Byung-Hoon Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Byung-Hoon Kim has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Chung-Yun Kang
Industrial Liaison Innovation Center, Pusan National University, Busan 46241, Korea
1 shared publication Ha-Young Yu
1 shared publication- Hye-Sung Na
Department of Materials Science and Engineering, Pusan National University, San 30 Jangjeon-dong, Geumjeong-gu, Busan 609-735, Korea
1 shared publication Jae Suk Jeong
1 shared publicationMinwoo Kang
1 shared publication- Sang-Hoon Lee
Industrial Technology Support Division, Korea Institute of Materials Science, 797 Changwondaero, Changwon 641-831, Korea
1 shared publication
Latest Publications
- Open Access
Thermodynamic Alloy Design of High Strength and Toughness in 300 mm Thick Pressure Vessel Wall of 1.25Cr-0.5Mo Steel
In the 21st century, there is an increasing need for high-capacity, high-efficiency, and environmentally friendly power generation systems. The environmentally friendly integrated gasification combined-cycle (IGCC) technology has received particular attention. IGCC pressure vessels require a high-temperature strength and creep strength exceeding those of existing pressure vessels because the operating temperature of the reactor is increased for improved capacity and efficiency. Therefore, high-pressure vessels with thicker walls than those in existing pressure vessels (≤200 mm) must be designed. The primary focus of this research is the development of an IGCC pressure vessel with a fully bainitic structure in the middle portion of the 300 mm thick Cr-Mo steel walls. For this purpose, the effects of the alloy content and cooling rates on the ferrite precipitation and phase transformation behaviors were investigated using JMatPro modeling and thermodynamic calculation; the results were then optimized. Candidate alloys from the simulated results were tested experimentally.
Open AccessThermodynamic Alloy Design of High Strength and Toughness in 300 mm Thick Pressure Vessel Wall of 1.25Cr-0.5Mo Steel
In the 21st century, there is an increasing need for high-capacity, high-efficiency, and environmentally friendly power generation systems. The environmentally friendly integrated gasification combined-cycle (IGCC) technology has received particular attention. IGCC pressure vessels require a high-temperature strength and creep strength exceeding those of existing pressure vessels because the operating temperature of the reactor is increased for improved capacity and efficiency. Therefore, high-pressure vessels with thicker walls than those in existing pressure vessels (≤200 mm) must be designed. The primary focus of this research is the development of an IGCC pressure vessel with a fully bainitic structure in the middle portion of the 300 mm thick Cr-Mo steel walls. For this purpose, the effects of the alloy content and cooling rates on the ferrite precipitation and phase transformation behaviors were investigated using JMatPro modeling and thermodynamic calculation; the results were then optimized. Candidate alloys from the simulated results were tested experimentally.
- 5 September 2016
- Published by The Korean Institute of Metals and Materials in Korean Journal of Metals and Materials
- Vol. 54 (9) , 672-680
Study on the Surface Microstructure of a Modified STD61 Steel Mold Used for the Die Casting Process
- 5 September 2016
- Published by The Korean Institute of Metals and Materials in Korean Journal of Metals and Materials
- Vol. 54 (9) , 672-680
Study on the Surface Microstructure of a Modified STD61 Steel Mold Used for the Die Casting Process