Marco Breda
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Marco Breda has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Irene Calliari
Department of Industrial Engineering, University of Padova, Padua, Italy
2 shared publications - Andrea Ghiotti
University of Padua
1 shared publication Antonella Scherillo
ISIS Neutron Source
1 shared publication- Claudio Gennari
Department of Industrial Engineering, University of Padova, Padua, Italy
1 shared publication F. Michieletto
Industrial Engineering Department (DII), University of Padova, Via Gradenigo 6/A, Padova 35131, Italy
1 shared publicationFrancesco Grazzi
Istituto dei Sistemi Complessi
1 shared publication
Latest Publications
- 5 May 2016
- Published by SAGE Publications in Materials Science and Technology
- Vol. 33 (3) , 317-325
Influence of stacking fault energy in electrically assisted uniaxial tension of FCC metals
Electrically assisted manufacturing is based on the electro-plastic effect induced by electricity on the material flow during deformation and represents an alternative method for forming materials. Several studies have pointed out the real effectiveness of this technique, but no relations among microstructure, electrical resistivity, crystal structure and deformation-mode have been revealed. In the present work, the stacking fault energy (SFE) was taken into account and three FCC materials possessing different SFEs were strained in electrically assisted uniaxial tension under continuous current application. The results showed an advantageous electric contribution only in the highest SFE material, whereas no enhancements in formability were revealed in the investigated low- and intermediate-SFE metals.
- 5 May 2016
- Published by SAGE Publications in Materials Science and Technology
- Vol. 33 (3) , 317-325
Influence of stacking fault energy in electrically assisted uniaxial tension of FCC metals
Electrically assisted manufacturing is based on the electro-plastic effect induced by electricity on the material flow during deformation and represents an alternative method for forming materials. Several studies have pointed out the real effectiveness of this technique, but no relations among microstructure, electrical resistivity, crystal structure and deformation-mode have been revealed. In the present work, the stacking fault energy (SFE) was taken into account and three FCC materials possessing different SFEs were strained in electrically assisted uniaxial tension under continuous current application. The results showed an advantageous electric contribution only in the highest SFE material, whereas no enhancements in formability were revealed in the investigated low- and intermediate-SFE metals.
- 7 January 2015
- Published by Elsevier in Acta Metallurgica Sinica (English Letters)
- Vol. 28 (3) , 331-337
σ-Phase in Lean Duplex Stainless Steel Sheets
- 7 January 2015
- Published by Elsevier in Acta Metallurgica Sinica (English Letters)
- Vol. 28 (3) , 331-337
σ-Phase in Lean Duplex Stainless Steel Sheets
- 19 November 2014
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 46 (2) , 577-586
Effects of Cold Rolling and Strain-Induced Martensite Formation in a SAF 2205 Duplex Stainless Steel
- 19 November 2014
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 46 (2) , 577-586
Effects of Cold Rolling and Strain-Induced Martensite Formation in a SAF 2205 Duplex Stainless Steel