Tobias Roethlingshoefer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Tobias Roethlingshoefer has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Bernhard Schmauss
Friedrich-Alexander-Universität Erlangen-Nürnberg, Institute of Microwaves and Photonics, Cauerstr. 9, 91058 Erlangen, Germany
4 shared publications Georgy Onishchukov
Max Planck Institute for the Science of Light, Optical Communication, Guenther-Scharowsky-Str. 1 B24, 91058 Erlangen, Germany
4 shared publications- Gerd Leuchs
Friedrich-Alexander-Universität Erlangen-Nürnberg
4 shared publications Colja Schubert
Fraunhofer Institute for Telecommunications, Heinrich Hertz Institute, 10587 Berlin, Germany
1 shared publicationKlaus Sponsel
Max Planck Institute for the Science of Light Optical Communication, Erlangen, Germany
1 shared publicationMartin Hierold
Institute of Microwave Technology, University of Erlangen-Nuremberg, Erlangen, Germany
1 shared publication
Latest Publications
- Open Access
- 15 December 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (26) , 31729-31734
Cascaded phase-preserving multilevel amplitude regeneration.
The performance of cascaded in-line phase-preserving amplitude regeneration using nonlinear amplifying loop mirrors has been studied in numerical simulations. As an example of a spectrally efficient modulation format with two amplitude states and multiple phase states, the regeneration performance of a star-16QAM format, basically an 8PSK format with two amplitude levels, was evaluated. An increased robustness against amplified spontaneous emission and nonlinear phase noise was observed resulting in a significantly increased transmission distance.
- 15 December 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (26) , 31729-31734
Open AccessCascaded phase-preserving multilevel amplitude regeneration.
The performance of cascaded in-line phase-preserving amplitude regeneration using nonlinear amplifying loop mirrors has been studied in numerical simulations. As an example of a spectrally efficient modulation format with two amplitude states and multiple phase states, the regeneration performance of a star-16QAM format, basically an 8PSK format with two amplitude levels, was evaluated. An increased robustness against amplified spontaneous emission and nonlinear phase noise was observed resulting in a significantly increased transmission distance.
- 23 October 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (22) , 27077-27085
All-optical phase-preserving multilevel amplitude regeneration
The possibility of all-optical phase-preserving amplitude regeneration for star-8QAM is demonstrated using a modified nonlinear optical loop mirror. Experiments show a reduction in amplitude noise on both amplitude levels simultaneously, considering two different types of signal distortions: deterministic low-frequency amplitude modulation and broadband amplitude noise. Furthermore, using this amplitude regeneration, the robustness against nonlinear phase noise from fiber nonlinearity in a transmission line is increased. The scheme suppresses the conversion of amplitude noise to nonlinear phase noise. This is shown for simultaneous amplitude regeneration of the two amplitude states as well as for amplitude regeneration of the high-power states only. If the transmission is limited by nonlinear phase noise, single-level operation at the more critical higher-power state will benefit because of the wider plateau region. Numerical simulations confirm the experimental results.
- 23 October 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (22) , 27077-27085
All-optical phase-preserving multilevel amplitude regeneration
The possibility of all-optical phase-preserving amplitude regeneration for star-8QAM is demonstrated using a modified nonlinear optical loop mirror. Experiments show a reduction in amplitude noise on both amplitude levels simultaneously, considering two different types of signal distortions: deterministic low-frequency amplitude modulation and broadband amplitude noise. Furthermore, using this amplitude regeneration, the robustness against nonlinear phase noise from fiber nonlinearity in a transmission line is increased. The scheme suppresses the conversion of amplitude noise to nonlinear phase noise. This is shown for simultaneous amplitude regeneration of the two amplitude states as well as for amplitude regeneration of the high-power states only. If the transmission is limited by nonlinear phase noise, single-level operation at the more critical higher-power state will benefit because of the wider plateau region. Numerical simulations confirm the experimental results.
- 9 January 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 26 (6) , 556-559
All-Optical Simultaneous Multilevel Amplitude and Phase Regeneration
Simultaneous amplitude and phase noise reduction of multiple signal states using a nonlinear amplifying loop mirror with integrated directional phase-sensitive amplifier are presented for the star-eight quadrature amplitude modulation transmission format as an example. The performance of this combined regenerator scheme is compared with that of a cascade of separate phase and amplitude regenerators. It could be shown that an improvement in the error vector magnitude of 4 dB for the high-power states with simultaneous improvement of 5 dB for the low-power states is possible in both cases. Transmission improvement by regeneration is considered for two noise types: 1) amplified spontaneous emission and 2) nonlinear phase noise. Both schemes can either improve the bit error rate by an order of magnitude or enable an increase of the fiber launch power by 3 dB.
- 9 January 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 26 (6) , 556-559
All-Optical Simultaneous Multilevel Amplitude and Phase Regeneration
Simultaneous amplitude and phase noise reduction of multiple signal states using a nonlinear amplifying loop mirror with integrated directional phase-sensitive amplifier are presented for the star-eight quadrature amplitude modulation transmission format as an example. The performance of this combined regenerator scheme is compared with that of a cascade of separate phase and amplitude regenerators. It could be shown that an improvement in the error vector magnitude of 4 dB for the high-power states with simultaneous improvement of 5 dB for the low-power states is possible in both cases. Transmission improvement by regeneration is considered for two noise types: 1) amplified spontaneous emission and 2) nonlinear phase noise. Both schemes can either improve the bit error rate by an order of magnitude or enable an increase of the fiber launch power by 3 dB.
- 2 May 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 23 (14) , 1007-1009
Multilevel Phase-Preserving Amplitude Regeneration Using a Single Nonlinear Amplifying Loop Mirror
A possibility of multilevel phase-preserving amplitude regeneration using a nonlinear amplifying loop mirror (NALM) is presented for the optical star-8 quadrature amplitude modulation (QAM) transmission format as an example. Two significantly different state power ratios for the QAM signal, 1:3 and 1:7, were investigated. After the optimization of the coupler splitting ratio and the directional phase bias in the NALM, amplitude noise can be efficiently suppressed at both signal power levels simultaneously. Bit-error-ratio (BER) simulations have shown that in a system limited by nonlinear phase noise, the deployment of the NALM allows an increase of the fiber launch power by 1.9 and 2.2 dB at a BER of 10-3 for a state power ratio of 1:3 and 1:7, respectively. The regeneration limits due to imperfections of the power transfer characteristic are also discussed.
- 2 May 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 23 (14) , 1007-1009
Multilevel Phase-Preserving Amplitude Regeneration Using a Single Nonlinear Amplifying Loop Mirror
A possibility of multilevel phase-preserving amplitude regeneration using a nonlinear amplifying loop mirror (NALM) is presented for the optical star-8 quadrature amplitude modulation (QAM) transmission format as an example. Two significantly different state power ratios for the QAM signal, 1:3 and 1:7, were investigated. After the optimization of the coupler splitting ratio and the directional phase bias in the NALM, amplitude noise can be efficiently suppressed at both signal power levels simultaneously. Bit-error-ratio (BER) simulations have shown that in a system limited by nonlinear phase noise, the deployment of the NALM allows an increase of the fiber launch power by 1.9 and 2.2 dB at a BER of 10-3 for a state power ratio of 1:3 and 1:7, respectively. The regeneration limits due to imperfections of the power transfer characteristic are also discussed.