation, here defined as the inverse quality factor. A Fontainebleau sandstone with a porosity of 8% and a permeability of 12 mD was saturated with different fluids and investigated at the confining pressures of 5, 10, and 15 MPa. At all the measured confining pressures, while attenuation was zero for the dry sample, for partial and full water saturation, it gradually increased from nearly zero to ~0.02 with increasing frequency. The sample was then fully saturated with glycerin‐water mixtures of varying viscosities, up to that of glycerin (8, 92, 485, and 1414 cP). At the confining pressure of 5 MPa, a bell‐shaped attenuation curve peaking at ~6 Hz with a magnitude of ~0.11 was observed when the sample was fully saturated with glycerin (1414 cP). A decrease in viscosity of the saturating fluid shifted the attenuation curve to higher frequencies, and an increase in confining pressure caused a decrease in the overall magnitude of attenuation. The data obtained for glycerin were compared to a simple squirt flow model with sufficient agreement, implying that squirt flow is the dominant mechanism responsible for the observed attenuation.
- 16 September 2014
- Published by Wiley in Geophysical Prospecting
- Vol. 62 (6) , 1211-1223
An overview of laboratory apparatuses to measure seismic attenuation in reservoir rocks
Intrinsic wave attenuation at seismic frequencies is strongly dependent on rock permeability, fluid properties, and saturation. However, in order to use attenuation as an attribute to extract information on rock/fluid properties from seismic data, experimental studies on attenuation are necessary for a better understanding of physical mechanisms that are dominant at those frequencies. An appropriate laboratory methodology to measure attenuation at seismic frequencies is the forced oscillation method, but technical challenges kept this technique from being widely used. There is a need for the standardization of devices employing this method, and a comparison of existing setups is a step towards it. Here we summarize the apparatuses based on the forced oscillation method that were built in the last 30 years and were used to measure frequency‐dependent attenuation in fluid‐saturated and/or dry reservoir rocks under small strains (10−8–10−5). We list and discuss important technical aspects to be taken into account when working with these devices or in the course of designing a new one. We also present a summary of the attenuation measurements in reservoir rock samples performed with these apparatuses so far.
- 16 September 2014
- Published by Wiley in Geophysical Prospecting
- Vol. 62 (6) , 1211-1223
An overview of laboratory apparatuses to measure seismic attenuation in reservoir rocks
Intrinsic wave attenuation at seismic frequencies is strongly dependent on rock permeability, fluid properties, and saturation. However, in order to use attenuation as an attribute to extract information on rock/fluid properties from seismic data, experimental studies on attenuation are necessary for a better understanding of physical mechanisms that are dominant at those frequencies. An appropriate laboratory methodology to measure attenuation at seismic frequencies is the forced oscillation method, but technical challenges kept this technique from being widely used. There is a need for the standardization of devices employing this method, and a comparison of existing setups is a step towards it. Here we summarize the apparatuses based on the forced oscillation method that were built in the last 30 years and were used to measure frequency‐dependent attenuation in fluid‐saturated and/or dry reservoir rocks under small strains (10−8–10−5). We list and discuss important technical aspects to be taken into account when working with these devices or in the course of designing a new one. We also present a summary of the attenuation measurements in reservoir rock samples performed with these apparatuses so far.