NAN. K. Algebraistova

N. K. Algebraistova

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


N. K. Algebraistova has a total of 95 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Material composition and technological evaluation of lead–zinc ore

    by N. K. Algebraistova, I. V. Prokopiev, P. N. Samorodskiy, D. A. Golsman

    The relevance of this study is driven by the worsening challenges of the mineral resource base at mines. Reserves of ores containing 6% lead and 3% zinc, processible by a direct selective scheme, are being depleted. Under these conditions, active efforts are underway to involve technologically refractory ores, characterized by complex mineral dissemination patterns and an unfavorable ratio of valuable component contents, in processing. A comprehensive study of the material composition and technological properties of lead–zinc ore from the upper horizon of the Main Ore Body at the Gorevskoe deposit was conducted. It was found that metamorphism and accompanying metasomatism led to the remobilization of ore minerals, fine sulfide dissemination, and to the complex intergrowths sulfides with nonmetallic minerals. The main technological challenges for beneficiation were identified: uneven distribution of galena, close association of sulfides with each other and with quartz, and the presence of oxidized mineral forms. It is demonstrated that the low efficiency of the current selective flotation scheme for the studied ore is a direct consequence of its material composition and microstructural features, resulting in a zinc recovery of 49.75%. A bulk flotation scheme with two-stage grinding was developed and optimized, based on the existing circuit of equipment and list of reagents. Testing the scheme in a closed cycle showed its high efficiency: recovery into bulk concentrate reached 85.52% Pb and 86.79% Zn. It is determined that the main metal losses (~68% Pb and ~53% Zn of total losses) are concentrated in -0.040 mm size fraction, which defines the direction for the further optimization of flotation technology for fine sludge.

  • Preparation of collective lead-zinc concentrates for selection cycle

    by N. K. Algebraistova, E. S. Komarova, I. V. Prokopiev

    The object of the study is a collective concentrate, which was obtained by flotation of sulfide lead-zinc ore from an East Siberian deposit using a combination of diesel fuel and butyl xanthate. In the collective concentrate the main ore minerals are galena and sphalerite. Non-metallic minerals are quartz, dolomite, calcite and chlorite. In the work were studied various methods of preparing a collective concentrate for a flotation selective cycle: without pulp preparation, washing with sodium sulfide, temperature, ultrasound, and bacterial treatment of a collective concentrate. The results of studies of the flotation selective cycle showed that it is impossible without preparation. Satisfactory technological indicators were not obtained when applying twice washing with sodium sulfide and using ultrasound. Introduction to the flow sheet of the operation of steaming in a medium of sodium sulfide and dosing of activated carbon into the process made it possible to obtain a foam product (lead concentrate) with a lead content of 45%, but the recovery was ~ 43%. In addition, the process is environmentally unfavorable, characterized by high material and energy costs. The prospects of using the bacterial method for preparing collective concentrates using diesel fuel for the flotation selective cycle are shown. The bacterial method consists in treating the collective concentrate with the bacteria Ochrobactrum anthropi and Pseudomonas aeruginosa JCM 5962.


  • Technological evaluation of the stale tailings of the processing of gold-containing low-sulfide ore

    by N. K. Algebraistova, D. A. Golsman, D. M. Kolotushkin, I. V. Prokopev

    The stale tailings of the gold recovery factory operating on a gravity-flotation scheme have been investigated. The main minerals of the initial sample and the products of enrichment are quartz, muscovite, chlorite (clinochlor), plagioclase (albite), carbonates (calcite and dolomite). The native gold during the investigations was observed in the form of particles of lumpy shape with crested short spurs sized around 0.15 mm, and also in the form of goldstone aggregate of various sizes, sprouting grains of pyrite; the maximum observable size of the section of gold was about 0.06 mm. Gold has a relatively low fineness/purity due to significant content mercury which exists as an impurity element. The average gold content in the particles investigated in this study was measured using the micro-X-ray spectral analysis and made up about 67.86 wt. %. Using gravitational and flotation methods, the possibility of the enrichment of the experimental object with the initial size was studied. As the main gravitational equipment, the centrifugal separators, such as Falcon, Itomak and Kelsey, were investigated, and in finalizing stage, the concentration tables, such as SKO-0.5 and Gemeni, were characterized. The results obtained from the flotation and gravity experiments on the material of the initial size indicate the necessity for its preliminary shredding. The influence of the fineness of grinding and dosing of combinations of reagentcollectors on the efficiency of the enrichment process was investigated. The best results were obtained with 80% of the grinding tonnage –0.074 mm. It is determined that the use of combinations of reagents provides higher values of the Hancock-Lücken criterion and a general gold recovery in comparison to flotation with a single butyl xanthate. A combined gravity-flotation scheme of enrichment was developed, which allows obtaining gravitational and flotation concentrates with a content of ~60 g/t gold in them with a total metal recovery of ~63.6%. As the main gravitational equipment, the centrifugal separator Falcon and the concentration table Gemeni are proposed.


  • Effect of Pulse-Discharge Treatment on Structural and Chemical Properties and Floatability of Sulfide Minerals

    by N. K. Algebraistova, E. A. Burdakova, A. S. Romanchenko, A. S. Markova, D. M. Kolotushkin, A. V. Antonov

    In terms of sulfide copper–molybdenum ore of Sorsk stockwork deposit (Republic of Khakasia), the authors discuss the option of selective dissociation of minerals. The scope of the discussion embraces the effect of pulsed-discharge treatment on particle-size indexes, structural and chemical properties and floatability of objects of the study. It is shown that the pulse-discharge treatment in a greater degree influences copper sulfides and levels their floatability while surface of molybdenite undergoes minor alteration. The pulse-discharge treatment allows enhancing flotation selectivity in separation of copper sulfides and molybdenite, and promotes removal of hydrophobic molybdenite film from quartz surface, which results in production of high-quality molybdenite concentrates.


  • Technology of gold recovery from gold-bearing technogenic raw materials

    by N. K. Algebraistova, P. N. Samorodskiy, D. M. Kolotushkin, I. V. Prokopyev

    The increasing tendency to larger volumes of man-caused mineral resources to be processed with a view to recover gold at low operating costs demands innovations development. Gravity concentration methods, permitting to reduce metal and power consumption, as well as adverse environmental impact, and also providing for a high degree of concentration, comply with the necessary requirements. The subject of research was aged dump tailings of the gold recovery plant with a gravity-flotation processing flow sheet. As a result of the research, aged dump tailings material composition was studied and a gravity gold recovery flow sheet was proposed. Different analytical methods and apparatuses were used in the material composition studies: mineralography and electron-microscopic analysis (Axioscope 40 A pol, ZEISS, Germany), scanning electron microscope Hitachi TM 3000 (Japan); X-ray fluorescence analysis (x-ray wavelength-fluorescence spectrometer Shimadzu XRF–1800); atomic emission spectral analysis (atomic emission spectrometer «Stream»); fire assay test and fire assay atomic-and-absorption analysis (HCAM 497-XC methodology). Gold occurrence forms and its character of associations with ore components, base metals’ grades, gold distribution in size fractions, fineness of gold, ore and gangue minerals were determined. In-process testings were performed on centrifugal separators Falcon, Itomak, Kelsey, SKO and Gemeni concentrating tables. It is shown, that the environmentally friendly processing flow sheet permits to recover more than 31 % of metal into concentrate with gold grade of ~30.5 g/t.


  • Material constitution and recovery of impact diamonds

    by Siberian Federal University, N.K. Algebraistova, O.Yu. Perfilova, D.M. Kolotushkin, E.S. Komarova

    ???????????? ?????? ? ?????????? ?????????? ????????? ???????


  • Open Access

    Erratum to: Publisher’s Erratum

    by V. V. Adushkin, S. B. Kishkina, V. I. Kulikov, D. N. Pavlov, V. N. Anisimov, N. V. Saltykov, S. V. Sergeev, V. G. Spungin, V. N. Oparin, T. A. Kiryaeva, et al.

    Due to a technical error volume 53, issue 4, 2017 has been published online with an incorrect cover data. The issue has erroneously been distributed with the cover date July 2018. The correct caver...


  • Ore dressing of precious metal bearing rocks in centrifugal machines

    by N. K. Algebraistova, E. A. Burdakova, A. S. Markova, A. V. Makshanin, Krasnoyarsk Llc “Sibkrasproekt”


  • Open Access

    Flow sheet and reactant treatment for lead-zinc ore bulk flotation

    by N. K. Algebraistova, I. V. Prokopiev, A. S. Markova, D. M. Kolotushkin

    The study subject is lead–zinc sulphide ore with the predominant content of lead. The authors illustrate the effi ciency of separating lead “head” under nonchemical treatment. Without collecting agents, during the first 6 mines of flotation, owing to the natural hydrophobic behavior of galena, it is possible to extract more than 40% of the metal into a product with the lead content of 34.5%. Middlings contain almost 93% of zinc in this case. The lead and zinc ratio in the product is 1 to 1, which is favorable for bulk–selective flotation. The authors investigate Cytec Industries reagents: Aero 400; Aero 5745 and Aero 8045 as well as an apolar reagent as an additive. It has been found that the combination of Aero 5745 and butyl xanthate at a ratio of 1:1 provides the noticeable improvement of beneficiation data. It is found that addition of engine oil in flotation enables reduction in metal loss in the tailings by 1.5–2%. The flowsheet and the reagent regime are proposed for the bulk flotation cycle. The flowsheet ensures favorable conditions for the further selective extraction of a bulk concentrate and for the low loss of lead and zinc in the bulk flotation cycle tailings (6.25 and 9.12%, respectively).


  • Effect of Pseudomonas Japonica bacteria on selection of sulfides

    by N. K. Algebraistova, A. V. Razvyaznaya, M. I. Teremova, E. V. Mazurova