Jürgen Slowack
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jürgen Slowack has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Peter Lambert
IDLab, Ghent University - Imec, Ghent, Belgium
3 shared publications - Jozef Škorupa
Ghent University, Belgium
2 shared publications Rik Van de Walle
Ghent University, Belgium
2 shared publications- Stefaan Mys
Ghent University, Belgium
2 shared publications Christos Grecos
University of the West of Scotland, UK
1 shared publication- Christos Grecos
University of Central Lancashire
1 shared publication
Latest Publications
- 15 May 2022
- Published by Springer Nature
- p. 411-422
Engagement Detection with Multi-Task Training in E-Learning Environments
- 15 May 2022
- Published by Springer Nature
- p. 411-422
Engagement Detection with Multi-Task Training in E-Learning Environments
- 31 July 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Multimedia
- Vol. 19 (10) , 2252-2266
Video Encoder Architecture for Low-Delay Live-Streaming Events
Video-streaming events such as virtual classrooms and video conferences require a low delay between sender and receiver. In order to achieve this requirement, and to make full use of the bandwidth capacity of each receiver, each client can be provided with a personalized bitstream of which the bit rate is continuously adapted to his current network bandwidth capacity. However, such an approach requires an excessive amount of computationally complex video encoders. Therefore, this paper proposes an architecture based on coding information calculation (CIC) modules and residual encoder (RE) modules. The CIC modules calculate coding information for the video at certain bit rates whereas the RE modules use this information to skip all encoding steps of a traditional encoder, except for the encoding of the residual. By reducing the amount of bits used to encode the residual, the RE modules can then provide bitstreams with personalized bit rates for several users at the same time. Each CIC module has approximately the same computational complexity as a traditional encoder, whereas an RE module has the approximate complexity of a decoder. The proposed architecture was evaluated for the high efficiency video coding standard, showing that the system achieves its goal of drastically reducing the computational complexity of low-delay live-streaming with many participants and suggesting that using less than six CIC modules results in the best tradeoff between compression efficiency and computational complexity.
- 31 July 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Multimedia
- Vol. 19 (10) , 2252-2266
Video Encoder Architecture for Low-Delay Live-Streaming Events
Video-streaming events such as virtual classrooms and video conferences require a low delay between sender and receiver. In order to achieve this requirement, and to make full use of the bandwidth capacity of each receiver, each client can be provided with a personalized bitstream of which the bit rate is continuously adapted to his current network bandwidth capacity. However, such an approach requires an excessive amount of computationally complex video encoders. Therefore, this paper proposes an architecture based on coding information calculation (CIC) modules and residual encoder (RE) modules. The CIC modules calculate coding information for the video at certain bit rates whereas the RE modules use this information to skip all encoding steps of a traditional encoder, except for the encoding of the residual. By reducing the amount of bits used to encode the residual, the RE modules can then provide bitstreams with personalized bit rates for several users at the same time. Each CIC module has approximately the same computational complexity as a traditional encoder, whereas an RE module has the approximate complexity of a decoder. The proposed architecture was evaluated for the high efficiency video coding standard, showing that the system achieves its goal of drastically reducing the computational complexity of low-delay live-streaming with many participants and suggesting that using less than six CIC modules results in the best tradeoff between compression efficiency and computational complexity.
- 1 January 2010
- Published by IGI Global Scientific Publishing
- p. 403-424
Fast Mode Decision in H.264/AVC
The latest video coding standard (Wiegand, 2003), H.264/AVC, uses variable block sizes ranging from 16x16 to 4x4 to perform motion estimation in inter-frame coding and a rich set of prediction patterns for intra-frame coding. Then a robust RDO (Rate Distortion Optimization) technique is employed to select the best coding mode and reference frame for each macroblock. As a result, H.264/AVC exhibits high coding efficiency compared to older video coding standards [2, 3] and shows significant future promise in the fields of video broadcasting and communication. However, high coding efficiency also carries high computational complexity. Fast mode decision is one of the key techniques to significantly reducing computational complexity for a similar RD (Rate Distortion) performance. This chapter provides an up-to-date critical survey of fast mode decision techniques for the H.264/AVC standard. The motivation for this chapter is twofold: Firstly to provide an up-to-data review of the existing techniques and secondly to offer some insights into the studies of fast mode decision techniques.
- 1 January 2010
- Published by IGI Global Scientific Publishing
- p. 403-424
Fast Mode Decision in H.264/AVC
The latest video coding standard (Wiegand, 2003), H.264/AVC, uses variable block sizes ranging from 16x16 to 4x4 to perform motion estimation in inter-frame coding and a rich set of prediction patterns for intra-frame coding. Then a robust RDO (Rate Distortion Optimization) technique is employed to select the best coding mode and reference frame for each macroblock. As a result, H.264/AVC exhibits high coding efficiency compared to older video coding standards [2, 3] and shows significant future promise in the fields of video broadcasting and communication. However, high coding efficiency also carries high computational complexity. Fast mode decision is one of the key techniques to significantly reducing computational complexity for a similar RD (Rate Distortion) performance. This chapter provides an up-to-date critical survey of fast mode decision techniques for the H.264/AVC standard. The motivation for this chapter is twofold: Firstly to provide an up-to-data review of the existing techniques and secondly to offer some insights into the studies of fast mode decision techniques.
- 1 January 2010
- Published by IGI Global Scientific Publishing
- p. 375-402
Distributed Video Coding for Video Communication on Mobile Devices and Sensors
In the context of digital video coding, recent insights have led to a new video coding paradigm called Distributed Video Coding, or DVC, characterized by low-complexity encoding and high-complexity decoding, which is in contrast to traditional video coding schemes. This chapter provides a detailed overview of DVC by explaining the underlying principles and results from information theory and introduces a number of application scenarios. It also discusses the most important practical architectures that are currently available. One of these architectures is analyzed step-by-step to provide further details of the functional building blocks, including an analysis of the coding performance compared to traditional coding schemes. Next to this, it is demonstrated that the computational complexity in a video coding scheme can be shifted dynamically from the encoder to the decoder and vice versa by combining conventional and distributed video coding techniques. Lastly, this chapter discusses some currently important research topics of which it is expected that they can further enhance the performance of DVC, i.e., side information generation, virtual channel noise estimation, and new coding modes.
- 1 January 2010
- Published by IGI Global Scientific Publishing
- p. 375-402
Distributed Video Coding for Video Communication on Mobile Devices and Sensors
In the context of digital video coding, recent insights have led to a new video coding paradigm called Distributed Video Coding, or DVC, characterized by low-complexity encoding and high-complexity decoding, which is in contrast to traditional video coding schemes. This chapter provides a detailed overview of DVC by explaining the underlying principles and results from information theory and introduces a number of application scenarios. It also discusses the most important practical architectures that are currently available. One of these architectures is analyzed step-by-step to provide further details of the functional building blocks, including an analysis of the coding performance compared to traditional coding schemes. Next to this, it is demonstrated that the computational complexity in a video coding scheme can be shifted dynamically from the encoder to the decoder and vice versa by combining conventional and distributed video coding techniques. Lastly, this chapter discusses some currently important research topics of which it is expected that they can further enhance the performance of DVC, i.e., side information generation, virtual channel noise estimation, and new coding modes.