Lin He
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lin He has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Fujiang Lin
Institute of MESIC, University of Science and Technology of China, Hefei 230027, China
3 shared publicationsJiaqi Yang
Institute of MESIC, University of Science and Technology of China, Hefei 230027, China
3 shared publicationsMingyuan Yu
Institute of MESIC, University of Science and Technology of China, Hefei 230027, China
2 shared publicationsShuangshuang Zhang
Institute of MESIC, University of Science and Technology of China, Hefei 230027, China
2 shared publicationsTing Li
Science and Technology on Analog Integrated Circuit Laboratory, Chongqing 400060, China
2 shared publicationsDuona Luo
Univ Sci & Technol China, Dept Elect Sci & Technol, Hefei 230027, Peoples R China
1 shared publication
Latest Publications
- 20 February 2019
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 99 (2) , 251-259
A second-order continuous-time delta-sigma modulator with double self noise coupling
- 20 February 2019
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 99 (2) , 251-259
A second-order continuous-time delta-sigma modulator with double self noise coupling
- 1 August 2017
- Published by IOP Publishing in Journal of Semiconductors
- Vol. 38 (8) , 085007
On the design of high-speed energy-efficient successive-approximation logic for asynchronous SAR ADCs
This paper analyzes the power consumption and delay mechanisms of the successive-approximation (SA) logic of a typical asynchronous SAR ADC, and provides strategies to reduce both of them. Following these strategies, a unique direct-pass SA logic is proposed based on a full-swing once-triggered DFF and a self-locking tri-state gate. The unnecessary internal switching power of a typical TSPC DFF, which is commonly used in the SA logic, is avoided. The delay of the ready detector as well as the sequencer is removed from the critical path. A prototype SAR ADC based on the proposed SA logic is fabricated in 130 nm CMOS. It achieves a peak SNDR of 56.3 dB at 1.2 V supply and 65 MS/s sampling rate, and has a total power consumption of 555 μW, while the digital part consumes only 203 μW.
- 1 August 2017
- Published by IOP Publishing in Journal of Semiconductors
- Vol. 38 (8) , 085007
On the design of high-speed energy-efficient successive-approximation logic for asynchronous SAR ADCs
This paper analyzes the power consumption and delay mechanisms of the successive-approximation (SA) logic of a typical asynchronous SAR ADC, and provides strategies to reduce both of them. Following these strategies, a unique direct-pass SA logic is proposed based on a full-swing once-triggered DFF and a self-locking tri-state gate. The unnecessary internal switching power of a typical TSPC DFF, which is commonly used in the SA logic, is avoided. The delay of the ready detector as well as the sequencer is removed from the critical path. A prototype SAR ADC based on the proposed SA logic is fabricated in 130 nm CMOS. It achieves a peak SNDR of 56.3 dB at 1.2 V supply and 65 MS/s sampling rate, and has a total power consumption of 555 μW, while the digital part consumes only 203 μW.
- 1 July 2016
- Published by IOP Publishing in Journal of Semiconductors
- Vol. 37 (7) , 075005
A 1 V 186-μW 50-MS/s 10-bit subrange SAR ADC in 130-nm CMOS process
This paper presents a 10-bit 50-MS/s subrange successive-approximation register (SAR) analog-to-digital converter (ADC) composed of a 4-bit SAR coarse ADC and a 6-bit SAR fine ADC. In the coarse ADC, multi-comparator SAR architecture is used to reduce the digital logic propagation delay, and a traditional asynchronous SAR ADC with monotonic switching method is used as the fine ADC. With that combination, power dissipation also can be much reduced. Meanwhile, a modified SAR control logic is adopted in the fine ADC to speed up the conversion and other techniques, such as splitting capacitors array, are borrowed to reduce the power consumption. Fabricated with 1P8M 130-nm CMOS technology, the proposed SAR ADC achieves 51.6-dB signal to noise and distortion ratio (SNDR) and consumes 186 μW at 50 MS/s with a 1-V supply, resulting in a figure of merit (FOM) of 12 fJ/conversion-step. The core area is only 0.045 mm2.
- 1 July 2016
- Published by IOP Publishing in Journal of Semiconductors
- Vol. 37 (7) , 075005
A 1 V 186-μW 50-MS/s 10-bit subrange SAR ADC in 130-nm CMOS process
This paper presents a 10-bit 50-MS/s subrange successive-approximation register (SAR) analog-to-digital converter (ADC) composed of a 4-bit SAR coarse ADC and a 6-bit SAR fine ADC. In the coarse ADC, multi-comparator SAR architecture is used to reduce the digital logic propagation delay, and a traditional asynchronous SAR ADC with monotonic switching method is used as the fine ADC. With that combination, power dissipation also can be much reduced. Meanwhile, a modified SAR control logic is adopted in the fine ADC to speed up the conversion and other techniques, such as splitting capacitors array, are borrowed to reduce the power consumption. Fabricated with 1P8M 130-nm CMOS technology, the proposed SAR ADC achieves 51.6-dB signal to noise and distortion ratio (SNDR) and consumes 186 μW at 50 MS/s with a 1-V supply, resulting in a figure of merit (FOM) of 12 fJ/conversion-step. The core area is only 0.045 mm2.
- 1 May 2014
- Published by IOP Publishing in Journal of Semiconductors
- Vol. 35 (5)
A 0.6 V 10 bit 1 MS/s monotonic switching SAR ADC with common mode stabilizer in 0.13 μm CMOS
- 1 May 2014
- Published by IOP Publishing in Journal of Semiconductors
- Vol. 35 (5)
A 0.6 V 10 bit 1 MS/s monotonic switching SAR ADC with common mode stabilizer in 0.13 μm CMOS