Sivasambu Mahesh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Sivasambu Mahesh has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- Indradev Samajdar
IIT Bombay
5 shared publications Ankit Gupta
Indian Institute of Technology Madras
4 shared publications- Gulshan Kumar
Department of Mechanical Engineering, Birla Institute of Technology and Science, Pilani, Dubai Campus, Dubai International Academic City, Dubai P.O. Box 345055, United Arab Emirates
4 shared publications - Jaiveer Singh
Department of Materials Engineering, Indian Institute of Technology Jodhpur, Karwar, Jodhpur, India
4 shared publications M. Arul Kumar
4 shared publications- Ashish Mishra
University of Petroleum and Energy Studies
3 shared publications
Latest Publications
- 3 September 2026
- Published by Springer Nature in Archive of Applied Mechanics
- Vol. 96 (9) , 188
An integration scheme for elastoplastic rate-independent single crystals based on Maier’s minimum principle
- 3 September 2026
- Published by Springer Nature in Archive of Applied Mechanics
- Vol. 96 (9) , 188
An integration scheme for elastoplastic rate-independent single crystals based on Maier’s minimum principle
- 28 May 2025
- Published by Springer Nature in Acta Mechanica
- Vol. 236 (7) , 3911-3939
Predicting small-offset yield surfaces with polycrystal plasticity
- 28 May 2025
- Published by Springer Nature in Acta Mechanica
- Vol. 236 (7) , 3911-3939
Predicting small-offset yield surfaces with polycrystal plasticity
- 23 August 2024
- Published by Springer Nature
- p. 445-453
Correspondence Between Energy Release Rates and Critical Shear Stresses Due to Interfacial Debonding in a Hybrid Composite
- 23 August 2024
- Published by Springer Nature
- p. 445-453
Correspondence Between Energy Release Rates and Critical Shear Stresses Due to Interfacial Debonding in a Hybrid Composite
- 12 January 2022
- Published by Springer Nature in International Journal of Fracture
- Vol. 233 (1) , 39-70
Tough–brittle transition in unidirectional composites with fibre breakage and fibre–matrix interfacial failure
- 12 January 2022
- Published by Springer Nature in International Journal of Fracture
- Vol. 233 (1) , 39-70
Tough–brittle transition in unidirectional composites with fibre breakage and fibre–matrix interfacial failure
- 16 March 2021
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 101 (5) , 192-202
The stress field of an infinite set of discrete dislocations
The two-dimensional stress fields induced by a set of infinitely many parallel edge dislocations are difficult to estimate as those of individual dislocations decay slowly. A simple numerical method to compute them is proposed. The method is based on series summation using a convergence factor, that decays rapidly with radial distance r from the field point, and letting the positive parameter numerically through Richardson extrapolation. The present method is more general than a lattice summation method with explicit spurious stress cancellation that is widely used in the literature. Furthermore, the spurious long-range stresses are cancelled in the present method without explicit evaluation.- 16 March 2021
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 101 (5) , 192-202
The stress field of an infinite set of discrete dislocations
The two-dimensional stress fields induced by a set of infinitely many parallel edge dislocations are difficult to estimate as those of individual dislocations decay slowly. A simple numerical method to compute them is proposed. The method is based on series summation using a convergence factor, that decays rapidly with radial distance r from the field point, and letting the positive parameter numerically through Richardson extrapolation. The present method is more general than a lattice summation method with explicit spurious stress cancellation that is widely used in the literature. Furthermore, the spurious long-range stresses are cancelled in the present method without explicit evaluation.- 1 December 2020
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 100 (23) , 2913-2937
Temperature-dependence of plasticity and fracture in an Al-Cu-Li alloy
The microstructure of an Al-Cu-Li alloy sheet is characterised in the solution treated, underaged, and peak aged tempers. Its mechanical response under uniaxial tension is measured at 90 K, 173 K, and along 0 degrees, 45 degrees, and 90 degrees to the rolling direction. The anisotropic stress-strain curves are interpreted using a polycrystal plasticity model, which implements three hardening modes suggested by the microstructure, viz., matrix hardening, hardening due to isotropic precipitates, and hardening due to anisotropic precipitates. Phenomenological activation theory based analysis of the work hardening suggests that the physical mechanism underlying work hardening due to anisotropic precipitates remains constant over the temperature range studied, while the mechanism underlying matrix hardening varies strongly with temperature.
- 1 December 2020
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 100 (23) , 2913-2937
Temperature-dependence of plasticity and fracture in an Al-Cu-Li alloy
The microstructure of an Al-Cu-Li alloy sheet is characterised in the solution treated, underaged, and peak aged tempers. Its mechanical response under uniaxial tension is measured at 90 K, 173 K, and along 0 degrees, 45 degrees, and 90 degrees to the rolling direction. The anisotropic stress-strain curves are interpreted using a polycrystal plasticity model, which implements three hardening modes suggested by the microstructure, viz., matrix hardening, hardening due to isotropic precipitates, and hardening due to anisotropic precipitates. Phenomenological activation theory based analysis of the work hardening suggests that the physical mechanism underlying work hardening due to anisotropic precipitates remains constant over the temperature range studied, while the mechanism underlying matrix hardening varies strongly with temperature.
- 1 June 2020
- Published by American Physical Society (APS) in Physical Review E
- Vol. 101 (6) , 063002
Tough-brittle transition in the planar fracture of unidirectional fiber composites
The transverse fracture of model unidirectional composite specimen, comprising up to fibers with random strengths, is studied using Monte Carlo simulations. The load sharing from broken to intact fibers is assumed to obey power-law scaling with distance from the fiber break. Fiber breaks are assumed to interact in order to remain traction free. The pattern of fiber breaks that propagate catastrophically is interpreted through cluster analysis. The empirical strength distributions obtained from the simulations are interpreted using two probabilistic models of brittle fracture available in the literature. These point to a transition from the brittle to the tough fracture mode as . The transitional is approximately equal to that reported in the literature for noninteracting fiber breaks.- 1 June 2020
- Published by American Physical Society (APS) in Physical Review E
- Vol. 101 (6) , 063002
Tough-brittle transition in the planar fracture of unidirectional fiber composites
The transverse fracture of model unidirectional composite specimen, comprising up to fibers with random strengths, is studied using Monte Carlo simulations. The load sharing from broken to intact fibers is assumed to obey power-law scaling with distance from the fiber break. Fiber breaks are assumed to interact in order to remain traction free. The pattern of fiber breaks that propagate catastrophically is interpreted through cluster analysis. The empirical strength distributions obtained from the simulations are interpreted using two probabilistic models of brittle fracture available in the literature. These point to a transition from the brittle to the tough fracture mode as . The transitional is approximately equal to that reported in the literature for noninteracting fiber breaks.- 20 February 2020
- Published by Springer Nature in International Journal of Fracture
- Vol. 222 (1-2) , 75-109
A fast algorithm for fracture simulations representing fibre breakage and matrix failure in three-dimensional fibre composites
- 20 February 2020
- Published by Springer Nature in International Journal of Fracture
- Vol. 222 (1-2) , 75-109
A fast algorithm for fracture simulations representing fibre breakage and matrix failure in three-dimensional fibre composites
- 1 July 2019
- Published by Elsevier in International Journal of Plasticity
- Vol. 118, 215-232
A phenomenological hardening model for an aluminium-lithium alloy
- 1 July 2019
- Published by Elsevier in International Journal of Plasticity
- Vol. 118, 215-232
A phenomenological hardening model for an aluminium-lithium alloy
- 30 May 2019
- Published by Springer Nature in International Journal of Fracture
- Vol. 217 (1-2) , 127-135
A fast algorithm to simulate the failure of a periodic elastic fibre composite
- 30 May 2019
- Published by Springer Nature in International Journal of Fracture
- Vol. 217 (1-2) , 127-135
A fast algorithm to simulate the failure of a periodic elastic fibre composite